Sharif Digital Repository

A low power analog to digital converter (ADC), based on a pipelining method employed in successive approximation register (SAR) architecture is presented. This structure is a two-stage pipeline SAR ADC with asymmetrical time interleaved (TI) channels, aimed to reach sampling rate as high as about threefold of a conventional SAR ADC while benefiting from its low power consumption and small area. Passive residue conversion without inter-stage amplifier and symphonic collaboration of stages are employed to design a low power, high speed, and accurate converter. In the proposed architecture, every signal sample experiences equal comparator offset during its conversion due to the applied novel... 

Air–water flow is a complex and challenging subject in many engineering fields as well as hydraulic engineering; and discovery of its characteristics can help the engineers to predict and analyze a probable phenomenon. In the present paper, development of a device capable of measuring the flow velocity, air concentration, diameter and counts of bubbles in air–water flows is described. The heart of the present device is two resistive probes with a novel configuration. Being pressure and corrosion resistant and also having negligible resistivity in the flow are some of the unique features of the employed needles. Moreover, sampling frequency and time can be adjusted for the intended... 

This paper presents a quadrature-clock generator based on a novel low-power ring oscillator with a wide frequency tuning range and low temperature variations. The proposed ring oscillator consists of two differential delay cells with a new controllable capacitive load of an MOS transistor. The wide tuning range is achieved due to transistor utilization in different regions and considering its resistance not to narrow down the frequency range. Delay cells are biased with a minimum possible value of a proportion to absolute temperature current to decrease frequency variations to temperature while the power consumption is kept low. The validation of the proposed methods is proved by circuit... 

Due to wireless communication’s rapid growth, the need for low power integrated transceivers is increasing. The receiver power is a major limiting factor, and the radio frequency (RF) front-end is often its significant power consuming part. Therefore, system-level design in which the overall specifications are distributed among RF front-end building blocks such that the minimum total power is consumed is crucial. A complete system-level design method for a low power RF front-end is presented in this paper. For this purpose, the performance of each block is modeled by its current and overdrive voltage. An analytical associated with a search-based optimization technique is employed to derive... 

The current study presents a numerical investigation on turbulent hydrothermal characteristics in a wavy passage equipped with discontinuous twisted tapes. The working fluid is water and passage walls are kept under constant wall temperature. The effect of Reynolds number (Re = 2500, 4500, 6500, 8500 and 10500), twist angle (TA = 90∘ and 180∘) and inclination angle (IA = 15∘ and 30∘) on velocity fields and streamlines, temperature contours, Nusselt number, friction factor, turbulent kinetic energy (TKE), thermal performance factor (TPF), energy efficiency factor (EEF) and entropy generation rate are evaluated. More uniform temperature and velocity fields can be found as both wavy passage and... 

Demand forecasting plays an important role as a decision support tool in power system management, especially in smart grid and liberalized power market. In this paper, a demand forecasting method is presented by using support vector regression (SVR). The proposed method is applied to practical hourly data of the Greater Tehran Electricity Distribution Company. The SVR parameters are selected by using a grid optimization process and an investigation on different kernel functions. Moreover, correlation analysis is used to find exogenous variables. Acceptable accuracy of load prediction is shown by comparing the result of SVR model to that of the artificial neural networks and the actual data,... 

Artifact removal is an essential part in electroencephalogram (EEG) recording and the raw EEG signals require preprocessing before feature extraction. In this work, we implemented three filtering methods and demonstrated their effects on the performance of different classifiers. Bandpass digital filtering, median filtering and facet method are three preprocessing approaches investigated in this paper. We used data set lib from the BCI competition 2003 for training and testing phase. Our accuracy varied between 80% and 96%. In our work, we demonstrated that the problems of choosing the classifier and preprocessing methods are not independent of each other. Two of our approaches could achieve... 

Boiling of water/triethyleneglycol (TEG) binary solution has a wide-ranging application in the gas processing engineering. Design, operation and optimization of the involved boilers require accurate prediction of boiling heat transfer coefficient between surface and solution. In this investigation, nucleate pool boiling heat transfer coefficient has been experimentally measured on a horizontal rod heater in water/TEG binary solutions in a wide range of concentrations and heat fluxes under ambient condition. The present experimental data are correlated using major existing correlations. In addition a correlation is presented for prediction of pool boiling heat transfer for the system in which... 

One of the roles of a Natural Language Processing (NLP) model in Continuous Speech Recognition (CSR) systems is to find the best sentence hypothesis by ranking all n-best sentences according to the grammar. This paper describes a robust parsing algorithm for Spoken Language Recognition (SLR) which utilizes a technique that improves the efficiency of parsing. This technique integrates grammatical and statistical approaches, and by using a best-first parsing strategy improves the accuracy of recognition. Preliminary experimental results using a Persian continuous speech recognition system show effective improvements in accuracy with little change in recognition time. The word error rate was... 

Nucleate pool boiling heat transfer coefficient have been experimentally measured on a horizontal rod heater for various liquid binary mixtures. Measurements are based on more than three hundred data points on a wide range of concentrations and heat fluxes. In this investigation, it has been confirmed that the heat transfer coefficient in boiling solutions are regularly less than those in pure component liquids with same physical properties. Several reasons should be responsible for this phenomenon, but mainly it could be related to preferential evaporation of the more volatile component(s) during bubble formation. In this article, the performances of major existing correlations to the... 

The secretary problems are of types of the optimal stopping theory problems and are also distinguished as well known problems in applied probability, statistics and decision theory fields. The importance of these kinds of problems defines many new conditions which have been discussed till now. The significance of these types of problems in social issues causes to define many conditions which are vastly discussed. In this paper, a new condition of this problem is considered. These conditions which have been performed using a real time method are based on Multi-Agent Systems techniques. In this paper, after evaluating this method, the resulted answers are examined using Multi-Agent system... 

The isomerization of D-glucose to D-fructose using the immobilized glucose isomerase, as a typical model system of solid-liquid enzyme reactions has been carried out in a novel type of two-impinging-jets reactor (TIJR), which is characterized by a rotating inner cylinder in a stationary one. Because of the impinging process, turbulence, and complex trajectory of the solid particles within the reactor, the fractional conversion of glucose obtained in the TIJR increased dramatically compared to that obtained by conventional reaction systems. A compartment model was considered to describe the pattern of flow [residence time distribution (RTD) of solid particles] within the TIJR. Considering...