Sharif Digital Repository

Modeling and controlling the fuel slosh phenomenon in a satellite is a vital problem in the field of satellite attitude control. In this paper, a satellite with a partially filled spherical fuel tank that uses diaphragm as a propellant management device (PMD), has been considered. The fuel slosh dynamics is modeled by a spherical pendulum with two degrees of freedom (DOF) and a rigid arm, which represents the first mode of sloshing. The effects of the diaphragm that surround the fuel surface, are considered as torsional spring-damper attached to the satellite body. The coupled equations of satellite motion and fuel are derived using the Lagrange method. The nonlinear control method based on... 

OBJECTIVE: This study aims to benchmark a Monte Carlo (MC) model of the 18 MV photon beam produced by the Siemens Oncor® linac using the BEAMnrc and DOSXYZnrc codes. METHODS: By matching the percentage depth doses and beam profiles calculated by MC simulations with measurements, the initial electron beam parameters including electron energy, full width at half maximum (spatial FWHM), and mean angular spread were derived for the 10×10 cm2 and 20×20 cm2 field sizes. The MC model of the 18 MV photon beam was then validated against the measurements for different field sizes (5×5, 30×30 and 40×40 cm2) by gamma index analysis. RESULTS: The optimum values for electron energy, spatial FWHM and mean... 

γ-Alumina is used to catalyze the Cannizzaro reaction in the absence of any base under microwave irradiation in high yields. In the case of terephthalaldehyde the reaction is carried out with high selectivity  

Enolizable ketones have been reacted in a one-pot method with aromatic aldehydes, acetyl chloride and acetonitrile at room temperature in the presence of SnCl4/SiO2 to furnish the corresponding β-acetamidoketones in improved yields. Acetylation of an aromatic hydroxyl group was observed while using 4-hydroxybenzaldehyde or vanillin and the corresponding β-acetamidoketones were isolated in an excellent yield  

The boundary layer integral method is used to investigate the development of the turbulent swirling flow at the entrance region of a conical nozzle. The governing equations in the spherical coordinate system are simplified with the boundary layer assumptions and integrated through the boundary layer. The resulting sets of differential equations are then solved by the fourth-order Adams predictor-corrector method. The free vortex and uniform velocity profiles are applied for the tangential and axial velocities at the inlet region, respectively. Due to the lack of experimental data for swirling flows in converging nozzles, the developed model is validated against the numerical simulations. The... 

The governing equations of two-dimensional steady density currents are solved numerically using a finite volume method. The v2̄-f turbulence model, based on standard k - s model, is used for the turbulence closure. In this method, all Reynolds stress equations are replaced with both a transport equation for v2̄ and an elliptic relaxation equation for f, a parameter closely related to the pressure strain redistribution term. The Simple-C procedure is used for pressure-velocity coupling. In addition, Boussinesq's approximation is used to obtain the momentum equation. The computed height of the progressive density current is compared to the measured data in the literature, resulting in good... 

The deposition behavior of fine sediment is an important phenomenon, and yet unclear to engineers concerned about reservoir sedimentation. An elliptic relaxation turbulence model (v2̄ - f model) has been used to simulate the motion of turbid density currents laden whit fine solid particles. During the last few years, the v2̄ - f turbulence model has become increasingly popular due to its ability to account for near-wall damping without use of damping functions. In addition, it has been proved that the v2̄ - f model to be superior to other RANS methods in many fluid flows where complex flow features are present. Due to low Reynolds number turbulence of turbidity current,(its critical Reynolds... 

In this paper, an analytical solution for steady creeping motion of viscoelastic drop falling through a viscous Newtonian fluid is presented. The Oldroyd-B model is used as the constitutive equation. The analytical solutions for both interior and exterior flows are obtained using the perturbation method. Deborah number and capillary numbers are considered as the perturbation parameters. The effect of viscoelastic properties on drop shape and motion are studied in detail. The previous empirical studies indicated that unlike the Newtonian creeping drop in which the drop shape is exactly spherical, a dimpled shape appears in viscoelastic drops. It is shown that the results of the present... 

In this paper, creeping motion of a viscoelastic drop falling through a Newtonian fluid is investigated experimentally and analytically. A polymeric solution of 0.08 % xanthan gum in 80:20 glycerol/water and silicon oil is implemented as the viscoelastic drop and the bulk viscous fluids, respectively. The shape and motion of falling drops are visualized using a high speed camera. The perturbation technique is employed for both interior and exterior flows, and Deborah and capillary numbers are considered as perturbation parameters up to second order. The product of Deborah and capillary numbers is also used as a perturbation parameter to apply the boundary condition on the deformation on the... 

In this paper, we consider the problem of minimizing the uplink delays of users in a 5G cellular network. Such cellular network is based on a Cloud Radio Access Network (CRAN) architecture with limited fronthaul capacity, where our goal is to minimize delays of all users through an optimal resource allocation. Earlier works minimize average delay of each user assuming same transmit power for all users. Combining Pareto optimization and Markov Decision Process (MDP), we show that every desired balance in the trade-off among infinite-horizon average-reward delays, is achievable by minimizing a properly weighted sum delays. In addition, we solve the problem in two realistic scenarios;... 

Microwave induced Cannizzaro reaction, which was performed in presence of neutral γ-alumina as a polymeric catalyst, was discussed. Cannizzaro reaction was carried out on alumina surface and other unknown products were also obtained. Solvent extraction method was utilized to isolate mild and selective benzyl alcohol and carboxylic acids  

A well known method to reduce the intrinsic complexity of Multiple Input Multiple Output (MIMO) systems is to choose a subset of available antennas which have stronger links than the others, in order to perform the specified MIMO algorithm. The data resulted from the antenna selection process (at the receiver side) is sent back to the transmitter side via a feedback channel. There seems to be a need to reduce the number of feedack bits, specially when the number of antennas is not small. In this paper, we investigate the problem of reducing the number of feedback bits in antenna selection techniques. We've proposed two methods using vector quantization techniques to perform feedback bit... 

Nowadays, deployment of peer-to-peer video streaming systems over wireless mesh networks has attained raising popularity among large number of users around the world. In this paper, we present an efficient peer-to-peer live video streaming architecture over multi-hop wireless mesh networks. In our proposed architecture, we take the physical topology of network into account and based on a distributed distributed locality-aware neighbor selection algorithm in the overlay construction phase, we generate an efficient mesh-based overlay on top of wireless mesh networks. In locality-aware neighbor selection algorithm, instead of choosing randomly, peers find their best neighbors based on their...