Sharif Digital Repository

In this paper, by applying a new permutation to the full-diversity block circular delay diversity (BCDD) space-frequency codes (SFCs), we show that their performance could be enhanced. Furthermore, we propose a new method for performing the permutation in the absence of partial channel state information at the transmitter. This new permutation, which is done based on artificial delay and power profiles (ADPPs), could improve the performance of the BCDD SFCs more than 3 dB as simulation results demonstrate  

Oxygen reduction on a polycrystalline silver electrode was studied by cyclic voltammetry and electrochemical impedance spectroscopy. The reaction occurred by a two-electron pathway. The steps in the mechanism were observed in the cyclic voltammograms recorded with different scan rates. The intermediates formed in the steps were detected by electrochemical impedance spectroscopy  

Phytoremediation has been applied for treating an extensive range of environmental contaminants such as anti-diabetic drug metformin which is increasingly found as environmental contaminant. These contaminants are released to the environment via human and veterinary medicine and pharmaceutical industries. In this study, native plant capabilities for uptake of metformin from wastewater were investigated. Moreover, uptake rate of metformin was studied in two different concentrations of 20 and 50 mg l−1 metformin solution by Amaranthus retroflexus, Ricinus communis, Brassica napus, Celosia cristata, Helianthus annuus and Phragmites australis. The results showed that after exposing to 20 mg l−1... 

In this paper, an efficient dynamic simulation algorithm is developed for an Unmanned Underwater Vehicle (UUV) with a N degrees of freedom manipulator. In addition to the effects of mobile base, the various hydrodynamic forces exerted on these systems in an underwater environment are also incorporated into the simulation. The effects modeled in this work are added mass, viscous drag, fluid acceleration, and buoyancy forces. Also the dynamics of thrusters are developed, and an appropriate mapping matrix dependent on the position and orientation of the thrusters on the vehicle, is used to calculate resultant forces and moments of the thrusters on the center of gravity of the vehicle. It should... 

The fast and very fast transient overvoltages can endanger the insulation of transformer windings. Therefore, it is necessary to develop models, to study these transients. This paper compares the two well-known multiconductor transmission line (MTL) and lumped parameter detailed (RLC ladder network) models. The high-voltage (HV) winding of a 220/35-kV, 50-MVA transformer has been modeled using these models. The simulation results of the MTL and the RLC ladder network models have been compared with the measurements results in the frequency domain, by application of the Pearson's correlation coefficients. It is shown that the RLC Ladder Network model should be used for fast transient... 

A series of consolidated undrained triaxial tests were performed in order to understand the behavior of a gravely sand. The material was selected from Tehran alluvium and is classified as gravely sand in the Unified Soil Classification System. Critical state concepts were used for interpretation of the behavior of the soil. The critical state line in q - p′ space was reasonably unique. However, it was not possible to define a unique critical state line in e -ln p′ space. The overall scatter, in the critical state line for the gravely sand studied, was ± 0.04, in terms of void ratio. Two reasons can be identified for this scatter. The first reason is the inevitable error in void ratio... 

A luminescent coating of CaAlSiN3:Eu2+ particles applied on photoanode (TiO2) layer of SQ1 sensitized solar cell by doctor blading the paste of phosphor particles. The luminescent layer acted as a dual functional layer and enhanced the short circuit current density (JSC) by 64% via both scattering effect and downshifting of the photons in 400-600nm spectral range to photons in 600-800nm spectral range. Considerable relative enhancement in incident photon to current conversion efficiency (IPCE) up to 350% in 400-600nm spectral range proves the down shifting effect as the dominant factor for the improved performance of dye sensitized solar cell (DSSC). © 2016 Elsevier B.V  

In this paper modeling and simulation of an underwater vehicle equipped with manipulator arms, using a composite rigid body algorithm, will be discussed. Because of the increasing need for unmanned underwater vehicles (UUVs) in oil and gas projects in the Persian Gulf for doing operations such as inspection of offshore jackets, subsea pipelines, and submarine cables, and also pre-installation survey and post-laid survey of submarine pipelines and cables, design and construction of "SROV" was developed in Sharif University of Technology, and at the design stage behavior of the underwater vehicles was studied. In this paper, an efficient dynamic simulation algorithm is developed for an UUV... 

Developing a simple, cost effective and accurate detection method for L-lysine (Lys), L-leucine (Leu) and glycine (Gly) as the important analytes in clinical diagnostics, biological processes and food industries is of great significance. Herein, we prepared spin-coated TEMPO-oxidized cellulose nanofibrils (TOCNFs) on Quartz Crystal Microbalance (QCM) chip to achieve QCM biodetectors. The coated QCMs were carefully characterized before and after interaction with amino acids (AA) using water contact angle (WCA), Fourier transform infrared spectrophotometry-attenuated total reflectance (FTIR-ATR), Raman spectroscopy, and scanning electron microscopy (SEM). In addition, to study the response of... 

Spin-Transfer Torque Random Access Memories (STT-RAMs) are a promising alternative to SRAMs in on-chip caches. STT-RAMs face with a high error rate in write operations due to stochastic switching. To alleviate this problem, Error-Correcting Codes (ECCs) are commonly used, which results in a significant area and energy consumption overhead. This paper proposes an efficient technique, so-called Adaptive Way Allocation for Reconfigurable ECCs (AWARE), to correct write errors in STT-RAM caches. AWARE exploits the asymmetric error rate in cell switching directions, which leads to data-dependent write error rates, to reduce the ECC overheads without compromising the reliability of the cache. To... 

