Sharif Digital Repository

Molybdenum resources around the world are mainly associated with porphyry copper ores. Molybdenite (MoS2) is the main Mo mineral that has rhenium in its crystal lattice. This paper investigates the recovery of rhenium and molybdenum from a molybdenite concentrate using a hydrometallurgical treatment method. The molybdenite concentrate is leached with nitric acid and subjected to solvent extraction to recover and separate rhenium and molybdenum from the leached liquor. The effects of pH and the chemicals' concentration on extraction characteristics of Mo and Re are investigated to define the best condition for selective extraction of these metals. The tested leached liquor contained of 8.2... 

The present research work is based on finding the optimum conditions for pressure oxidative leaching of the molybdenite concentrate to produce technical-grade molybdic oxide (MoO 3) with high recovery through further treatment of the filtrate solution. The Taguchi method was used to design and minimize the number of experiments. By using Taguchi orthogonal (L 25) array, five parameters (time, temperature, oxygen pressure, pulp density and acid concentration) at five levels were selected for 25 experiments. The experiments were designed and carried out in a high-pressure reactor in the presence of nitric acid as solvent and oxidizing agent for the molybdenite concentrate and its ReS 2... 

This study is concerned with investigation of pressure oxidative leaching of entire molybdenum of a molybdenite concentrate. Effects of oxygen pressure, stirring speed, pulp density, acid concentration, and temperature on the leaching rate of molybdenum were studied. A three-layer feed-forward artificial neural network was applied to model the effect of the abovementioned parameters on the leaching ability. The leaching efficiency was considered as a target value for modeling. The quantified leaching efficiencies obtained by applying different parameters demonstrated a good agreement with neural network predictions  

The current study was carried out to investigate the kinetics of reactions for the pressure oxidative leaching of a molybdenite concentrate in less than one hour. The effects of oxygen pressure, stirring speed, pulp density, acid concentration and temperature on the leaching rate of the molybdenum were studied. It was found that about 85% of molybdenite was oxidized to molybdic oxide precipitate with remaining molybdenum dissolved in the leaching liquor. Analysis of experimental data showed that the reaction is chemically controlled with activation energy of 68.8 kJ/mol. Furthermore SEM images showed no significant boundary diffusion layer and it was noted that the molybdic oxide... 

The main goals in zinc electrowinning process are decreasing of power consumption and increasing of current efficiency. The purpose of this research was to investigate effect of different alloy compositions used in production of lead-based anodes on the zinc electrowinning process. The anode compositions prepared and examined in this study were binary alloys Pb - (0.5 and 2 %) Ag and quaternary alloys Pb - 0.5 % Ag - 1 % Ca - 2 % Sn, Pb - 0.5 % Ag - 1 % Ca - 1 % Sn - 1 % Sb and Pb - 0.5 % Ag - 1 % Ca - 1 % Sn - 1 % Bi. The electrowinning experiments were conducted using a laboratory-scale apparatus, at a plating time of 4 hours, a current density of 500 to 1000 A/m2, industrial zinc sulfate... 

Dental professionals are in a unique position to promote smoking cessation among their patients. We evaluated the effects of a brief counselling intervention by a dentist on patients' attitude towards the role of dentists in tobacco cessation programmes. In a semi-experimental study in Tehran, Islamic Republic of Iran, 70 eligible smokers were selected and randomly assigned to intervention and control groups. The initial attitudes of the patients regarding tobacco cessation counselling services provided by the dentist were determined using a validated questionnaire. The intervention group received a brief chair-side counselling by a dentist based on the 5 A's approach, while no intervention... 

Thermal oxidation of commercial ilmenite concentrate from Kahnouj titanium mines, Iran, at 500-950 C was investigated for the first time. Fractional conversion was calculated from mass change of the samples during oxidation. Maximum FeO to Fe2O3 conversion of 98.63 % occurred at 900 C after 120 min. Curve fit trials together with SEM line scan results indicated constant-size shrinking core model as the closest kinetic mechanism of the oxidation process. Below 750 C, chemical reaction with activation energy of 80.65 kJ mol-1 and between 775 and 950 C, ash diffusion with activation energy of 53.50 kJ mol-1 were the prevailing mechanisms. X-ray diffraction patterns approved presence of... 

This paper proposes a class of estimators for population correlation coefficient when information about the population mean and population variance of one of the variables is not available but information about these parameters of another variable (auxiliary) is available, in two phase sampling and analyzes its properties. Optimum estimator in the class is identified with its variance formula. The estimators of the class involve unknown constants whose optimum values depend on unknown population parameters. In earlier research it has been shown that when these population parameters are replaced by their consistent estimates the resulting class of estimators has the same asymptotic variance... 

