Sharif Digital Repository

In the present work, the multiscale finite volume (MsFV) method is implemented on a new coarse grids arrangement. Like grids used in the MsFV methods, the new grid arrangement consists of both coarse and dual coarse grids but here each coarse block in the MsFV method is a dual coarse block and vice versa. Due to using the altered coarse grids, implementation, computational cost, and the reconstruction step differ from the original version of MsFV method. Two reconstruction procedures are proposed and their performances are compared with each other. For a wide range of 2-D and 3-D problem sizes and coarsening ratios, the computational costs of the MsFV methods are investigated. Furthermore, a... 

This paper presents an extension of the multiscale finite volume (MsFV) method to multi-resolution coarse grid solvers for single phase incompressible flows. To achieve this, a grid one level coarser than the coarse grids used in the MsFV method is constructed and the local problems are redefined to compute the basis and correction functions associated with this new grid. To construct the coarse-scale pressure equations, the coarse-scale transmissibility coefficients are calculated using a new multi-point flux approximation (MPFA) method. The estimated coarse-scale pressures are utilized to compute the multiscale pressure solution. Finally a reconstruction step is performed to produce a... 

The condition known as a water-hammer problem is a transient condition that may occur as a result of worst-case loadings, such as pump failures, valve closures, etc. in pipeline systems. The pressure in the water hammer can vary in such a way that in some cases it may increase and cause destruction to the hydraulic systems. The pressure in the water hammer can also be decreased to the extent that it can fall under the saturation pressure, where cavitation appears. Therefore, the liquid is vaporized, thus, making a two-phase flow. This pressure decrease can be as dangerous as the pressure rise. As a result of the pressure drop and vaporization of the liquid, two liquid regions are separated,... 

Different families of the Discrete Vapour Cavity Model (DVCM) are developed, including the frictionless, steady and quasi-steady friction models. A relaxation-dissipation approach is proposed to improve the timing of pressure pulses predicted by the classic DVCM. In this approach, a friction correction factor is introduced into the steady/quasi-steady friction term to reduce the local value of the dissipation term in regions facing with cavitation. The proposed approach is completely consistent with the classical water-hammer framework. The importance of the steady/quasi-steady friction term is investigated by comparing numerical results of different DVCMs with the experimental data for... 

Demand forecasting plays an important role as a decision support tool in power system management, especially in smart grid and liberalized power market. In this paper, a demand forecasting method is presented by using support vector regression (SVR). The proposed method is applied to practical hourly data of the Greater Tehran Electricity Distribution Company. The SVR parameters are selected by using a grid optimization process and an investigation on different kernel functions. Moreover, correlation analysis is used to find exogenous variables. Acceptable accuracy of load prediction is shown by comparing the result of SVR model to that of the artificial neural networks and the actual data,... 

The secretary problems are of types of the optimal stopping theory problems and are also distinguished as well known problems in applied probability, statistics and decision theory fields. The importance of these kinds of problems defines many new conditions which have been discussed till now. The significance of these types of problems in social issues causes to define many conditions which are vastly discussed. In this paper, a new condition of this problem is considered. These conditions which have been performed using a real time method are based on Multi-Agent Systems techniques. In this paper, after evaluating this method, the resulted answers are examined using Multi-Agent system... 

The isomerization of D-glucose to D-fructose using the immobilized glucose isomerase, as a typical model system of solid-liquid enzyme reactions has been carried out in a novel type of two-impinging-jets reactor (TIJR), which is characterized by a rotating inner cylinder in a stationary one. Because of the impinging process, turbulence, and complex trajectory of the solid particles within the reactor, the fractional conversion of glucose obtained in the TIJR increased dramatically compared to that obtained by conventional reaction systems. A compartment model was considered to describe the pattern of flow [residence time distribution (RTD) of solid particles] within the TIJR. Considering... 

A compartment model was developed to describe the flow pattern of gas within the dense zone of a membrane-assisted fluidized-bed reactor (MAFBR), in the bubbling mode of operation for steam reforming of methane both with (adiabatic) and without (isothermal) entering oxygen. Considering such a flow pattern and using the experimental data reported elsewhere [Roy S, Pruden BB, Adris AM, Grace JR, Lim CJ. Fluidized-bed steam methane reforming with oxygen input. Chem Eng Sci 1999; 54:2095-2102.], the parameters of the developed model (i.e., number of compartments for the bubble and emulsion phases) were determined and fair agreements were obtained between model predictions and experimental data.... 

In this article, the transesterification of waste cooking oil (WCO) to biodiesel fuel (BDF) has been studied using KOH loaded on millimetric γ-Al2O3 particles in a novel type of two-impinging-jets reactor (TIJR). The effects of various parameters such as KOH loading (wt %), catalyst loading, and methanol-to-oil molar ratio on the BDF yield were studied. The catalyst particles with a KOH loading of 25 wt % at appropriate reaction conditions (i.e., catalyst loading = 4 wt % and methanol-to-oil molar ratio = 15:1) and at 65 °C were used in the TIJR. The influences of various operating and design parameters such as jet Reynolds number value, feed flow rate, jet diameter, and the internozzle... 

Mixed-convection flow of nanofluids inside a vertical rectangular channel partially filled with open-cell metal foam and subject to a constant wall-heat flux was investigated experimentally and numerically. Al2O3-water nanofluids with different concentrations were prepared and their stability was examined using UV-Vis spectroscopy. Dynamic light scattering method was used to determine particle size distribution of the nanofluid feedstock. The outlet temperature and pressure drop were measured for different nanofluid flow rates (i.e., Reynolds number values). In the numerical section, a two-dimensional volume-averaged form of the governing equations was used. The velocity and temperature... 

In this article, transient hydrodynamic and heat-transfer behavior of Newtonian fluid flow in vertical parallel-plate channels partially filled with a porous medium has been investigated numerically. In this regard, the influences of macroscopic local inertial term and the viscous heating due to the viscous dissipation were taken into account in the momentum equations of porous region and the thermal energy equations, respectively. Moreover, Forchheimer-Brinkman extended Darcy model was used to model fluid flow in the porous region. In addition, an analytical solution was obtained in the case of negligible Brinkman and Forchheimer number values at the steady-state conditions. The predicted... 

In this article, adsorption of p-xylene, m-xylene, o-xylene, and ethylbenzene on Na-BETA type zeolite in liquid phase at 15, 25, and 35 °C has been studied and the single adsorption isotherms have been obtained and reported. The Langmuir isotherm model was used to describe the experimental adsorption isotherm data. It was found that p-xylene is more strongly adsorbed component followed by ethylbenzene, m-xylene and o-xylene. This means that this adsorbent is selective for p-xylene. Using Langmuir isotherm model, the saturation adsorption capacities of the adsorbent were obtained as follows 143 mg/g for p-xylene, 105 mg/g for ethylbenzene, 83 mg/g for m-xylene, and 68 mg/g for o-xylene at 25... 

The mass-transfer characteristics of a new type of two-impinging-streams reactor (TISR) was studied by means of sodium sulfite solution as the liquid phase and air as the gas phase, in the presence and absence of various types of surface-active agents (SAAs). The influences of anionic, cationic, and nonionic SAAs on the specific interfacial area and overall volumetric mass-transfer coefficient obtained in the TISR were investigated. It was found that the presence of a little amount of the above-mentioned contaminants increases the specific interfacial area and decreases the overall volumetric mass-transfer coefficient. On the basis of the experimental results obtained for various types of...