Sharif Digital Repository

An electro membrane extraction (EME) methodology was utilized to study the isolation of some environmentally important pollutants, such as chlorophenols, from aquatic media based upon the electrokinetic migration process. The analytes were transported by application of an electrical potential difference over a supported liquid membrane (SLM). A driving force of 10 V was applied to extract the analytes through 1-octanol, used as the SLM, into a strongly alkaline solution. The alkaline acceptor solution was subsequently analyzed by high performance liquid chromatography-ultraviolet (HPLC-UV) detection. The parameters influencing electromigration, including volumes and pH of the donor and... 

Carbon-doped zinc oxide/reduced graphene oxide (C-ZnO/rGO) was prepared by a facile one-pot supercritical methanol method. The synthesized C-ZnO/rGO nanocomposite with flower-like ZnO micro-rods (MRs) synergistically inherited all the advantages of carbon doping and rGO heterojunction and exhibited high photocatalytic activity for the photodegradation of methyl orange (MO) under visible light. The x-ray diffraction (XRD) results indicated that in presence of GO, a new carbon-doped phase was formed at the high temperature and pressure of supercritical methanol. The x-ray photoelectron spectroscopy (XPS) at low binding energies demonstrated that the valence band of C-ZnO-rGO is up-shifted by... 

Supercritical water was used for simultaneous fragmentation and reduction of graphene oxide (GO) sheets into water-dispersible graphene quantum dots (GQDs) with tunable sizes. Transmission electron microscopy (TEM) demonstrated that by increasing the temperature above the critical point of water, the average size and thickness of the GQDs were decreased and the size uniformity and production yield were increased. The results of thermal conductivity measurement of GQD nanofluids with different weight fractions indicated that the GQDs prepared at supercritical condition could enhance the thermal conductivity of water by 65% as compared to 35% for the GQDs synthesized at sub-critical... 

Hematite is recognized as a promising photoanode for photoelectrochemical water oxidation to produce solar hydrogen due to its favorable properties. However, the high charge carrier recombination rate due to low electrical conductivity and sluggish oxygen reduction kinetics of pure hematite hinder its photocatalytic activity. This work proposed a new hematite-based heterostructure of Ti-Fe2O3/Fe2TiO5/FeOOH, synthesized through a hydrothermal method. The photoanode morphology was branched nanorods that expanded their surface area and improved charge transfer at the photoanode/electrolyte interface. In a novel and complement modification approach, a thin pseudobrookite interlayer was applied... 

Congestion management is one of the most important issues for secure and reliable system operations in deregulated electricity market. This paper presents a cost/worth analysis approach for optimal location and sizing of Distributed Resources (DRs) to mitigate congestion and increase security of the system. In order to reduce the solution space a priority of candidate buses is formed, then optimal location and sizing problem is discussed. To increase the accuracy of results, load duration curve is constituted and based on this curve different load levels are incorporated into this study. Proposed method considers economical factors such as congestion rent, deferred upgrading investment and... 

INTRODUCTION: Phacomatosis pigmentokeratotica (PPK), an epidermal nevus syndrome, is characterized by the coexistence of nevus spilus and nevus sebaceus. Within the nevus spilus, an extensive range of atypical nevi of different morphologies may manifest. Pigmented lesions may fulfill the ABCDE criteria for melanoma, which may prompt a physician to perform a full-thickness biopsy. MOTIVATION: Excisions result in pain, mental distress, and physical disfigurement. For patients with a significant number of nevi with morphologic atypia, it may not be physically feasible to biopsy a large number of lesions. Optical coherence tomography (OCT) is a non-invasive imaging modality that may be used to... 

