Sharif Digital Repository

Detectivity optimization of large-area freestanding-type YBCO superconducting bolometric detectors is theoretically and experimentally investigated. The effect of the device thermal parameters on the theoretical total noise-equivalent power based on background radiation, thermal fluctuation, and Johnson noise is considered. By analytical optimization of the total noise-equivalent power (NEP) of the device with respect to the thermal parameters and radiation modulation frequency, the maximum sensitivity and optimal thermal parameters of the bolometric detector are obtained. Relating device thermal parameters to the special case of the large substrate dimensions, the optimum device geometry is... 

The effect of substrate thickness and its Debye temperature on the bolometric response of the freestanding-membrane type of superconductor transition-edge detectors is investigated. The investigation is based on the calculation of the variation of the specific heat per unit volume and the heat conductivity using the finite-size scaling method for different Debye temperatures and micron size thickness of substrate. We also calculated the heat capacity and time constant for various materials with Debye temperatures in the range of 600-1400 K. The calculated results are compared with previously reported response values obtained theoretically and experimentally for the thermal-based infrared... 

The infrared range optical absorption mechanism of carbon-copper composite thin layer coated on the diamond-like carbon buffer layer has been investigated. By consideration of weak interactions between copper nanoparticles in their network, optical absorption is modelled using their coherent dipole behaviour induced by the electromagnetic radiation. The copper nanoparticles in the bulk of carbon are assumed as a chain of plasmonic dipoles, which have coupling resonance. Considering nearest neighbour interactions for this metallic nanoparticles, surface plasmon resonance frequency (ω 0) and coupled plasmon resonance frequency (ω 1) have been computed. The damping rate against wavelength is... 

A terahertz modulator based on the Type-II superconductor flux flow oscillator has been proposed. Analytical calculations are presented and the effects of intrinsic and extrinsic parameters such as disorder strength of crystal, penetration depth, frequency, and amplitude of the modulated current on the radiation power spectrum have been studied. The proposed structure also exhibits a mixer-like behavior, in the sense that its output harmonics range from the washboard frequency up to the superconductor gap frequency, so the input signal is practically mixed with the washboard frequency and its harmonics. The modulation index for each harmonic of this modulator has also been investigated. This... 

In this work, we have investigated and presented the bolometric response of freestanding membrane type of superconductive transition-edge detectors at micro-scale and submicron-scale substrate thicknesses. The technique applied here is based on the finite-size scaling method which is now extensively used for the calculation of thermal parameters of materials at low dimensions when the significance of surface energy contribution is not negligible compared to that of the total bulk energy. This method is used to evaluate the variation of specific heat per unit volume and heat conductivity and hence its effect on the total heat capacitance and conductance of the substrate versus its thickness.... 

We present a new approach for analytical modeling and calculating the response of high-Tc superconductive transition edge sensors in a wide range of modulation frequencies for different configurations of the film patterns. The method used here is based on solving the heat transfer differential equation for two different time varying heat sources, which are related to the absorbed radiated power. The used method employs two-dimensional boundary conditions for describing meander-line patterned devices. The results from the applied method are in better agreement with those obtained from the frequency response measurements of the characterized samples, than the previously developed models. In... 

Bolometric response and noise characteristics of YBCO superconductor transition edge IR detectors with relatively sharp transition and its resulting detectivity are investigated both theoretically and experimentally. The magnitude of response of a fabricated device was obtained for different bias currents and modulation frequencies. Using the measured and calculated bolometric response and noise characteristics, we found and analyzed the device detectivity versus frequency for different bias currents. The detectivity versus chopping frequency of the device did not decrease following the response strongly, due to the decrease of the noise at higher frequencies up to 1 kHz, resulting in... 

Bolometric response and noise characteristics of YBCO superconductor transition edge IR detectors with relatively sharp transition and its resulting detectivity are investigated both theoretically and experimentally. The magnitude of response of a fabricated device was obtained for different bias currents and modulation frequencies. Also dependency of intrinsic noise of the device on the bias current in the vicinity of critical temperature was studied for various values of chopping frequencies. Using the measured and calculated bolometric response and noise characteristics, we found and analyzed the device detectivity versus frequency for different bias currents. The detectivity versus... 

Local educational institutions produce in-house English for Specific Purpose (ESP) materials according to the curriculum policies designated and developed by the Ministry of Higher Education In Iran. To this end, this book aims to be used in the Iranian setting at the tertiary level for undergraduate students majoring in Mechanical Engineering. Moreover, the style of English usage in this ESP textbook is American.
Regarding the content of the textbook, it has both thematic organizations in which the topics are relevant and includes sufficient treatment of the target language areas necessary for the students. The principle organizing approach of this textbook is theme-based. In addition,... 

The aim of this study is to employ feedback control loops to provide a stable forward dynamics simulation of human movement under repeated position constraint conditions in the environment, particularly during stair climbing. A ten-degrees-of-freedom skeletal model containing 18 Hill-type musculotendon actuators per leg was employed to simulate the model in the sagittal plane. The postural tracking and obstacle avoidance were provided by the proportional—integral—derivative controller according to the modulation of the time rate change of the joint kinematics. The stability of the model was maintained by controlling the velocity of the body's centre of mass according to the desired centre of... 

A combination of silica chloride and wet SiO2 was used as an effective deacetalizating agent for the conversion of acetals to their corresponding carbonyl derivatives under mild and heterogeneous condition  

Free Content Selective synthesis of conjugated enynes from α-arylalkynols using LiCl-Acidic Al2O3 under solvent-free conditions  

7H-benzimidazo[2,1-a]benz[de]isoquinolin-7-one compounds were prepared in a selective manner by reaction between o-phenylenediamines and appropriate 1,8-naphthalenedicarboxylic anhydrides using acidic alumina under microwave irradiation