Sharif Digital Repository

-In this paper, a new optimized structure for two-speed, capacitor-run, single-phase axial flux induction motor (AFIM) for direct-drive operation is presented. Although, there are many advantages for direct-drive systems, their axial forces between the stator and rotor increases with reduction in air-gap length and is of serious concern. An increase in the air-gap length will result in the deterioration of performance characteristics of the motor. In this paper, a new construction technique is proposed to fabricate an AFIM with adjustable air-gap length. After presenting a comprehensive design algorithm, all geometrical dimensions and electrical equivalent circuit parameters are analytically... 

Surfaces of cast 1100 aluminum were treated by multi-pass friction stir processing (MP-FSP), which is a solid-state microstructural modification technique using frictional heat and stirring action. An improvement in the mechanical properties was accomplished due to the microstructural modification and reduction of porosities. The yield strengths of the MP-FSPed specimens were significantly increased to about 1.4 times versus that of the base metal. The elongation of MP-FSP sample is about 30% higher than that of the base metal. Also the ultimate tensile strength and hardness of MP-FSPed specimens are improved. Moreover the effect of tool rotation rate and tool travel speed on the mechanical... 

Recently, V. Sorokine et al. (see IEEE Trans. Commun., vol.48, no.10, p.1660-8, 2000; vol.48, no.11, p.1818-28, 2000) have introduced a class of low-density parity-check (LDPC) codes which, when applied on an IS-95 CDMA system, show, at BER=10-3, a five-fold and two-fold increase in capacity compared to the traditional uncoded scheme and to state-of-the-art low-rate orthogonal convolutional codes, respectively. However, these codes suffer from an error-floor at lower BERs which are needed for high-quality services, such as data. To enhance the capacity of CDMA systems, not only for moderate BER values but also for lower BER values, we modify the construction of these codes slightly, to... 

In this work, a novel method is proposed to study the BIBO stability of a fractional delay system. The characteristic equation of a fractional delay system with some transcendental terms has infinitely many roots. Applying D-subdivision method and the Rekasius substitution divide one-dimensional parametric space of the time delay to infinite intervals with finite unstable roots. The number of unstable roots in each interval is calculated with the definition of root tendency on the boundary of each interval. Two illustrative examples are presented to confirm the proposed method results  

Several unicast and multicast routing protocols have been presented for MPSoCs. Multicast protocols in NoCs are used for cache coherency in distributed shared memory systems, replication, barrier synchronization, or clock synchronization. Unicast routing algorithms are not suitable for multicast, as they increase traffic, congestion and deadlock probability. Famous multicast schemes such as tree-based and path-based schemes have been proposed originally for multicomputers and recently adapted to NoCs. In this paper, we propose a switch tree-based multicast scheme, called STBA. This method supports tree construction with a minimum number of routers. Our evaluation results reveal that, for... 

Resolver is an electromagnetic position sensor typically used in the closed-loop control of permanent magnet synchronous motors (PMSMs). In terms of structure and principle of operation, resolvers are very similar to electrical machines. In this regard, different numerical and analytical models have been developed for the performance prediction of a resolver, with a compromise between computational burden and accuracy. Therefore, a fast and accurate hybrid model of the resolver is presented in this article, which can be used for resolvers with different structures. Additionally, this model can easily be implemented in software such as MATLAB/SIMULINK. The performance of different variable... 

This paper has been prepared, based on reports regarding extraordinary induced ac voltage on buried gas pipelines in residential and industrial areas of the capital city of Tehran, especially in densely populated central areas. Also, some reports are considered on the existence of ac induced voltage in buried gas pipelines under the overhead transmission lines, for example, one case located 80 Km to the west of Tehran, in an agricultural region of the town of Abyek. In this paper, the results of an extensive theoretical, experimental and practical investigation and implementation of methods carried out during the last two years are introduced. Furthermore, this paper includes evaluation of... 

Achieving dense off-chip interconnection with satisfactory electrical performance is emerging as a major challenge in advanced system engineering. Graphene nanoribbons (GNRs) have been recently proposed as one of the potential candidate materials for both transistors and interconnect. In addition, development is still underway for alternative materials and processes for high aspect ratio (AR) contacts. Studding the effect of varying aspect ratio on relative stability of graphene nanoribbon interconnects is an important viewpoint in performance evaluation of system. In this paper, Nyquist stability analysis based on transmission line modeling (TLM) for GNR interconnects is investigated. In... 

The remarkable properties of graphene nanoribbons (GNRs) make them attractive for nano-scale devices applications, especially for transistor and interconnect. Furthermore, for reduction interconnects signal delay, low dielectric constant materials are being introduced to replace conventional dielectrics in next generation IC technologies. With these regards, studding the effect of varying dielectric constant (e{open}r) on relative stability of graphene nanoribbons interconnect is an important viewpoint in performance evaluation of system. In this paper, Nyquist stability analysis based on transmission line modeling (TLM) for graphene nanoribbon interconnects is investigated. In this... 