We report on charge transport across self-assembled monolayers (SAMs) of short tau peptides by probing the electron tunneling rates and quantum mechanical simulation. We measured the electron tunneling rates across SAMs of carboxyl-terminated linker molecules (C6H12O2S) and short cis-tau (CT) and trans-tau (TT) peptides, supported on template-stripped gold (AuTS) bottom electrode, with Eutectic Gallium-Indium (EGaIn)(EGaIn) top electrode. Measurements of the current density across thousands of AuTS/linker/tau//Ga2O3/EGaIn single-molecule junctions show that the tunneling current across CT peptide is one order of magnitude lower than that of TT peptide. Quantum mechanical simulation... 

Organ-on-a-chip (OOC) systems are engineered nanobiosystems to mimic the physiochemical environment of a specific organ in the body. Among various components of OOC systems, biomimetic membranes have been regarded as one of the most important key components to develop controllable biomimetic bioanalysis systems. Here, we review the preparation and characterization of biomimetic membranes in comparison with the features of the extracellular matrix. After that, we review and discuss the latest applications of engineered biomimetic membranes to fabricate various organs on a chip, such as liver, kidney, intestine, lung, skin, heart, vasculature and blood vessels, brain, and multiorgans with... 

Multi-walled carbon nanotubes (MWCNTs) are one of the preferred candidates for reinforcing polymeric nanobiocomposites, such as acrylic bone type of cement. In this study, at first, bulk samples of the reinforced polymethylmethacrylate (PMMA) matrix were prepared with 0.1, 0.25, and 0.5 wt per wt% of MWCNTs by the casting method. Tensile and three-point bending tests were performed to determine the essential mechanical properties of bone cement, such as tensile and bending strengths. The tensile fracture surfaces were investigated by scanning electron microscopy (SEM). The commercial software (Abaqus) was used to conduct finite element analysis (FEA) by constructing a representative volume... 

The effects of the current density on the microstructure and the corrosion property of the coating on AZ31 Mg alloy processed by the plasma electrolytic oxidation (PEO) were investigated. The present coatings were produced in an acid electrolyte containing K2ZrF6 with three different current densities, i.e., 100, 150, and 200 mA/cm2. From the microstructural observations, as the applied current density was increased, the diameter of micro-pores formed by the plasma discharges with high temperature increased. The coatings on AZ31 Mg alloy were mainly composed of MgO, ZrO 2, MgF2, and Mg2Zr5O12 phases. The results of potentiodynamic polarization clearly showed that the PEO-treated AZ31 Mg... 

The burning of fossil fuels such as gasoline, coal, oil, natural gas in combustion reactions results in the production of carbon dioxide. The phase behavior of the carbon dioxide + water system is complex topic. Unlike methane, CO2 exhibits a minimum in the water content. These minima cannot be predicted by existing methods accurately. In this communication, two mathematical-based procedures have been proposed for accurate computation of CO2 water content for tempe-ratures between 273.15 and 348.15 K and the pressure range between 0.5 and 21 MPa. The first is based on least squares support vector machine (LSSVM) algorithm and the second applies multilayer perceptron (MLP) artificial neural... 

For elastic scattering of 133Cs atoms by 85Rb and 87Rb atoms, interacting via the X 1Σ+ and a 3Σ+ molecular states of RbCs, calculations are presented of the scattering length and the effective range and also of two volume parameters, one for low energy p-wave scattering and one for the energy of an ensemble of fermions. The calculations are performed by various methods, with several representations of the interatomic potentials, including new ab initio potentials presented here. It is shown how the calculated data may be corrected to include the influence of the long range interactions, thus removing the need for numerical solutions of the radial Schrödinger equation at very large... 

Normal basis multiplication in finite fields is vastly utilized in different applications, including error control coding and the like due to its advantageous characteristics and the fact that squaring of elements can be obtained without hardware complexity. In this brief, we present decomposition algorithms to develop novel systolic structures for digit-level Gaussian normal basis multiplication over GF (2m). The proposed architectures are suitable for high-performance applications, which require fast computations in finite fields with high throughputs. We also present the results of our application-specific integrated circuit synthesis using a 65-nm standard-cell library to benchmark the... 

