Sharif Digital Repository

The optimum design of reinforced concrete cantilever retaining walls subjected to seismic loads is an extremely important challenge in structural and geotechnical engineering, especially in seismic zones. This study proposes an adaptive sperm swarm optimization algorithm (ASSO) for economic design of retaining structure under static and seismic loading. The proposed ASSO algorithm utilizes a time-varying velocity damping factor to provide a fine balance between the explorative and exploitative behavior of the original method. In addition, the new method considers a reasonable velocity limitation to avoid the divergence of the sperm movement. The proposed algorithm is benchmarked with a set... 

Copper(II) efficiently catalyzes the aerobic oxidation of aryl thioacetamides into the corresponding α-keto aryl thioamides in moderate to high yields in the presence of K2CO3 under O 2 atmosphere. This protocol is simple, clean, and generates water as the only byproduct. A mechanism is proposed for the reaction course. © Georg Thieme Verlag Stuttgart  

Efficient synthesis of protected and unprotected chlorohydrins has been achieved by ring opening of epoxides with acetyl/benzoyl chloride and TMSCl using a catalytic amount of ZnO as a reusable catalyst. The applicability of ZnO is further extended by performing the cleavage of the natural product 5,6-epoxysitosterol with acetyl chloride. © 2009 Wiley Periodicals, Inc  

The currently available commercial motion capture systems are constrained by space requirement and thus pose difficulties when used in developing kinematic description of human movements within the existing manufacturing and production cells. The Kinect sensor does not share similar limitations but it is not as accurate. The proposition made in this article is to adopt the Kinect sensor in to facilitate implementation of Health Engineering concepts to industrial environments. This article is an evaluation of the Kinect sensor accuracy when providing three dimensional kinematic data. The sensor is thus utilized to assist in modeling and simulation of worker performance within an industrial... 

Small strain shear modulus, Gmax, is one of the most important parameters for the characterization of the behavior of earth structures subjected to static or dynamic loading conditions. This research presents an experimental laboratory study on the effect of non-plastic fines content and hydraulic hysteresis on the Gmax of unsaturated sandy soils. In this regard, clean Firoozkuh No. 161 silica sand which is classified as poorly graded sand was mixed with different percentages of non-plastic Firoozkuh silt. A set of bender element tests were carried out using two modified triaxial devices. The modifications on these two apparatus were to add HAV ceramic discs for air–water control of... 

This is the first research on the thermal buckling analysis of graphene nanoplatelets reinforced composite (GPLRC) doubly curved open cylindrical micropanel in the framework of numerical-based two-dimensional generalized differential quadrature method (2D-GDQM). Additionally, the small-scale effects are analyzed based on nonlocal strain gradient theory (NSGT). The stresses and strains are obtained using the high-order shear deformable theory (HOSDT). The rule of mixture is employed to obtain varying thermal expansion, and Poisson's ratio, while module of elasticity is computed by modified Halpin-Tsai model. In addition, nonlinear temperature changes along the GPLRC micropanel's thickness... 

An efficient one-pot, three-component synthesis of novel dispiro[oxindole-3,3′-pyrrolidines] by 1,3-dipolar cycloaddition of azomethine ylides, in situ generated by reaction of 1,2-diones with sarcosine and subsequent decarboxylation, with a series of (E)-3-benzylidene-2,3-dihydro- 1H-indol-2-ones is reported. Molecular complexity is generated in only one synthetic step. All reactions proceed with excellent regioselectivity and in good-to-excellent yields. The workup is easy, the reaction times are short, and no catalyst is required. © 2013 Verlag Helvetica Chimica Acta AG, Zürich  

The relative stabilities and noncovalent interactions of the six low-lying energy tautomers of cytosine nucleobase with some biological anions (such as F-, Cl-, and CN-) have been investigated in gas phase by density functional theory (DFT) method in conjunction with 6-311++G (d,p) atomic basis set. Furthermore, to systematically investigate all possible tautomerisms from cytosine induced by proton transfer, we describe a study of structural tautomer interconversion in the gas phase and in a continuum solvent using DFT calculation. We carried out geometrical optimizations with the integral equation formalism of polarizable continuum (IEF-PCM) model to account for the solvent effect, and the... 