In this work, studies of underground gas storage (UGS) were performed on a partially depleted, naturally fractured gas reservoir through compositional simulation. Reservoir dynamic model was calibrated by history matching of about 20 years of researvoir production. Effects of fracture parameters, i.e. fracture shape factor, fracture permeability and porosity were studied. Results showed that distribution of fracture density affects flow and production of water, but not that of gas, through porous medium. However, due to high mobility of gas, the gas production and reservoir average pressure are insensitive to fracture shape factor. Also, it was found that uniform fracture permeability... 

Linear position sensors are essential parts of linear motion control systems. Among different linear sensors, linear resolvers are an appropriate choice for harsh environments. Design optimization of linear resolvers needs an accurate, but computationally fast model for their performance prediction. Slotting effect of the cores and end effect are two important phenomena that must be accurately involved in the model to ensure its reliable results. Therefore, in this paper a semi-analytical model based on subdomain modeling technique is proposed for linear resolvers. Then, according to the developed model, the induced voltages in the signal windings of the resolver are calculated and... 

Linear resolvers are position sensors that are being used in a wide range of applications for linear motion systems. The electromagnetic design of a linear resolver, similar to any other electromagnetic device, demands an accurate, functional, and fast tool. While the finite element method (FEM) is considered the most accurate tool for electromagnetic analysis, it is not a good candidate for an optimization-based design which is an iterative process. In this article, first off, an analytical tool based on the subdomain model is briefly presented. This model is very accurate and much faster than FEM. However, it has high computational time for iterative design and optimization processes.... 

Multi-speed resolvers are used in the applications that need higher accuracy. However, they suffer from losing absolute position information. To overcome this challenge and improve the reliability of detecting position, using multi-turn resolvers is recommended. The conventional configuration of multi-turn resolver is using two individual resolvers on one shaft and into a common frame. Using such configuration needs special care on setting the distance between two resolvers. In this paper a new structure based on dual side configuration is proposed. The performance of the double sided resolver is analyzed and optimized using an analytical model based on magnetic equivalent circuit (MEC).... 

In this letter, we examine the positioning in wireless networks in the presence of IRSs. We show that IRSs can be used to localize the user when there are not enough transmitters (Base Station). To this end, we consider a network of one transmitter, few IRSs, and one receiver, whose location should be determined. Our results indicate that we can achieve the accuracy required in the localization by controlling the number of elements of IRSs and properly selecting the location of IRSs for a given region. © 2012 IEEE  

Multispeed resolvers are used in the applications that need higher accuracy. However, they suffer from losing absolute position information. To overcome this challenge and improve the reliability of detecting position, the use of multiturn resolvers is recommended. The conventional configuration of multiturn resolver is using two individual resolvers on one shaft and into a common frame. Using such configuration needs special care on setting the distance between two resolvers. In this article, a new structure based on a dual side configuration is proposed. The performance of the double-sided resolver is analyzed and optimized using an analytical model based on a magnetic equivalent circuit.... 

Fractures identification is essential during exploration, drilling and well completion of naturally fractured reservoirs since they have a significant impact on flow contribution. There are different methods to characterize these systems based on formation properties and fluid flow behaviour such as logging and testing. Pressure-transient testing has long been recognized as a reservoir characterization tool. Although welltest analysis is a recommended technique for fracture evaluation, but its use is still not well understood. Analysis of pressure transient data provides dynamic reservoir properties such as average permeability, fracture storativity and fracture conductivity.An infusion of... 

In this paper, we consider a broadband secondary transmitter-receiver pair which interferes with N narrowband primary users and study the effect of cognition and cooperation on the maximum stable throughput. In our study we focus on four transmission protocols as well as two channel types, i.e., flat fading and frequency selective fading. In the cooperative protocols, the broadband transmitter relays the packets of the primary users which have not correctly decoded at the primary receiver. The analysis includes random packet arrivals at the transmitters which may impact on the maximum stable throughput. Moreover, sensing errors at the secondary user are considered. In this paper, we derive... 

Proton Exchange Membrane (PEM) Fuel Cells are attracting most of the electricity consumers because of high efficiency, zero carbon emissions and high reliability. There are many parameters influencing on this power source's operation. A model of PEM fuel cell will be presented and the sensitivity of the fuel cell's parameters will be analyzed. Multi Parameters Sensitivity Analysis is used next to examine the relative importance of the influential parameters on the PEM fuel cell operation  

To improve the thermal stability of starch in water-based drilling fluid, monoethanolamine (MEA) was added, and the effect was investigated by laboratory experiment. The experimental results show that the addition of monoethanolamine (MEA) increases the apparent viscosity, plastic viscosity, dynamic shear force, and static shear force of the drilling fluid, and reduces the filtration rate of drilling fluid and thickness of mud cake apparently. By creating hydrogen bonds with starch polymer, the monoethanolamine can prevent hydrolysis of starch at high temperature. Starch, as a natural polymer, is able to improve the rheological properties and reduce filtration of drilling fluid, but it works...