Cell separation is a key step in many biomedical research areas including biotechnology, cancer research, regenerative medicine, and drug discovery. While conventional cell sorting approaches have led to high-efficiency sorting by exploiting the cell's specific properties, microfluidics has shown great promise in cell separation by exploiting different physical principles and using different properties of the cells. In particular, label-free cell separation techniques are highly recommended to minimize cell damage and avoid costly and labor-intensive steps of labeling molecular signatures of cells. In general, microfluidic-based cell sorting approaches can separate cells using “intrinsic”... 

Optical tweezers provide an accurate measurement technique for evaluating mechanical properties of the living cells and many experimental studies have been done to understand the behavior of cells due to external forces. Numerical studies such as finite element methods have been used in order to simulate mechanical behavior of the Red Blood Cells (RBCs). Recent studies have shown that the particle methods are useful tools to simulate the mechanical behavior of living cells. Since in microscopic scales, using discrete models are preferred than continuum methods, a particle-based method is used to simulate the deformation of RBC which is stretched by optical tweezers. The cytoplasm of RBC is... 

Although demand responsive feeder bus operation is possible with human-driven vehicles, it has not been very popular and is mostly available as a special service because of its high operating costs due to intensive labor costs as well as requirement for advanced real-time information technology and complicated operation. However, once automated vehicles become available, small-sized flexible door-to-door feeder bus operation will become more realistic, so preparing for such automated flexible feeder services is necessary to take advantage of the rapid improvement of automated vehicle technology. Therefore, in this research, an algorithm for optimal flexible feeder bus routing, which... 

Governments in developing countries have invested in institutions of higher learning in order to develop homegrown, high technology products. Among these, the National University of Malaysia (Universiti Kebangsaan Malaysia), recognized as a Research University, is actively involved in projects related to medical technology through its various faculties. The net result of these activities is impressing from the point of view of patents and publications, but unfortunately not yet in terms of commercialization. This paper starts by presenting the main obstacles towards the objective of bringing a laboratory prototype to the market in the context of Malaysia. Then, a framework is presented... 

We report the discovery of a cold Super-Earth planet (mp = 4.4 ± 0.5 M) orbiting a lowmass (M = 0.23 ± 0.03 M) M dwarf at projected separation a = 1.18 ± 0.10 a.u., i.e., about 1.9 times the distance the snow line. The system is quite nearby for a microlensing planet, DL = 0.86 ± 0.09 kpc. Indeed, it was the large lens-source relative parallax πrel = 1.0 mas (combined with the low mass M) that gave rise to the large, and thus well-measured, "microlens parallax πE ∞ (πrel/M)1/2 that enabled these precise measurements. OGLE-2017-BLG-1434Lb is the eighth microlensing planet with planet-host mass ratio q < 1×10-4. We apply a new planet-detection sensitivity method, which is a variant of "V/Vmax,... 

Inherently safer design is the new approach to maximize the overall safety of a process plant. This approach suggests some risk reduction strategies to be implemented in the early stages of design. In this paper a multi-objective optimization was performed considering economic, exergetic, and environmental aspects besides evaluation of the inherent safety level of a cascade refrigeration system. The capital costs, the processing costs, and the social cost due to CO2 emission were considered to be included in the economic objective function. Exergetic efficiency of the plant was considered as the second objective function. As a measure of inherent safety level, Quantitative Risk Assessment... 

In order to optimize the aging treatment of Mg-1.8Zn-0.7Si-0.4Ca alloy, different times and temperatures of solid solution and age hardening were applied to the alloy specimens. Microstructures and mechanical properties of the specimens were investigated using the optical microscopy, field emission scanning electron microscopy equipped with an energy dispersive x-ray spectrometer, x-ray diffraction, hardness, and shear punch tests. The lowest hardness and strength were achieved by solution treating of the alloy at 500 °C for 8 h, presenting the optimal condition for solution treatment of the alloy. The microstructural examinations revealed three different precipitates consisting of CaMgSi,...