Using multiple antennas at the transmit and receive sides of a passive radar brings both the benefits of MIMO radar and passive radar. However one of the obstacles arisen in such configuration is the receive antennas placement in proper positions so that the radar performance is improved. Here we just consider the case of positioning one receiver among multiple illuminators of opportunity. Indeed it is a start for the solution of optimizing the geometry of the multiple receivers in a passive radar  

SbCl3 supported on montmorillonite K-10 is an efficient catalyst for the ring opening of epoxides with aromatic amines under solvent-free conditions and microwave irradiation to give the corresponding b-amino alcohols in high yields with high regioselectivity  

In this paper, we consider an integrated sensing and communication (ISAC) system with wireless power transfer (WPT) where an unmanned aerial vehicle (UAV)-based radar serves a group of energy-limited communication users in addition to its sensing functionality. In this architecture, the radar senses the environment in phase 1 (namely sensing phase) and mean-while, the communications users (nodes) harvest and store the energy from the radar transmit signal. The stored energy is then used for information transmission from the nodes to UAV in phase 2, i.e., uplink phase. Performance of the radar system depends on the transmit signal as well as the receive filter; the energy of the transmit... 

One of the important obstacles in MIMO (Multiple Input Multiple Output) radars is the issue of designing proper transmit signals. Indeed, the capability of signal design is a significant advantage in MIMO radars, through which, the system can achieve much better performance. Many different aspects of this performance improvement have been considered yet, and the transmit signals have been designed to attain such goal, e.g., getting higher SNR or better detector's performance at the receiver. However, an important tool for evaluating the radar's performance is its ambiguity function. In this paper, we consider the problem of transmit signal design, in order to optimize the ambiguity function... 

Two gains play key roles in recently developed MIMO wireless communication systems: "spatial diversity" gain and "spatial multiplexing" gain. The diversity gain refers to the capability to decrease the error rate of the MIMO channel, while the multiplexing gain implicitly refers to the amount of increase in the capacity of the MIMO channel. It has been shown that there is a fundamental tradeoff between these two types of gains, meaning interplay between increasing reliability (via an increase in the diversity gain) and increasing data rate (via an increase in the multiplexing gain). On the other hand, recently, MIMO radars have attracted much attention for their superior ability to enhance... 

It is a well known fact that using multiple antennas at transmit and receive sides improves the detection performance. However, in such multiple-input multiple-output (MIMO) configuration, proper positioning of transmitters and receivers is a big challenge that can have significant influence on the performance of the overall system. In addition, determining the power of each transmitter under a total power constraint is a problem that should be solved in order to enhance the performance and coverage of such a system. In this paper, we design the Neyman-Pearson detector under the Rayleigh scatter model and use it to introduce a criterion for the antenna placement at both transmit and receive... 

There has been much interest, recently, towards exploiting the Multiple-Input Multiple-Output (MIMO) technique in radar. It is shown that using multiple antennas at transmit and receive sides can improve the performance of the system. However, in order to analyze the system's performance, its ambiguity function, i.e. the ambiguity function of a MIMO radar, is needed to be defined. In this paper, beginning from the information theoretic definitions, we derive such function, specifically for a MIMO radar with widely separated antennas  

By combining the two ideas of MIMO (Multiple Input Multiple Output) and PCL (Passive Coherent Location) in radar, one can achieve the advantages of both recently developed techniques simultaneously. While using multiple antennas at the receive side provides a spatial diversity of the object to be detected, using multiple illuminators of opportunity, most importantly, makes the radar covert to the interceptors. One obstacle in such MIMO configuration is choosing the positions of the receive antennas. In this paper, after analyzing the Neyman-Pearson detector for the DVB-T based PCL, we introduce the probability of missed detection as a criterion to place the receive antenna. Here, we only... 

One of the most important obstacles in passive radar applications is removing the direct signal from the target channel. Otherwise, week echoes from the targets in the target channel would be ignored due to the limited dynamic range of the system. One of the most effective techniques in this field is using adaptive filters. In this paper various adaptive filters are introduced and their performances are shown and compared  

It has been shown that using multiple antennas in a radar system improves the performance considerably, since multiple target echoes are received from different aspect angles of the target. In this way, the target detection is improved. However, when using multiple antennas, some problems, such as designing the transmit signals, synchronization, etc. emerge that should be solved. One of such problems is the receiver placement. Receiver placement deals with choosing a proper position for the receive antenna in order to optimize the whole system's performance. In this paper, a receiver placement procedure based on improving the radar ambiguity function is proposed for the case of a multisite...