Sharif Digital Repository

In this study, SiC/Ti–Cu nanocomposite was fabricated by mechanical alloying and sintering process. Effects of SiC nano-reinforcement on phase transformation, microstructure and tribological and antibacterial properties Ti–Cu intermetallic alloy were studied. The microstructure of the powders and sintered materials was investigated using X-ray diffraction, and scanning/transmission electron microscopy. The results exhibited the formation of major TiCu and TiCu 4 , and minor Ti 2 Cu and Ti 2 Cu 3 nanocrystalline phases in the sintered Ti–Cu and SiC/Ti–Cu samples. With the addition of the nanoparticles, the amount of TiCu 4 phase increased. Reinforcing Ti–Cu intermetallic alloy by SiC... 

The demands for high-performance biomaterials are driving the development of new metallic alloys with improved mechanical and biological responses. In this study, a nanocrystalline Ti-Cu intermetallic alloy was prepared by a powder metallurgy route, and its application as an orthopedic material was evaluated by the microstructural, mechanical, corrosion, antibacterial, cytotoxicity and osseointegration examinations. Microstructural characterization revealed the formation of TiCu and Ti2Cu3 as major phases with 23 nm grain size in the structure of the alloy. The synthesized alloy exhibited ultra-high hardness of 10 GPa, acceptable toughness of 8.14 MPam1/2, a ∼98 % anti-bacterial rate against... 

Effects of SiC nanoparticles addition on synthesis and antibacterial properties of TiCu nanocrystalline powder prepared through high energy mechanical milling were studied. The results showed that the synthesis of TiCu powder in the presence of the nanoparticles was accelerated and after mechanical alloying for 20 h, a TiCu/SiC nanocrystalline powder with the crystallite size <5 nm, and 3.3% lattice micro-strain obtained. Further milling resulted in fully amorphous TiCu intermetallic alloy with more uniform distribution of SiC nanoparticles. The antibacterial activity of the synthesized powders was investigated by disk diffusion test. The TiCu/SiC nanocomposites showed enhanced antibacterial... 

In this paper, ultra-small CuO nanoparticles (NPs) were synthesized through a mechanochemical method using two different Cu-containing precursors (i.e. CuSO4·5H2O and CuCl2·2H2O), and their structure and antibacterial activity were studied. From the microstructural studies, it was observed that CuO NPs have a spherical morphology and a narrow size distribution with 7 and 14 nm median particle sizes for CuCl2·2H2O and CuSO4.5H2O precursors, respectively. The CuCl2·2H2O derived nanoparticles showed more antibacterial activity than CuSO4.5H2O derived nanoparticles. The minimum inhibitory concentration (MIC) of the synthesized nanoparticles (derived from both precursors) against E. coli and... 

HF radar systems are widely used for the measurement of ocean surface currents and wave parameters. Theoretical analysis of high frequency radio wave backscattering from the sea has been derived in the past. Also, the relationship between Bragg frequencies and surface currents is determined and has been proved by HF radars. It is known that when surface currents are present, the Bragg frequencies move to new frequencies. Their movement is proportional to the surface current in the direction toward radar. In addition, it is observed that sea surface current changes the second order part of the spectrum of radar reflection from the sea surface. In this paper, a theoretical analysis of... 

This study focused on the synthesis of TiO2-Zeolite nanocomposite through a sol-gel approach. The decrease in the size of the nanocomposite is considered a primary parameter to improve photocatalytic activity. In this regard, fabricated samples were exposed to laser irradiation (532 nm) for four different time intervals in order to investigate the size variation of the nanocomposite. FTIR, UV-Vis, XRD, DLS, SEM and EDX analyses were applied to characterize and determine the size of the products. An optimized nanocomposite sample, in term of the particle size, was used for photodegradation of 2,4-D herbicide from aqueous solution. Photodegradation was carried out under UV irradiation (12 W)... 

In this research, carbon nanotube decorated with Cu nanoparticles (CNT/Cu) was synthesized by a new solvothermal process. Solvothermal treatment of CuSO4 and NaOH was completed in ethanol containing ultrasonically dispersed CNTs at 160 °C for 3 h. In the solvothermal process, Cu nanoparticles were heterogeneously deposited on the surface of COOH-functionalized CNTs through the reduction of the Cu+2 ions. Cu nanoparticles with the size of ≈8 nm on CNTs (and some in the solution) and strong bonding between Cu and CNT were obtained by the used process. Microstructural characterization revealed that the solvothermal method is an appropriate method for producing homogenous CNT/Cu nanostructure.... 

In this research, Linear Amplitude Sweep (LAS) test was conducted on several asphalt binders modified by different percentages of gilsonite and Styrene-Butadiene-Styrene (SBS) polymer. Asphalt mixtures were also made from some of the study binders and tested for fatigue resistance using Four-point Bending Beam (FBB) fatigue test. The results showed that a strong correlation exists between LAS and FBB rankings at all the tested strain levels. Also, SHRP binder fatigue index (G∗sinδ), as a traditional binder fatigue index, was evaluated which did not show a strong correlation with either LAS or FBB tests. It was concluded that LAS test seems to be an effective binder fatigue test in predicting... 

This paper considers the Gaussian multichannel binary detection problem. A multichannel generalized likelihood ratio (GLR) is presented using a model-based approach where the signal and its amplitude are known and additive noise is characterized by autoregressive (AR) vector processes which can be a suitable model for ground clutter in most scenarios involving airborne surveillance phased array radar. The detector can use secondary vectors to improve its performance. Although, in our model, the amplitude of signal must be known, but according to its excellent performance, an approximation of GLR on the amplitude is also presented. The detector performance in various conditions and the result... 

Learning a foreign language encompasses a process of trial and error that can lead to the progression of the learner's interlanguage, meaning that the learners make use of their language knowledge that receives feedback and brings about progress through diagnosis of the problems and being corrected by the teacher. Therefore, there exists a need to analyze the underlying reasons causing the students to remain taciturn with a low willingness to communicate (WTC) during a language class. There has been much work done investigating the role of the learner's stable personal characteristics (traits) along with their situational changes at a specific time (states) that influence the student's... 

Using 3-D scanned data to analyze and extract pore network plays a vital role in investigation of porous media's characteristics. In this paper, a new simple method is developed to detect pores and throats for analyzing the connectivity and permeability of the network. This automated method utilizes some of the common and well-known image processing functions which are widely accessible by researchers and this has led to an easy algorithm implementation. In this method, after polishing and quality control of images, using city-block distance function and watershed segmentation algorithm, pores and throats are detected and 3-D network is produced. This method can also be applied on 2-D images... 

In this paper, we try to recognize and distinguish different groups of arrhythmia using novel features which have been obtained from the heart rate's phase space in recent years. For this purpose, we used Triangular Phase Space Mapping (TPSM) and Parabolic Phase Space Mapping (PPSM). For recognition, we used three groups of 15 subjects using the Physionet database (Arrhythmia, Congestive Heart Failure (CHF), and Atrial Fibrillation (AF)) with Normal Sinus Rhythm (NSR). The obtained features discriminate arrhythmia from NSR by p