Sharif Digital Repository

High efficiency and low-emission fuel cells have the capacity to replace fossil fuels for energy supply concerns. Solid oxide fuel cells operate in relatively high temperature and have power plant applications. Hence, they are acquainted to be coupled with cycle gas turbine to reduce the cost and increase the overall system efficiency. The control of these hybrid systems is so important. Due to the system nonlinearity and having more than one controlled variable, its control with classic methods would be difficult. The model based predictive control is used as an alternative to mitigate these difficulties. In addition to their high performance, their extension to the multivariate case would... 

With the progression of technology demands for novel method of heat cooling is increased so the old method of cooling such as heat removal by air stream with force convection and even single phase method was not sufficient for today’s industry need. Nowaday, spray cooling method which belongs to two phase cooling method is one of the most popular method. In this study two method of spray cooling: spray cooling with flow blurring nozzle and electrospray cooling were investigated. For both method, at first the physics of phenomena and morphology of spray is studied experimentally then the efficiency of heat removal in each method is evaluated by the assessment of variation of temperature and... 

Primary visual cortex plays a paramount role in processing visual information. Visual information after the primitive processing by LGN and Thalamus, will be sent to the primary visual cortex which is called V1 area. According to the fact that V1 neurons have the definitive sensitivity to the edge and contrast of visual stimuli so their behavior are very selective to the certain features, specially contrast, of visual stimuli. These neurons have different response behavior to contrast. In fact most of them have some nonlinear behavior to this feature. Normally we expect that response of them or spiking rate of them grow linearly by the contrast increases but in most many cases they have some... 

Epoxy resins are used for a wide number of application due to good stiffness, chemical resistant and dimensional stability. This is the reason of their use as matrix in composite material. The incorporation of a small amount of carbon nanotubes (CNTs) in epoxy increases mechanical properties if nanocomposite have strong interfacial interaction between epoxy and CNTs, fine dispersion of CNTs and high final aspect ratio CNTs. In Noncovalent functionalization by polymer surfactant, CNTs are dispersed in a solvent/surfactant solution by ultra-sonication and then added to epoxy. In this thesis a novel study of toughening and mechanical properties of epoxy/ rubber/ CNT nanocomposite is presented.... 

Improvement of semiconductors photocatalytic activity by different means has always been one of the challenges for researchers. Semiconductors doping for band-gap engineering and changing morphology to increase specific surface area and photocatalytic reaction sites are amongst these efforts. In this research simultaneous effect of these two parameters for three morphologies containing nanoparticle, nanowire and micro dandelion, simultaneously doped with carbon and nitrogen has been investigated. Final purpose of this thesis is to decrease the band-gap energy close to soft UV photon energies to make surface photodynamic therapy possible. Nanoparticle morphology with size distribution between... 

Light-sensitive hydrogels are advanced materials with modern applications that have the ability to deform with light radiation at specific frequencies. Numerous studies have been conducted to identify the behavior and deformation of these materials. Most studies have experimentally investigated the light-sensitive behavior of hydrogels. On the other hand, modeling the behavior of light-sensitive hydrogels is very complicated, so that the use of these models is possible only in certain cases. Therefore, in the present study, the existing studies have been reviewed in order to simplify the relationships governing the deformation of light-sensitive hydrogels. In this regard, the deformation... 

In this thesis the behavior of a 3D wing has investigated by Flow visualization and pressure acquisition test. The goal of this tests was considering changes in 3D wing section parameter in comparison with 2D airfoils. The performed Tests showed that variation in 3D wing treatment is affected by finite aspect ratio and sweep angle and also indicate changes in pressure profile, increasing pressure peak and decreasing effective speed. CFD studies has conducted to investigate special effect of sweep angle and show that lift and drag coefficient decrease with increasing sweep angle. Also different section pressure profile near the wing tip and intersection of wing/fuselage varies and miss... 

The representation of data influences the explanation factors of data variations. Thus,the success of learner algorithms depends on the data representation. Our main contribution in this thesis is learning of high level and abstract representation using deep structure. One of the fundamental examples of representation learning is the AutoEncoders. The auto-encoder is a rigid framework that doesn’t consider explanation factors in terms of statistical concepts. So, the auto-encoders can be re-interpreted by seeing the decoder as the statistical model of interest. The role of encoder is a mechanism for inference in the model described by the decoder. Our purpose is to design such model with... 

One of the main challenges in characterization and simulation of larg scale porous media is spatial heterogeneity and variability of porous media properties such as porosity, density, and lithology at different scales. These information can be achieved at different scale from coring, well logging or seismic data. Well logs are an efficient way to obtain rock and fluid properties of geological patterns specially water resources and hydrocarbon reservoirs. One of the characteristics of geophysical well logs is their complex behavior which seems to imply a multifractal nature.In this study we investigate multifractality and presence of long range correlations in petrophysical well log data such... 

Using microbial electrolysis cells (MEC) for hydrogen production has been considered in recent years. So far, synthetic wastewaters containing substances such as glucose and acetate have been mainly used in MECs and industrial wastewaters have not been widely studied. Food industry wastewater is a suitable choice for application in microbial electrolysis cell due to its biodegradable materials. In present research, dairy wastewater and sludge collected from UASB reactor of Iran Dairy Industries company, Tehran were initially used in a dual chamber microbial fuel cell until a stable voltage was generated .Afterward, the system was converted to a MEC applying a predetermined voltage. The... 

Hi-C is a new technology invented to record the amount of interaction between all chromatin fragments. Chromatin interactions are manifestations of chromatin's 3D structure. It has been proved that different 3D structures of different cell types, despite having the same DNA, causes in different functionalities of cells. Therefore knowing chromatin structure, the factors affecting it and the way it affects cells' behaviors such as gene co-expression, sheds more light on the knowledge about cells and the methods that can change their fates. Finding the causes of diseases, designing more efficient drugs and progressing the conversion of different cell types into each other used for amending... 

Internet is the largest multi-purpose, self-reliant, complex and distributed computer network across the globe. The nodes of this network are placed in every place like homes, offices, military camps, schools and all other locations by utilizing many different communication protocols, media and capacities. Furthermore, by rapid technology development, there are many newly born applications utilizing internet in new ways such as Internet of Things systems. The explosive growth of technology causing accelerated addition of new nodes to the internet, and any new single node may have several new unpatched vulnerabilities. This is a serious issue for managing this vast chaotic configuration and...