Sharif Digital Repository

A control strategy for islanded (autonomous) operation of a microgrid consisting of two Distributed Generation (DG) units is proposed in this thesis. The DG units are connected together in a radial configuration. Each DG unit utilizes a voltage-sourced converter (VSC) to interface to its dedicated load. The DG units and the loads are to operate in the islanded mode of operation. To provide autonomous operation for the microgrid, voltage and frequency of the loads should be regulated. The proposed control strategy utilizes (i) an internal oscillator for frequency control in an open loop manner and (ii) a decentralized servomechanism controller to regulate the load voltage. The microgrid is... 

The sun, as the world's largest source of energy, had always affected various aspects of human life. Several studies on the use of solar energy in various forms have been reported. Parabolic trough solar collectors are one of the most common ways to use solar thermal energy. Many investigations have been carried out on the study of various parameters of this system and their effect on the efficiency. In this study, a detailed numerical study on the impact of thermo-physical properties of the heat transfer fluid on the system efficiency have been performed and the fluid have been optimized. Parabolic trough solar collector is modelled by dividing the structure of the device into three layers:... 

Process optimization is a technique by which the plant operating condition is obtained such that a specific objective is achieved while the other process requirements are still met. These requirements can include product quality specifications, physical equipment limitations, and the constraints corresponding to the environmental, health, and safety issues. Frequently, this objective is an economic one. In the process optimization, the use of improper optimization techniques may lead to impractical results. One of these strategies is the plant wide optimization. In order to show the effect of plant wide optimization, one should use a complicated enough process as a bench mark of the... 

In this thesis, using superstructure concept, a method is presented to synthesize of new structures for thermal desalination processes along with their structural and operational optimization. The proposed superstructure is capable of producing various common (feed forward, backward, parallel cross feed) and non-common structures in evaporators, as well as in combination with flash stages and thermal vapor compressor. By using the GA (Genetic algorithm), the superstructure has been optimized to identify the optimal structures in both Iranian and international economic scales. Also comparisons were made between conventional structures at optimum state, to suggest superior structures at... 

One of the fundamental steps in drug discovery and development is predicting the binding affinity of the drug to target proteins. Due to the high costs, slow pace, and lack of structural data in experimental approaches, several machine learning and deep learning-based methods have been proposed to date. Machine learning-based methods, which have shown high prediction capabilities, require precise engineering and selection of a wide range of physicochemical, biological, and structural information about proteins and drugs. On the other hand, deep neural network-based methods require the design of numerous complex networks for automatic feature extraction. Therefore, a method that can utilize... 

Since steady state behavior of a plant is affected by the change of various inputs to the plant, the transient behavior of the chemical plants are also very important in their general performance. On the other hand, catalytic hydrotreating is one of the most important processes in crude oil refining process in many aspects such as economical, technical and environmental. Thus, the goal of this project was dynamic simulation and control of catalytic hydrotreating unit (UNIFINER Unit) of Tehran Refinery with using the HYSYS software. To fulfill this target, data that were necessary for simulation were gathered from Unifiner unit of Tehran refinery at first. Then, steady state simulation of the... 

In control engineering we want to set dynamic behavior of the system to a desired one and having a model that simulate systems behavior is necessary . System identification is a branch of chemical engineering that provide us this model , which divided into different branches itself . In this project we use object oriented programming to design and implement a software that support black box models such as Neural networks in addition to Mechanistic models (Which was implemented in previous project ) for identification . We use UML and C++ language in C++ Borland Builder in this project  

The gradual exhaustion of oil and gas resources and the various problems involved in their pollution makes it necessary to promote a renewable energy system. One of the most interesting developments of standalone systems based on the utilization of hydrogen is solar hydrogen system. Central and southern Iran exhibit an excellent solar climate which makes them ideal places for solar hydrogen systems. The economy of Iran is based on oil and it has one of the largest reserves of oil and gas in the world but the reserves would not be enough to meet the domestic and export markets starting in three to four decades. Moreover, elimination of energy subsidies in Iran, will led to more tendencies to... 

In this thesis a general model for simulation of solar cooler for domestic usage is developed. The model consists of 2 main parts: thermo-dynamical and economical calculations. The thermodynamic part consists of 4 sub models: a model for calculation of incoming solar radiation, cooling load demand calculation, the refrigeration cycle and the solar cycle with heat storage.As for hourly calculation of system performance part of the model produces the hourly received radiation data based on geographical position and orientation of the receiving surface. Base on results of the cooling load calculation for a 9 m2 studying room located in western part of Tehran, 1 TBR (3.516 kW) is chosen as... 

Traditionally, chemical Process design is focused on the selection of technologies and optimization based on economic consideration .In the 1970’s because of the global energy crisis, other consideration consider with economic goals .in this study we are eager to provide design procedures and guidance for optimizing chemical processes simultaneously based on economic and environmental aspects .this optimization is applied to production maleic anhydride(MA) from n-butane feedstock .an optimization algorithm based on the genetic algorithm with four decision variables(recycle flow ratio ,air to feed ratio ,solvent flow and reactor temperature ).for including dynamic objective in optimization... 

Focusing on fossil fuel to secure energy demand lead to big challenges. Hydrogen as alternative for fossil fuel has attracted a lot of attentions. Fuel cell with an electrochemical reaction which it’s byproducts are water and heat convert Hydrogen into electricity. High efficiency and low environmental pollution, persuade many researchers toward fuel cell commercialization. But problems such as high cost, high power oscillation and inertia, avoid fuel cell from significant development. One way to deal with these problems is using the fuel cell and battery hybrid system. In recent decade too many research has been made in utilizing this hybrid system in transportation. This project... 

Application of the advanced control techniques and information technology in the biomedical engineering have been the focal point of the research communities in biomedical engineering due to the rapid growth of the nonlinear control theories along with the computer hardware. In this work the application of differential geometry and globally linearizing control has been applied to efficiently control the first phase of HIV disease based on the HIV infection model proposed in the literature. All the efforts have been in the way to obtain a suitable scenario of drug administration to suppress and control the infection. In the proposed scenario, drug administration is time dependant and... 

Inappropriate effects of fossil fuels and conventional power generation systems on the environment have necessitated a sustainable energy system for the next decade by growing interests in renewable energy systems. The world’s most fast-growing renewable energy resource is the wind energy. The main problem of wind power is the power fluctuations at the load side caused by the variable nature of wind speed, and the main issue in case of remote locations is the long-term storage of power generated by wind turbines. Batteries can be used to store a limited amount of energy for a short time. Although new advances in this field have been achieved, most common type of batteries is hardly able to... 

Fuel cells are a reliable technology for electrical power generation, widely regarded as a promising alternative for stationary and mobile applications. In order to supply vehicle required power, fuel cell must possess suitable transient response. In this work, a mathematical zero dimensional control-oriented model for a PEM fuel cell stack is developed. Afterwards, to increase the efficiency, four parameters including cathode air inlet flow rate, return manifold cross section area, anode hydrogen inlet flow rate and hydrogen humidity are optimized in different vehicle current demand. Also, in order to decrease water production inside the fuel cell membrane, considered parameters are... 

increasing energy demand and emission of environmental pollutant as a result of using fossil fuels and increase in waste generated due to human activities resulted in considering this source as a partial substitute for fossil resources in power application . Hence in this project biomass is considered as source of energy for heat and power application. Having low quality energy is the most important difficulty for application this resource as an energy carrier, so, gasification is applied to convert this source to gas with higher quality one. Produced gas in gasification enters to a micro turbine to meet thermal and electrical demand of the Sharif energy research institute. To investigate...