Sharif Digital Repository

Originally, the application of nano zero valent iron/nickel (nZVI/Ni) particles for nitrate removal in porous media was studied. nZVI/Ni was prepared and employed in batch and continuous modes. Based on batch experiments, the reaction kinetics was consistent with the adsorption model by the order of 1-1.5. The variation of the kinetics order depends on pH and nickel content. So that highest reactivity was observed for nZVI with 10% of Ni at pH ≤ 3. Nitrate remediation in a continuous system was mostly influenced by seepage velocity, quantity and freshness of nZVI/Ni and particle size of porous media. In a batch mode, the maximum nitrate removal was 99% while in a continuous mode it did not... 

Originally, application of nano zero valent iron (nZVI) particles for the removal of lead (Pb2+) in porous media was studied. At first, stabilized nZVI (S-nZVI) was prepared and characterized, then used in batch and continuous systems. Based on the batch experiments, corresponding reaction kinetics well fitted with the pseudo-first-order adsorption model, and reaction rate ranged from 0.01 to 0.04 g/mg/min depend on solution pH and the molar ratio between Fe and Pb. In batch tests, optimal condition with more than 90% removal efficiency at 60 min was observed at a pH range of 4 to 6 and Fe/Pb ratio more than 2.5. Continuous experiments exposed that Pb2+ remediation was as well influenced by... 

Wind turbines are of the most promising devices to cut down carbon emissions. However, some phenomena that adversely affect their performance are inevitable. The aim of the present paper is to investigate flow separation prevention exploiting leading edge (LE) single dielectric barrier discharge plasma actuator (SDBD-PA) on an airfoil belonging to a section of a locally developed wind turbine. The numerical results of the surface pressure distribution over the airfoil were compared with the experimental measurements carried out by the authors on the same blade section, and good agreement was found between numerical and experimental data for both plasma-OFF and plasma-ON cases. An in-depth... 

Fuel management in PWR nuclear reactors is comprised of a collection of principles and practices required for the planning, scheduling, refueling, and safe operation of nuclear power plants to minimize the total plant and system energy costs to the extent possible. Despite remarkable advancements in optimization procedures, inherent complexities in nuclear reactor structure and strong inter-dependency among the fundamental parameters of the core make it necessary to evaluate the most efficient arrangement of the core. Several patterns have been presented so far to determine the best configuration of fuels in the reactor core by emphasis on minimizing the local power peaking factor (Pq). In... 

Thermodynamic modeling is known as a promising tool for phase behavior modeling of asphaltene precipitation under different conditions such as pressure depletion and CO2 injection. In this work, a thermodynamic approach is used for modeling the phase behavior of asphaltene precipitation. The precipitated asphaltene phase is represented by an improved solid model, while the oil and gas phases are modeled with an equation of state. The PR-EOS was used to perform flash calculations. Then, the onset point and the amount of precipitated asphaltene were predicted. A computer code based on an improved solid model has been developed and used for predicting asphaltene precipitation data for one of... 

Thermodynamic modeling is known as a promising tool for phase behavior modeling of asphaltene precipitation under different conditions such as pressure depletion and CO2 injection. In this work, a thermodynamic approach is used for modeling the phase behavior of asphaltene precipitation. The precipitated asphaltene phase is represented by an improved solid model, while the oil and gas phases are modeled with an equation of state. The PR-EOS was used to perform flash calculations. Then, the onset point and the amount of precipitated asphaltene were predicted. A computer code based on an improved solid model has been developed and used for predicting asphaltene precipitation data for one of... 

Gas sparging and back-flushing treatments were compared as a means to tackle the problem of fouling in yeast microfiltration. Based on the feed and membrane characteristics, it was shown that either of these techniques could be superior to the other in order to overcome the problem. At more concentrated feed streams the main cause of flux decline was cake formation. In this condition gas sparging showed greater efficiency in flux enhancement. On the other hand at lower feed concentration the relative importance of internal fouling due to pore blockage, increased. In this case back-flushing was more effective. © 2007  

The concentration and temperature behaviors of the self-diffusion coefficient were analyzed in glycerol-water and methanol-water solutions using Diffusion-Ordered Spectroscopy (DOSY) experiment. Our results indicate that the self-diffusion coefficient dips with increasing concentration and decreasing temperature. The concentration behavior shows that there is hydrogen bond interaction between water and alcohol, which declines the self-diffusion coefficients of both in the aqueous binary mixtures. The self-diffusion activation energies were estimated 13.6, 29.4, and 32.8 (kJ/mol) for methanol and 24.8, 25.5, and 27.6 (kJ/mol) for water in the methanol-water solutions with 0.03, 0.10, and 0.20... 

