Sharif Digital Repository

As a matter of fact, it is necessary to have the values of Response Modification Factor R, Over-strength Factor Ω0, and Deflection Amplification Factor Cd in order to design seismic-force-resisting systems according to design and loading codes. This study is intended to evaluate these factors for a structural lateral bracing system called Chevron Knee Bracing (CKB). In this type of bracing, the knee elements assist the system to dissipate energy through the formation of plastic flexural and/or shear hinges within the presented bracing system. The approach utilized in this study is according to FEMA P695 based on low probability of structural collapse and involves nonlinear static and dynamic... 

This paper studies the influence of burial depth on slope response and pipe performance under earthquake induced landslide. Three physical models are constructed and tested using 1 g shaking table device. The slope is divided into four sections as toe, lower and upper sections of the slope face and crest. The pips which perpendicularly cross the slope are embedded at these positions in three burial depths to demonstrate burial depth effect in each section. According to the experiments, dynamic slope response which moderately develops at deeper depths at toe and lower section, displays a clear downtrend at upper section and crest. Also, the pipe response depends on pipe route and slope... 

Landslides have disastrous influence on buried pipeline operation. In order to overcome this phenomenon, many retrofitting solutions have been proposed in literature and practice. This paper concentrates on the solutions which deal with pipe thickness change and rerouting method. As an answer to this,ABAQUS FE program has been used for numerical modeling. Soil-pipe interaction was modeled as hard and frictional contact in normal and tangential directions respectively. Typical geotechnical parameters of Tehran soil and predicted acceleration time history, compatible with Tehran geological condition, have been introduced to program for numerical calculations. Usefulness of two basic proposed... 

In this article, two base-line correction methods for correcting the near-source strong motions were studied on the near-source recording of the 2003, Bam earthquake. To obtain permanent ground displacements at Bam station, two methods were applied with some modifications and without using any kind of filtering. Even though it is difficult to calculate true permanent displacements from data attained by present accelerograms, the results of this study show that the rational limit of permanent ground displacements can be successfully achieved by rational choosing of effective parameters. In addition, it is observed that some pre-processing steps suggested in literature have no considerable... 

Enterprise risk management (ERM) has emerged as a more integrated risk management (IRM) framework in recent years. Many studies have been conducted in recent years to determine the effects of ERM implementation on other parts of an organization. The purpose of this research was to explore the relationship between ERM implementation and organizational performance. The research sample consisted of Iranian banks that either had a license from the central bank of Iran (CBI) or were active in the stock market. A novel measure of ERM implementation was employed in this study. Furthermore, the return on equity (ROE) and Tobin's Q ratio were used as two measures of organizational performance. The... 

In this paper the dynamic properties of Babolsar dry sand was investigated through one dimensional shaking table tests. 8 models of Babolsar loose dry sand under low confining pressures, were subjected to different harmonic and irregular dynamic loadings. The container was a laminar shear box having 24 layers each moving on the lower one. The dynamic properties including shear wave velocity, maximum shear modulus and damping ratio of the samples were addressed in this project. © 2006 Taylor & Francis Group, London  

The land-sliding forces applied to buried pipelines depend on the ground condition, types of loading and pipelines features. This paper intends to numerically investigate the effect of ground condition on pipelines. The loading type and pipeline features are kept constant. The pipeline which is positioned at mid-length of the slope, is made of steel and intersects the slope at the angle of 90o. The slope material specifications are determined based on geotechnical reports andthe harmonic loading simulates a 7.5 magnitude earthquake. The descending trend of slope displacement in sandy clay, loose to medium sand, cemented sand and medium to hard clayare shown by numerical calculations. But,... 

The land-sliding forces applied to buried pipelines depend on the ground condition, types of loading and pipelines features. This paper intends to numerically investigate the effect of ground condition on pipelines. The loading type and pipeline features are kept constant. The pipeline which is positioned at mid-length of the slope, is made of steel and intersects the slope at the angle of 90o. The slope material specifications are determined based on geotechnical reports andthe harmonic loading simulates a 7.5 magnitude earthquake. The descending trend of slope displacement in sandy clay, loose to medium sand, cemented sand and medium to hard clayare shown by numerical calculations. But,... 

Using multiple antennas at the transmit and receive sides of a passive radar brings both the benefits of MIMO radar and passive radar. However one of the obstacles arisen in such configuration is the receive antennas placement in proper positions so that the radar performance is improved. Here we just consider the case of positioning one receiver among multiple illuminators of opportunity. Indeed it is a start for the solution of optimizing the geometry of the multiple receivers in a passive radar  

SbCl3 supported on montmorillonite K-10 is an efficient catalyst for the ring opening of epoxides with aromatic amines under solvent-free conditions and microwave irradiation to give the corresponding b-amino alcohols in high yields with high regioselectivity  

In this paper, we consider an integrated sensing and communication (ISAC) system with wireless power transfer (WPT) where an unmanned aerial vehicle (UAV)-based radar serves a group of energy-limited communication users in addition to its sensing functionality. In this architecture, the radar senses the environment in phase 1 (namely sensing phase) and mean-while, the communications users (nodes) harvest and store the energy from the radar transmit signal. The stored energy is then used for information transmission from the nodes to UAV in phase 2, i.e., uplink phase. Performance of the radar system depends on the transmit signal as well as the receive filter; the energy of the transmit... 

One of the important obstacles in MIMO (Multiple Input Multiple Output) radars is the issue of designing proper transmit signals. Indeed, the capability of signal design is a significant advantage in MIMO radars, through which, the system can achieve much better performance. Many different aspects of this performance improvement have been considered yet, and the transmit signals have been designed to attain such goal, e.g., getting higher SNR or better detector's performance at the receiver. However, an important tool for evaluating the radar's performance is its ambiguity function. In this paper, we consider the problem of transmit signal design, in order to optimize the ambiguity function... 

Two gains play key roles in recently developed MIMO wireless communication systems: "spatial diversity" gain and "spatial multiplexing" gain. The diversity gain refers to the capability to decrease the error rate of the MIMO channel, while the multiplexing gain implicitly refers to the amount of increase in the capacity of the MIMO channel. It has been shown that there is a fundamental tradeoff between these two types of gains, meaning interplay between increasing reliability (via an increase in the diversity gain) and increasing data rate (via an increase in the multiplexing gain). On the other hand, recently, MIMO radars have attracted much attention for their superior ability to enhance... 

It is a well known fact that using multiple antennas at transmit and receive sides improves the detection performance. However, in such multiple-input multiple-output (MIMO) configuration, proper positioning of transmitters and receivers is a big challenge that can have significant influence on the performance of the overall system. In addition, determining the power of each transmitter under a total power constraint is a problem that should be solved in order to enhance the performance and coverage of such a system. In this paper, we design the Neyman-Pearson detector under the Rayleigh scatter model and use it to introduce a criterion for the antenna placement at both transmit and receive... 

There has been much interest, recently, towards exploiting the Multiple-Input Multiple-Output (MIMO) technique in radar. It is shown that using multiple antennas at transmit and receive sides can improve the performance of the system. However, in order to analyze the system's performance, its ambiguity function, i.e. the ambiguity function of a MIMO radar, is needed to be defined. In this paper, beginning from the information theoretic definitions, we derive such function, specifically for a MIMO radar with widely separated antennas