Sharif Digital Repository

An iterative reconstruction-based method for suppression of clipping distortion in OFDM systems is proposed. Analysing the performance of the proposed method in Rician fading channels shows that it outperforms similar techniques, i.e. DFT-based reconstruction and iterative cancellation methods, on both BER performance and computational complexity. © IEE, 2005  

Considerable interest in the indoor applications of wireless local-area networks (WLANs) demands some powerful simulation methods of these systems. Proper modeling of the physical propagation channel is crucial in this context. A novel simulation method for indoor wideband multi-input multi-output (MIMO) channel at the operating frequency band of IEEE 802.11a, HIPERLAN/2, and the emerging IEEE 802.11n standards is presented in this paper which is suitable for performance analysis of MIMO techniques in these systems. The presented model is developed on the basis of a previously proposed channel representation at the same frequency band. Simulation results for MIMO channel capacity are... 

In this paper, an iterative method is proposed to jointly cancel multi-user interference and clipping noise in uplink Multi-Carrier Code Division Multiple Access (MC-CDMA) systems. Clipping is the simplest method to overcome high peak-to-average power ratio of multi-carrier signals but it makes the signals distorted. Reconstruction methods use non-distorted samples to reconstruct distorted samples in the receiver but multi-user interference causes the methods do not work properly because all the received samples are distorted due to clipping and interference and so there is no undistorted samples to be used in recovering clipped samples. On the other hand, multi-user interference... 

The performance of OFDM-based Wireless Local Area Networks (WLANs) is investigated by employing different smart antenna techniques at the receiver. The use of multiple antennas at the Access Point (AP) receiver in IEEE802.11a standard-compliant Single Input Multiple Output (SIMO) configuration, improves the physical layer performance in different channel scenarios and interference that may arise from other stations sharing the same frequency band. For this purpose, a comparative study of smart antenna architectures for IEEE802.11a WLAN system using pre-FFT and post-FFT array processing techniques is presented. Simulations are performed on a new model for IEEE802.11a system using a... 

combination of smart antenna techniques and OFDM could be considered as a promising solution for improving the performance and enhancing the data rates of next generation wireless communication systems operating in frequency selective fading environments. There are different design parameters which could affect the application of adaptive arrays in OFDM-based systems. Various beam-forming methods in frequency or time domain, different array architectures and various number of array elements are important factors which are able to change the performance and complexity of the system. These parameters may show different effects in different channel conditions. In this paper we implemented a new... 

The smart antenna technique as a method of improving the physical layer performance of OFDM WLANs is studied. For this purpose, a comparison of the smart antenna architectures for IEEE802.11a WLAN system using pre-FFT and post-FFT array processing with different parameters is represented. Simulations are performed on a new Simulink model for IEEE802.11a system using a spatio-temporal channel modeling which is based on the measured wideband channels in the 5GHz band. Raw bit-error-rate performance for QPSK/16QAM modulations at LOS and NLOS channel scenarios are evaluated and compared. © 2005 IEEE  

Modeling and analysis of information system vulnerabilities helps us to predict possible attacks to networks using the network configuration and vulnerabilities information. As a fact, exploiting most of vulnerabilities result in access rights alteration. In this paper, we propose a new vulnerability analysis method based on the Take-Grant protection model. We extend the initial Take-Grant model to address the notion of vulnerabilities and introduce the vulnerabilities rewriting rules to specify how the protection state of the system can be changed by exploiting vulnerabilities. Our analysis is based on a bounded polynomial algorithm, which generates the closure of the Take-Grant graph... 

We study the translocation of stiff polymers through a nanopore, driven by the chemical-potential gradient exerted by binding proteins (chaperones) on the trans side of the pore. Bound chaperones prevent backsliding through the pore and, therefore, partially rectify the polymer passage. We show that the sequence of chain monomers with different binding affinity for the chaperones significantly affects the translocation dynamics. In particular, we investigate the effect of the nearest-neighbor adjacency probability of the two monomer types. Depending on the magnitude of the involved binding energies, the translocation speed may either increase or decrease with the adjacency probability. We... 

Combining the advection-diffusion equation approach with Monte Carlo simulations we study chaperone driven polymer translocation of a stiff polymer through a nanopore. We demonstrate that the probability density function of first passage times across the pore depends solely on the Péclet number, a dimensionless parameter comparing drift strength and diffusivity. Moreover it is shown that the characteristic exponent in the power-law dependence of the translocation time on the chain length, a function of the chaperone-polymer binding energy, the chaperone concentration, and the chain length, is also effectively determined by the Péclet number. We investigate the effect of the chaperone size on... 

The amount of rippling in graphene sheets is related to the interactions with the substrate or with the suspending structure. Here, we report on an irreversibility in the response to forces that act on suspended graphene sheets. This may explain why one always observes a ripple structure on suspended graphene. We show that a compression-relaxation mechanism produces static ripples on graphene sheets and determine a peculiar temperature Tc, such that for T