Sharif Digital Repository

A low power analog to digital converter (ADC), based on a pipelining method employed in successive approximation register (SAR) architecture is presented. This structure is a two-stage pipeline SAR ADC with asymmetrical time interleaved (TI) channels, aimed to reach sampling rate as high as about threefold of a conventional SAR ADC while benefiting from its low power consumption and small area. Passive residue conversion without inter-stage amplifier and symphonic collaboration of stages are employed to design a low power, high speed, and accurate converter. In the proposed architecture, every signal sample experiences equal comparator offset during its conversion due to the applied novel... 

Air–water flow is a complex and challenging subject in many engineering fields as well as hydraulic engineering; and discovery of its characteristics can help the engineers to predict and analyze a probable phenomenon. In the present paper, development of a device capable of measuring the flow velocity, air concentration, diameter and counts of bubbles in air–water flows is described. The heart of the present device is two resistive probes with a novel configuration. Being pressure and corrosion resistant and also having negligible resistivity in the flow are some of the unique features of the employed needles. Moreover, sampling frequency and time can be adjusted for the intended... 

This paper presents a quadrature-clock generator based on a novel low-power ring oscillator with a wide frequency tuning range and low temperature variations. The proposed ring oscillator consists of two differential delay cells with a new controllable capacitive load of an MOS transistor. The wide tuning range is achieved due to transistor utilization in different regions and considering its resistance not to narrow down the frequency range. Delay cells are biased with a minimum possible value of a proportion to absolute temperature current to decrease frequency variations to temperature while the power consumption is kept low. The validation of the proposed methods is proved by circuit... 

Due to wireless communication’s rapid growth, the need for low power integrated transceivers is increasing. The receiver power is a major limiting factor, and the radio frequency (RF) front-end is often its significant power consuming part. Therefore, system-level design in which the overall specifications are distributed among RF front-end building blocks such that the minimum total power is consumed is crucial. A complete system-level design method for a low power RF front-end is presented in this paper. For this purpose, the performance of each block is modeled by its current and overdrive voltage. An analytical associated with a search-based optimization technique is employed to derive... 

The current study presents a numerical investigation on turbulent hydrothermal characteristics in a wavy passage equipped with discontinuous twisted tapes. The working fluid is water and passage walls are kept under constant wall temperature. The effect of Reynolds number (Re = 2500, 4500, 6500, 8500 and 10500), twist angle (TA = 90∘ and 180∘) and inclination angle (IA = 15∘ and 30∘) on velocity fields and streamlines, temperature contours, Nusselt number, friction factor, turbulent kinetic energy (TKE), thermal performance factor (TPF), energy efficiency factor (EEF) and entropy generation rate are evaluated. More uniform temperature and velocity fields can be found as both wavy passage and... 

This work studies the nonlinear oscillations of an elastic rotating shaft with acceleration to pass through the critical speeds. A mathematical model incorporating the Von-Karman higher-order deformations in bending is developed to investigate the nonlinear dynamics of rotors. A flexible shaft on flexible bearings with springs and dampers is considered as rotor system for this work. The shaft is modeled as a beam and the Euler-Bernoulli beam theory is applied. The kinetic and strain energies of the rotor system are derived and Lagrange method is then applied to obtain the coupled nonlinear differential equations of motion for 6 degrees of freedom. In order to solve these equations... 

This work studies the nonlinear oscillations of an elastic rotating shaft with acceleration to pass through the critical speeds. A mathematical model incorporating the Von-Karman higher-order deformations in bending is developed and analyzed to investigate the nonlinear dynamics of rotors. A flexible shaft on flexible bearings with springs and dampers is considered as rotor system for the present work. The shaft is modeled as a beam with a circular cross-section and the Euler Bernoulli beam theory is applied. The kinetic and strain energies of the rotor system are derived and Lagrange method is then applied to obtain the coupled nonlinear differential equations of motion for 6° of freedom.... 

Artifact removal is an essential part in electroencephalogram (EEG) recording and the raw EEG signals require preprocessing before feature extraction. In this work, we implemented three filtering methods and demonstrated their effects on the performance of different classifiers. Bandpass digital filtering, median filtering and facet method are three preprocessing approaches investigated in this paper. We used data set lib from the BCI competition 2003 for training and testing phase. Our accuracy varied between 80% and 96%. In our work, we demonstrated that the problems of choosing the classifier and preprocessing methods are not independent of each other. Two of our approaches could achieve...