Using multiple antennas at the transmit and receive sides of a passive radar brings both the benefits of MIMO radar and passive radar. However one of the obstacles arisen in such configuration is the receive antennas placement in proper positions so that the radar performance is improved. Here we just consider the case of positioning one receiver among multiple illuminators of opportunity. Indeed it is a start for the solution of optimizing the geometry of the multiple receivers in a passive radar  

SbCl3 supported on montmorillonite K-10 is an efficient catalyst for the ring opening of epoxides with aromatic amines under solvent-free conditions and microwave irradiation to give the corresponding b-amino alcohols in high yields with high regioselectivity  

In this paper, we consider an integrated sensing and communication (ISAC) system with wireless power transfer (WPT) where an unmanned aerial vehicle (UAV)-based radar serves a group of energy-limited communication users in addition to its sensing functionality. In this architecture, the radar senses the environment in phase 1 (namely sensing phase) and mean-while, the communications users (nodes) harvest and store the energy from the radar transmit signal. The stored energy is then used for information transmission from the nodes to UAV in phase 2, i.e., uplink phase. Performance of the radar system depends on the transmit signal as well as the receive filter; the energy of the transmit... 

One of the important obstacles in MIMO (Multiple Input Multiple Output) radars is the issue of designing proper transmit signals. Indeed, the capability of signal design is a significant advantage in MIMO radars, through which, the system can achieve much better performance. Many different aspects of this performance improvement have been considered yet, and the transmit signals have been designed to attain such goal, e.g., getting higher SNR or better detector's performance at the receiver. However, an important tool for evaluating the radar's performance is its ambiguity function. In this paper, we consider the problem of transmit signal design, in order to optimize the ambiguity function... 

Two gains play key roles in recently developed MIMO wireless communication systems: "spatial diversity" gain and "spatial multiplexing" gain. The diversity gain refers to the capability to decrease the error rate of the MIMO channel, while the multiplexing gain implicitly refers to the amount of increase in the capacity of the MIMO channel. It has been shown that there is a fundamental tradeoff between these two types of gains, meaning interplay between increasing reliability (via an increase in the diversity gain) and increasing data rate (via an increase in the multiplexing gain). On the other hand, recently, MIMO radars have attracted much attention for their superior ability to enhance... 

It is a well known fact that using multiple antennas at transmit and receive sides improves the detection performance. However, in such multiple-input multiple-output (MIMO) configuration, proper positioning of transmitters and receivers is a big challenge that can have significant influence on the performance of the overall system. In addition, determining the power of each transmitter under a total power constraint is a problem that should be solved in order to enhance the performance and coverage of such a system. In this paper, we design the Neyman-Pearson detector under the Rayleigh scatter model and use it to introduce a criterion for the antenna placement at both transmit and receive... 

There has been much interest, recently, towards exploiting the Multiple-Input Multiple-Output (MIMO) technique in radar. It is shown that using multiple antennas at transmit and receive sides can improve the performance of the system. However, in order to analyze the system's performance, its ambiguity function, i.e. the ambiguity function of a MIMO radar, is needed to be defined. In this paper, beginning from the information theoretic definitions, we derive such function, specifically for a MIMO radar with widely separated antennas  

By combining the two ideas of MIMO (Multiple Input Multiple Output) and PCL (Passive Coherent Location) in radar, one can achieve the advantages of both recently developed techniques simultaneously. While using multiple antennas at the receive side provides a spatial diversity of the object to be detected, using multiple illuminators of opportunity, most importantly, makes the radar covert to the interceptors. One obstacle in such MIMO configuration is choosing the positions of the receive antennas. In this paper, after analyzing the Neyman-Pearson detector for the DVB-T based PCL, we introduce the probability of missed detection as a criterion to place the receive antenna. Here, we only... 

One of the most important obstacles in passive radar applications is removing the direct signal from the target channel. Otherwise, week echoes from the targets in the target channel would be ignored due to the limited dynamic range of the system. One of the most effective techniques in this field is using adaptive filters. In this paper various adaptive filters are introduced and their performances are shown and compared