Due to serious problems of SRAM-based caches in nano-scale technologies, researchers seek for new alternatives. Among the existing options, STT-RAMseems to be themost promising alternative.With high density and negligible leakage power, STT-RAMs open a new door to respond to future demands of multi-core systems, i.e., large on-chip caches. However, several problems in STT-RAMs should be overcome to make it applicable in on-chip caches.High probability of write error due to stochastic switching is amajor problemin STT-RAMs. Conventional Error-CorrectingCodes (ECCs) impose significant area and energy consumption overheads to protect STT-RAMcaches. These overheads in multi-core processors with... 

Spin-Transfer Torque Random Access Memories (STT-RAMs) are a promising alternative to SRAMs in on-chip caches. STT-RAMs face with a high error rate in write operations due to stochastic switching. To alleviate this problem, Error-Correcting Codes (ECCs) are commonly used, which results in a significant area and energy consumption overhead. This paper proposes an efficient technique, so-called Adaptive Way Allocation for Reconfigurable ECCs (AWARE), to correct write errors in STT-RAM caches. AWARE exploits the asymmetric error rate in cell switching directions, which leads to data-dependent write error rates, to reduce the ECC overheads without compromising the reliability of the cache. To... 

Emerging STT-MRAM memories are promising alternatives for SRAM memories to tackle their low density and high static power consumption, but impose high energy consumption for reliable read/write operations. However, absolute data integrity is not required for many approximate computing applications, allowing energy savings with minimal quality loss. This paper proposes QuARK, a hardware/software approach for trading reliability of STT-MRAM caches for energy savings in the on-chip memory hierarchy of multi- A nd many-core systems running approximate applications. In contrast to SRAM-based cache-way-level actuators, QuARK utilizes fine-grained cache-line-level actuation knobs with different... 

In this study, the fatigue behavior of composite reinforced cracked aluminum 1050 plates is investigated experimentally and numerically. The tests are conducted in four different stress ratios between 0 and 1. At first step, plates with similar cracks and geometries have been prepared. Then the glass/epoxy patches have been attached to the cracked plates using Araldite 2015 adhesive. Fatigue load has been applied to three cases of samples including non-patch, one-side patch and two-side patch, where in all stress ratios the maximum force is considered constant. A three-dimensional finite element analysis is developed in ABAQUS. A good correlation between finite element results and the... 

Noise analysis techniques including Feynman-α (variance-to-mean) and Rossi-α (correlation) have been simulated by MCNP computer code to calculate the prompt neutron decay constant (α0), effective delayed neutron fraction (βeff) and neutron generation time (Λ) in a subcritical condition for the first operating core configuration of Tehran Research Reactor (TRR). The reactor core is considered to be in zero power (reactor power is less than 1 W) in the entire simulation process. The effect of some key parameters such as detector efficiency, detector position and its dead time on the results of simulation has been discussed as well. The results of proposed method in the current study are... 

In this paper, a two-component Lattice Boltzmann Method (LBM) has been utilized to simulate the natural convection of TiO2-water nanofluid in a curved geometry. The main purpose of this research is to study the effect of nanoparticle size and also boundary conditions on the thermal characteristics of the nanofluid. Furthermore, the effect of Rayleigh number (Ra) and volume fraction of nanoparticles (ϕ) on the average Nusselt number (Nuave) have been investigated. Two different thermal boundary conditions, namely adiabatic and constant temperature, have been considered in the current work for the curved boundaries. The Rayleigh number varies from 103 to 109. Four different sizes, namely 10,... 

The corrosion behavior of different grades of commercial aluminum such as AA1040, AA5083, AA6060 and AA7075 in ZnO-containing 4 M NaOH has been determined by using open circuit potential-time measurements (OCP), galvanostatic and potentiodynamic polarization and electrochemical impedance spectroscopy (EIS). The results of scanning electron microscopy (SEM) and energy dispersive analysis of X-ray (EDAX) reveal that ZnO produces the inhibition effect by the formation of a zinc-containing deposit layer on the surface of aluminum electrodes. Although the influence of zincating on the performance of aluminum alloys and considering the amount of alloying elements such as zinc, magnesium and... 

The behavior of a cemented gravely sand was studied using triaxial compression tests. Gypsum, Portland cement and lime were used as the cementing agents in sample preparation. The samples with different cement types were compared in equal cement contents. Three cement contents of 1.5%, 3.0% and 4.5% were selected for sample preparation. Drained and undrained triaxial compression tests were conducted in a range of confining pressures from 25 kPa to 500 kPa. Failure modes, shear strength, stress-strain behavior, volume and pore pressure changes were considered. The gypsum cement induced the highest brittleness in soil among three cement types while the Portland cement was found to be the most... 

Face Analysis is an important task in image processing. Most of these tasks centralized on face recognition and detection. One of different ways for deceiving automatic face analysis systems is mark notation on the skin. On the other hand some applications attempts to eliminate defects of the face. Hence, in this paper we try to detect and remove skin marks on the face, whether they're natural or not. Our algorithm passes face image through appropriate filters to get mark candidates and then create a graph space using 8-point neighborhood relations of mark candidates image pixels. Then we compute probabilities of each mark candidate using four measures based on intensity of occurrence, shape... 

For a dye-sensitized solar cell with a near-infrared squaraine (SQ1) sensitizer, the photovoltaic performance was enhanced remarkably with a reflective luminescent down-shifting (R-LDS) layer to increase the light-harvesting efficiency at the wavelength region 400-550 nm where the SQ1 dye has weak absorption. Relative enhancements greater than 200% in IPCE near 500 nm and 40-54% in JSC were achieved with red phosphor CaAlSiN 3:Eu2+ as the LDS material, attaining 5.0 and 4.8% overall efficiencies of power conversion for the R-LDS layer coated on the counter electrode (front illumination) and working electrode (back illumination), respectively