Sharif Digital Repository

A mathematical model has been developed that is based the dual sorption in the dense layer and pore flow in the porous layer. In the porous layer a resistance model is applied where four mechanisms, i.e., Knudsen, Viscous, Slip, and Surface flows, are superimposed. Steady-state, constant pressure along the membrane and constant physical properties are assumed. Its application to the separation of H 2S/CH 4 gas mixtures as a sour gas in natural gas sweetening by using a PPO hollow fiber module is put forward. The Quasi Newton method is used to determine the parameters of membrane transport model for the case of H 2S/CH 4 separation. The H 2S and CH 4 permeances increased by increasing the... 

In this paper, we address the problem of recovering degraded images using multivariate Gaussian mixture model (GMM) as a prior. The GMM framework in our method for image restoration is based on the assumption that the accumulation of similar patches in a neighborhood are derived from a multivariate Gaussian probability distribution with a specific covariance and mean. Previous methods of image restoration with GMM have not considered spatial (geometric) distance between patches in clustering. Our conducted experiments show that in the case of constraining Gaussian estimates into a finite-sized windows, the patch clusters are more likely to be derived from the estimated multivariate Gaussian... 

In this work, permeation of mixed gases H2S/CH4 through commercial polyphenylene oxide (PPO) hollow fiber and poly (ester urethane) urea (PEUU) flat membranes was studied at pressures of 345–689 kPa, at ambient temperature and at 313.15 K. Various H2S concentrations of about 100–5000 ppm in CH4 binary synthetic gas mixtures as well as a real natural gas sample obtained from a gas refinery containing 0.3360 mol.% H2S (equivalent to 3360 ppm) were tested. It was observed that the permeance of components was affected by the balance between competitive sorption and plasticization effects. Separation factors of H2S/CH4 were in the range of 1.3–2.9, 1.8–3.1 and 2.2–4.3 at pressures of 345, 517 and... 

In this paper, we address the problem of dictionary learning for sparse representation. Considering the regularized form of the dictionary learning problem, we propose a method based on a homotopy approach, in which the regularization parameter is overall decreased along iterations. We estimate the value of the regularization parameter adaptively at each iteration based on the current value of the dictionary and the sparse coefficients, such that it preserves both sparse coefficients and dictionary optimality conditions. This value is, then, gradually decreased for the next iteration to follow a homotopy method. The results show that our method has faster implementation compared to recent... 

In this paper we address the problem of image interpolation using Gaussian Mixture Models (GMM) as a prior. Previous methods of image restoration with GMM have not considered spatial (geometric) distance between patches in clustering, failing to fully exploit the coherency of nearby patches. The GMM framework in our method for image interpolation is based on the assumption that the accumulation of similar patches in a neighborhood are derived from a multivariate Gaussian probability distribution with a specific covariance and mean. An Expectation Maximization-like (EM-like) algorithm is used in order to determine patches in a cluster and restore them. The results show that our image... 

Recently, decellularized amniotic membrane-derived hydrogels (DAMHs) have received significant attention for wound care, ocular surface reconstruction, and chondral healing. Despite the advantages of DAMHs for tissue engineering (TE), the loss of structural components during the decellularization process mitigates their mechanical strength and thus limits their practical application. Herein, we present a method for the surface modification of two-dimensional nanosilicates (laponite) as a rheological modifier to tailor the properties of DAMHs. Results show that after introducing nanosilicates, severe aggregation of the nanoparticles occurs, owing to the shielding effect of ions on the surface... 

Recently, decellularized amniotic membranes (dAM) have attracted significant interest as a valuable source for the development of shear-thinning hydrogels and bioinks. However, the inferior rheological behavior and weak mechanical durability restrict the printability of the hydrogels and their stability after three-dimensional (3D) bioprinting. Therefore, a chemical or physical modification with biocompatible components is necessary to improve dAM-derived hydrogels’ properties. The present study proposes a strategy to fabricate printable dAM-derived hydrogels (DAMHs) supplemented with sodium alginate and Laponite nanoplatelets. Rheological experiments determined the key role of Laponite... 

In this communication, a hybrid model based on Least Square Support Vector Machine (LSSVM) was constructed to predict CO2 corrosion rate. The input parameters of the model are temperature, CO2 partial pressure, flow velocity and pH. The data used for training and testing of the developed model are 612 and 109 data, respectively. In order to benefit LSSVM from Kernel learning, we compared three kernel functions to select the most efficient one. Furthermore, Coupled Simulated Annealing (CSA) optimization technique was adapted to choose the best optimal values of the model parameters. The results elucidate that Gaussian Kernel functions is the desired function which can afford high accuracy for... 

