Sharif Digital Repository

Geotechnical design codes have been shifted from classical limit equilibrium analysis toward the performance-based procedures. In foundation design, settlement is the most representative parameter for its performance. Settlement of shallow foundations subjected to earthquake loading and its consequences is one of the most outstanding issues which should be considered in designing different structures. In this study, settlement of shallow footing on two-layered subsoil strata under earthquake loading is of concern. The numerical study presented in this research by means of a 3D dynamic fully coupled u-p analysis, addresses the effect of different parameters on shallow foundation settlement... 

Short-circuit fault (SCF) detection is mandatory in a high voltage DC power supply (HVPS) to prevent fatal damage. The majority of converters employ a single sensor to detect the SCF. This attribute increases the interference vulnerability of the fault detection (FD) system in the presence of noise. Therefore, miss detections and false alarms are possible to occur. Miss detections and false alarms are harmful catastrophes in most applications. A commonly used method to suppress the noise impacts is using a low-bandwidth low-pass filter. However, the use of the low-bandwidth low-pass filter reduces the speed of FD due to the filter delay. This paper proposes a fast FD algorithm based on... 

Vacuum arc is one of the most important failure factors of the vacuum tubes. The amount of delivered energy from the high-voltage dc power supply to the vacuum tube is an important issue during the vacuum arc in the tube. Vacuum arc acts as a short-circuit fault (SCF) at the power supply output. The majority of converters use a single current sensor to measure only the converter output current for detecting the SCF. However, the sensor may provide unreliable data because of the noise effect. Application of a low-pass filter reduces the noise effect. Regarding the delay of the low-pass filter, the interval of arc detection increases and more energy is delivered to the tube. In this article, a... 

Vacuum arc is one of the most important failure factors of the vacuum tubes. The amount of delivered energy from the high-voltage dc power supply to the vacuum tube is an important issue during the vacuum arc in the tube. Vacuum arc acts as a short-circuit fault (SCF) at the power supply output. The majority of converters use a single current sensor to measure only the converter output current for detecting the SCF. However, the sensor may provide unreliable data because of the noise effect. Application of a low-pass filter reduces the noise effect. Regarding the delay of the low-pass filter, the interval of arc detection increases and more energy is delivered to the tube. In this article, a... 

In performance-based geotechnical earthquake engineering, the required degree and spatial extent of ground densification for mitigation of liquefaction beneath a structure should be determined based on the acceptable levels of performance of foundation. Currently, there is no solution for evaluation of the amount of settlement and tilt of footings constructed on a densified ground which is surrounded by a liquefiable soil. This implies the need for numerical procedures for simulation of seismic behavior of shallow foundations supported on both liquefiable and densified subsoil. In this paper, the dynamic response of shallow foundations on a densified ground is studied using a 3D fully... 

Vacuum tubes are widely used for various applications. These vacuum tubes are supplied by high voltage power supplies. The amount of delivered energy from the high voltage power supply to the vacuum tube is an important issue during the vacuum arc in the tube. The protection mechanism consists of a shunt crowbar which diverts the fault current from the tube to itself as a parallel path. Detection of the vacuum arc is crucial and only one sensor is usually employed to detect the vacuum arc. This characteristic intensifies the interference susceptibility of the vacuum arc diagnosis system in a noisy environment. As a result of the noise, the arc detection system can report false alarms. False... 

Liquefaction is a phenomenon through which saturated sandy soil loses its shear strength and turns into a liquefied state. One of the most detrimental consequences of liquefaction is the reconsolidation volumetric settlements after the earthquakes, which is due to the dissipation of excess pore pressure caused by earthquakes. Severe floods can follow these settlements in free fields such as grounds close to the sea or rivers. Several researchers studied this phenomenon using data obtained from experiments in the lab or observations in the fields. Previous works were mainly based on a limited number of experimental observations and considered loadings and boundary conditions that were... 

In our previous report (J. Phys. Org. Chem., 2017), we discussed the dual behavior of gold nanocluster (Au3 NC), where it scavenged reactive oxygen species (ROS) while promoted their generation to a lesser extent. Continuing this quest, we investigate the effects of Au3 NC on common reactive nitrogen species (RNS: O=N˙ and O=N-O) and their precursors (O=N-H and O=N-O-H, respectively), at B3LYP/LACVP+* level of theory. We compare the results with those of prevalent ROS (H-O˙ and H-O-O˙) and their precursors (H-O-H and H-O-O-H, respectively). To this end, various parameters are probed such as binding energy (Eb), bond dissociation energy (BDE), bond lengths, Mullikan spin density (MSD),... 

We have investigated the pathways of stability for NHCs derived from azole, di-azole, n-tetrazole, and ab-tetrazole (1a, 2a, 3a, and 4a, respectively), at the M06/6-311++G** level of theory. Optimization and vibrational frequency calculations of ground states (GS) and transition states (TS) are performed to identify Gibbs free energies and nature of stationary points, respectively. Two possible pathways of stability for 1a-4a are compared and contrasted which entail dimerization through hydrogen bonding (HB) and covalent bonding (CB). The CB pathway comprises head to head (HH) and head to tail (HT) dimerizations. Plausible reaction profiles are illustrated for 1a-4a along with the mechanism... 

In our previous report (J. Phys. Org. Chem., 2017), we discussed the dual behavior of gold nanocluster (Au3 NC), where it scavenged reactive oxygen species (ROS) while promoted their generation to a lesser extent. Continuing this quest, we investigate the effects of Au3 NC on common reactive nitrogen species (RNS: O=N˙ and O=N-O) and their precursors (O=N-H and O=N-O-H, respectively), at B3LYP/LACVP+* level of theory. We compare the results with those of prevalent ROS (H-O˙ and H-O-O˙) and their precursors (H-O-H and H-O-O-H, respectively). To this end, various parameters are probed such as binding energy (Eb), bond dissociation energy (BDE), bond lengths, Mullikan spin density (MSD),... 

Colloidal quantum dots (CQD) have attracted considerable attention for biomedical diagnosis and imaging as well as biochemical analysis and stem cell tracking. In this study, quasi core/shell lead sulfide/reduced graphene oxide CQD with near infrared emission (1100 nm) were prepared for potential bioimaging applications. The nanocrystals had an average diameter of ~4 nm, a hydrodynamic size of ~8 nm, and a high quantum efficiency of 28%. Toxicity assay of the hybrid CQD in the cultured human mononuclear blood cells does not show cytotoxicity up to 200 μg/ml. At high concentrations, damage to mitochondrial activity and mitochondrial membrane potential (MMP) due to the formation of... 

Polycarboxylate superplasticizers based on acrylic acid (AA) and maleic anhydride (MAn) were synthesized via free-radical copolymerization with an ethylene glycol monomer and characterized. The copolymerization temperature (ranging from 50 to 90 °C) appeared to be the key operating factor governing the chemical structure of the superplasticizers. The chemical structures of the products were analyzed by gel permeation chromatography, whereas an optimized sample was further analyzed by Fourier transform infrared spectroscopy and 1H-NMR. Superplasticizers of the AA and MAn classes were then incorporated into concrete, and their performances were measured by slump and slump loss tests, where a...