We study the problem of maximizing constrained non-monotone submodular functions and provide approximation algorithms that improve existing algorithms in terms of either the approximation factor or simplicity. Different constraints that we study are exact cardinality and multiple knapsack constraints for which we achieve (0.25-)-factor algorithms. We also show, as our main contribution, how to use the continuous greedy process for non-monotone functions and, as a result, obtain a 0.13-factor approximation algorithm for maximization over any solvable down-monotone polytope  

A new and efficient model for calculation of the unsteady hydrodynamic loads on an oscillating plate in two-dimensional flow is proposed. In order to compute the hydrodynamic loads, an unsteady hydrodynamic model is derived using the boundary-element method along with the potential flow assumption. To this aim, the steady boundary of cavity is determined by a full-nonlinear iterative procedure. Thereafter, assuming that amplitude and frequency of oscillations are so that the length of cavity in unsteady flow remains intact, simulation of the unsteady hydrodynamic flow is performed by imposing some velocity perturbations over the steady cavity solutions. Consequently, based on this... 

The functionality of multi-stimuli-responsive hydrogels in physiological states is the reason for the increased attention of hydrogels nowadays. Multi-stimuli-responsive hydrogels exhibit tunable changes in swelling or mechanical properties in response to predetermined combinations of stimuli such as pH, temperature, ionic strength, electric field, magnetic field, light, chemical triggers, enzyme concentration, redox species, reactive oxygen species (ROS), and glucose levels. This review summarizes the recent advances in multi-stimuli-responsive hydrogels used in medical approaches. The first part of the review highlights the medical applications of polymer-based and supramolecular hydrogels... 

This paper is concerned with global analysis of a delay SVEIR epidemiological model in a population of varying size. By using Lyapunov stability method and LaSalle's invariance principle for delay systems, we prove that when there is no endemic equilibrium, the disease free equilibrium is globally asymptotically stable, otherwise the endemic equilibrium is globally stable  

With the introduction of restructuring concepts to traditional power systems, a great deal of attention is given to the utilization of distributed generation. Since the integration of DG units has been known as an alternative for main grid as a resource for energy supply, the determination of optimal sizing and sitting is an important issue in the planning procedure of DG. This work presents a comprehensive multi-objective model for integration of distributed generations into a distribution network, regarding various technical, economical and environmental issues such as reduction of carbon dioxide emissions and investment & running costs while the bus voltages shall be kept within... 

In contrast to more polar media, G-quadruplex assembly reveals remarkably high thermodynamic and kinetic stability in toluene solutions. Depending on the substituents installed at the lipophilic guanosine, either a dodecamer or an octamer complex is formed in the presence of K+ or Na+ salts that resist conditions of high dilution and elevated temperatures without exhibiting significant dissociation. Moreover, kinetic exchange between complexed and uncomplexed G is slow enough in NMR to monitor G-quadruplex formation along a day time scale. © 2017 American Chemical Society  

Development of hardware and CFD codes, especially in turbulence model and optimization of numerical codes has led to increment in usage of CFD which is capable of simulating different experimental situations take place at laboratory. Particularly in issues related to turbo machinery, twodimensional test of blades, three-dimensional investigation of different stages and studying the effect of different parameters are very costly. By means of CFD modeling all these issues are accessible. Actual flow within the compressor is three dimensional and fully turbulent due to geometry complexity, flow velocity and viscosity. For this reason it has become more and more popular to perform 3D numerical... 

Coronary artery disease (CAD) causes oscillations in peripheral arteries. Oscillations of the walls of the brachial arteries of 51 patients were recorded [together with the electrocardiogram (ECG)] by an accelerometer at different cuff pressures. By analyzing the energy of the oscillations in the 30-250 Hz band, 16 of 22 patients with CAD and 26 of 29 non-CAD subjects were classified correctly, independent of the ECG, and with no effect of heart murmurs  

In this work, forced-convection heat transfer of magnetic-sensitive nanofluids has been investigated in the presence of rotating magnetic field. In this regard, the laminar, Newtonian, incompressible, and two-dimensional (2D) fluid flow in a horizontal duct subject to constant wall temperature boundary condition was modeled. Moreover, the fluid was supposed to be non-electrical conductive and the magnetic field source comprised of two time varying components perpendicular to each other. Influences of magnetic field intensity and frequency, inlet fluid velocity, and spin viscosity on the forced-convection heat transfer of the magnetic nanofluids were investigated. It was found that the... 

In this article, three-dimensional (3D) forced-convection heat transfer of magnetic nanofluids in a pipe subject to constant wall heat flux in the presence of single or double permanent magnet(s) or current-carrying wire has been investigated and compared. In this regard, laminar fluid flow and equilibrium magnetization for the ferrofluid were considered. In addition, variations of magnetic field in different media were taken into account and the assumption of having a linear relationship of magnetization with applied magnetic field intensity was also relaxed. Effects of magnetic field intensity, nanoparticle volume fraction, Reynolds number value, and the type of magnetic field source... 

In this article, effects of magnetic fields induced by a finite length solenoid on the forced-convection heat transfer in a pipe partially filled with porous medium have been investigated. In this regard, two-dimensional steady-state fluid flow in the pipe was considered and the Darcy–Brinkman equation of motion was applied to model the fluid flow in the porous medium, as well as the thermal equilibrium was assumed between the solid phase and the magnetic nanofluid. Effects of electric current passing through the solenoid and the solenoid dimensions (i.e.; diameter and length) on the forced-convection heat transfer were studied carefully. The combined effects of the magnetic field and the...