Sharif Digital Repository

The purpose of this Thesis is designing and constructing of high voltage power supply with very low ripple. Proposed method of this thesis is formed of two sections. In this proposed structure, in first section, structure is on basis of diodes rectifier that has been used for producing main portion of output load energy. Second section uses with aim of regulating of first stage voltage. In attention to existence of noises and available offsets in different sections of proposed circuits, model is basis of two stages structure. Sampling of output voltage by using of resistance divider for main loop of circuit has been done. So noises and offsets available in circuit act as prevented factor... 

The ultra-narrow pulse generator have being used for direct production of pulsed power. One of these structures is being used to make a bipolar pulse and its main feature is the utilization of the real transmission lines (not PFN) with an intricate structure that caused volume to be compressed. It is desired to reach an appropriate design by analyzing the output waveform and its relation to the transmission line parameters. A little piece of work has been done in the past but there were some differences from our anticipations in the waveforms, like pre-pulse, long rise and fall times and overshoot that caused by some non-idealities in the structure. What we have done in this project is to... 

Power Inverter or DC to AC voltage converter is one of the most important and widely discussed topics in the world of power electronics and systems such as DC/DC converters. Increasing the switching frequency of the inverter, in addition to its many advantages, also creates challenges that will be addressed in this dissertation. To build a high frequency yet reliable inverter, you need accurate and comprehensive information about the inverter circuitry, parasitic elements, switches and their behavior against fault conditions such as short circuit, protection requirements and etc.In this dissertation, several MOSFET transistors is shorted under various test conditions while parameters... 

The TWT is highly sensitive to the ripple amplitude of its power supply output voltage. If the amplitude of the output voltage's ripple exceeds a certain limit, the amplitude of the undesired harmonics in the power spectrum of the TWT is greatly increased. Increasing the amplitude of undesired harmonics in the TWT output power spectrum reduces the accuracy and performance of the TWT. Therefore, for optimum TWT performance, a low-ripple power supply is essential. Typically, a low-frequency rectifier or high-frequency switching structure is used to build a high-voltage DC power supply. In this thesis, the different structures of high voltage DC power supplies are studied. Next, by focusing on... 

Mostly, the high voltage DC power supplies have output voltage ripple. In such an applications like power supply of microwave lamps in radar systems, low output voltage ripple is an important point of operational characteristics. On the other hand, measuring the low voltage ripple will be a challenge that can lead to recognize of its reasons and reduce its amplitude. In this thesis, different ways of ripple measurement constraints is described, then a method based on high pass filters for output voltage ripple measurement is implemented. The impact of components tolerance and their parasitic components like shunt parasitic resistance of a capacitor in filter operational characteristics is... 

In present thesis, the effect of cosmological constant, Λ, in bending of light by spherical symmetric mass has been studied. At first we obtain the Schwarzschild-de Sitter solution as spherical symmetric solution of General relativity field equations with cosmological constant, without we suppose the solution is static. Then we obtain gravitational lens equation by considering the space geometry and we benefited from several approach to specify the contribution of cosmological constant to the deflection angle. Furthermore we put new upper bounds on the value of the lambda independently of cosmological constraints. Finally for study the contribution of lambda in gravitational lensing... 

Planning safe rendezvous and docking trajectories between two spacecrafts has a high importance in the space applications. In order to make two spacecrafts moving in different orbits closer, two stages must be completed simultaneously: First the implementation of rendezvous maneuver which deals with the generation of control/guidance commands leading to trajectories that lead the chaser towards the target. Second the docking maneuver incorporation which makes the two spacecrafts closer with the relative zero attitude. Various approaches have been dealt with till now using the analytical and numerical approaches generally considering rendezvous, not the docking maneuver. These approaches... 

Today, the global environmental restrictions as well as; energy problems have directed researchers toward developing ideas of producing a clean liquid fuel from coal or natural gas as a major research topic. In this regard, a special attention is paid to the dimethyl ether (DME) as a clean material containing 34.8% oxygen possessing enough positive potential to replace the diesel and LPG fuels. One of the most economic routes for producing the DME is known to be the direct conversion of the synthesis gases and carbon dioxide first to the methanol and then its dehydration to the DME. Moreover, the DME is not limited to a particular country or resource area since small reservoirs of natural... 

In recent years, ability of computers to recognize human actions, because of numerousapplications, has attracted scientists. Surveillancesystems in house, work and public places, human computer interaction, study of human movement problems, remote supervision of ill or old people and sport training are only some of the applications. In this thesis 10 actions are considered. These actions are Walking, Running, Galloping side, Bending, Jump jacking, Jumping, Jumping in place, Skipping, Waving one hand and Waving two hands. All actions exist in Weisemann dataset so this dataset is used as training and testing dataset. Here important objectives are recognising human action so that it is... 

We have tried this for the first time to reperesent a comprehensive description of the evolution of a perfect fluid in inhomogeneous relativistic models.We solve Einstein equations using numerical methods.In this procedure we can evaluate the effect of pressure in perfect fluid evolution.Also we look at the behavior of the various horizons, and in the end we will present a cosmological model to a black hole  

Knowledge about travel demand patterns is an important requirement for strategic planning and management of urban transportation networks. Use of theoretical trip distribution models such as growth, gravity or intervening opportunities, estimation with the help of questionnaire surveys and development of volume- based O-D estimation methods have been major fields of scientific efforts in recent years.Rapid changes in land use and transportation networks especially in developing countries has raised the importance level of knowledge about changes in travel demand.Traditional approaches are costly, time consuming and suffer from inaccuracies, so,... 

The running time of almost every algorithm in the graph theory depend on the number of edges. Thus, these algorithms are often too slow when the input graphs are dense. Therefore, it is useful to reduce the number of edges by sparsification. In fact, sparsification is the task of approximating a graph G = (V;E) by another graph ~G = (V; ~E) so that ~E E (j~Ej jEj) and ~G maintain a main prefixed property of G. Depending on these properties several notions of graph sparsification have been proposed. In this thesis we study a notion of sparsification that is called spectral sparsification which is based on the contributions of Daniel A. Spielman et.al..In this notion of sparsification... 

Nanocrystalline metals and alloys have some appealing characteristics with significance potential compared to their microcrystalline counterparts for engineering applications. These include ultra-high yield and fracture strengths, decreased elongation and toughness, superior wear resistance, and the promise of enhanced superplastic formability at lower temperatures and faster strain rates. This leads us to study the effects of different nanocrystalline parameters on crack propagation process in these materials. In the present study, the behavior of a crack in a columnar nanocrystalline structure is examined. One of the methods of modelling nanocrystals primary structures is the Voronoi...