Using multiple antennas at the transmit and receive sides of a passive radar brings both the benefits of MIMO radar and passive radar. However one of the obstacles arisen in such configuration is the receive antennas placement in proper positions so that the radar performance is improved. Here we just consider the case of positioning one receiver among multiple illuminators of opportunity. Indeed it is a start for the solution of optimizing the geometry of the multiple receivers in a passive radar  

SbCl3 supported on montmorillonite K-10 is an efficient catalyst for the ring opening of epoxides with aromatic amines under solvent-free conditions and microwave irradiation to give the corresponding b-amino alcohols in high yields with high regioselectivity  

In this paper, we consider an integrated sensing and communication (ISAC) system with wireless power transfer (WPT) where an unmanned aerial vehicle (UAV)-based radar serves a group of energy-limited communication users in addition to its sensing functionality. In this architecture, the radar senses the environment in phase 1 (namely sensing phase) and mean-while, the communications users (nodes) harvest and store the energy from the radar transmit signal. The stored energy is then used for information transmission from the nodes to UAV in phase 2, i.e., uplink phase. Performance of the radar system depends on the transmit signal as well as the receive filter; the energy of the transmit... 

One of the important obstacles in MIMO (Multiple Input Multiple Output) radars is the issue of designing proper transmit signals. Indeed, the capability of signal design is a significant advantage in MIMO radars, through which, the system can achieve much better performance. Many different aspects of this performance improvement have been considered yet, and the transmit signals have been designed to attain such goal, e.g., getting higher SNR or better detector's performance at the receiver. However, an important tool for evaluating the radar's performance is its ambiguity function. In this paper, we consider the problem of transmit signal design, in order to optimize the ambiguity function... 

Two gains play key roles in recently developed MIMO wireless communication systems: "spatial diversity" gain and "spatial multiplexing" gain. The diversity gain refers to the capability to decrease the error rate of the MIMO channel, while the multiplexing gain implicitly refers to the amount of increase in the capacity of the MIMO channel. It has been shown that there is a fundamental tradeoff between these two types of gains, meaning interplay between increasing reliability (via an increase in the diversity gain) and increasing data rate (via an increase in the multiplexing gain). On the other hand, recently, MIMO radars have attracted much attention for their superior ability to enhance... 

It is a well known fact that using multiple antennas at transmit and receive sides improves the detection performance. However, in such multiple-input multiple-output (MIMO) configuration, proper positioning of transmitters and receivers is a big challenge that can have significant influence on the performance of the overall system. In addition, determining the power of each transmitter under a total power constraint is a problem that should be solved in order to enhance the performance and coverage of such a system. In this paper, we design the Neyman-Pearson detector under the Rayleigh scatter model and use it to introduce a criterion for the antenna placement at both transmit and receive... 

There has been much interest, recently, towards exploiting the Multiple-Input Multiple-Output (MIMO) technique in radar. It is shown that using multiple antennas at transmit and receive sides can improve the performance of the system. However, in order to analyze the system's performance, its ambiguity function, i.e. the ambiguity function of a MIMO radar, is needed to be defined. In this paper, beginning from the information theoretic definitions, we derive such function, specifically for a MIMO radar with widely separated antennas  

By combining the two ideas of MIMO (Multiple Input Multiple Output) and PCL (Passive Coherent Location) in radar, one can achieve the advantages of both recently developed techniques simultaneously. While using multiple antennas at the receive side provides a spatial diversity of the object to be detected, using multiple illuminators of opportunity, most importantly, makes the radar covert to the interceptors. One obstacle in such MIMO configuration is choosing the positions of the receive antennas. In this paper, after analyzing the Neyman-Pearson detector for the DVB-T based PCL, we introduce the probability of missed detection as a criterion to place the receive antenna. Here, we only... 

One of the most important obstacles in passive radar applications is removing the direct signal from the target channel. Otherwise, week echoes from the targets in the target channel would be ignored due to the limited dynamic range of the system. One of the most effective techniques in this field is using adaptive filters. In this paper various adaptive filters are introduced and their performances are shown and compared  

It has been shown that using multiple antennas in a radar system improves the performance considerably, since multiple target echoes are received from different aspect angles of the target. In this way, the target detection is improved. However, when using multiple antennas, some problems, such as designing the transmit signals, synchronization, etc. emerge that should be solved. One of such problems is the receiver placement. Receiver placement deals with choosing a proper position for the receive antenna in order to optimize the whole system's performance. In this paper, a receiver placement procedure based on improving the radar ambiguity function is proposed for the case of a multisite...