Sharif Digital Repository

So far, investigations have shown that open dielectricresonator antennas(DRAs) offer several advantages at microwaveand millimeter wave frequencies and make them appropriate in low directional-gain applications . These advantages include small size, large impedance bandwidth, high radiation efficiency, ease of manufacturing and simple feed-coupling mechanisms (such as probe coupling, aperture coupling or proximity coupling to micro-strip lines). Most microwave ferrites have dielectric constants in the desirable range and they can be used in place of dielectric materials. Such ferrite resonator antennas (FRAs) offer a potential advantage inthat their permeability tensor can be controlled by... 

Exoskeleton is a newborn technology for disabled people. Personal exoskeleton is a type that is suitable for replacement of wheelchair. Exoped, the first Iranian exoskeleton made by Pedasys company, was a rehabilitation one. The purpose of this research was enhancing the design of its actuators to accomplish lighter, smaller and cheaper one. At first we identified the different loads that are applied to actuators of exoskeleton and we tried to decrease the number of actuators needed, as more as possible. Then we modeled the exoskeleton-user system to measure the required parameters. Using this model, we conducted an algorithm to design appropriate gait cycle for walking with the help of... 

The use of polymers is increasing day by day due to low density, reasonable price and ability to produce different products. On the other hand, the accumulation of polymer wastes in nature is one of the environmental concerns in today's world, which is mainly due to the widespread use of polymers in the packaging industry and disposable applications. In order to solve this problem, recycling is recommended as the most appropriate and economical solution. Because in addition to consuming polymer waste, it also saves energy and reduces carbon footprint.Polyethylene terephthalate (PET) is one of the polymeric materials which; It has a special place in the packaging industry and is widely used... 

The improved properties of nanocomposites are not achievable with conventional composites. Scale effect is one the most important parameters in the physical and mechanical properties of polymeric nanocomposites. One of the physical phenomena, which can be related to the scale effect, is the very large interface between the nanoparticles and the polymeric matrices. Motional behavior and conformation of polymeric chains change near the nanoparticles surfaces. Due to high interface of the nanoparticles with the polymeric matrices the amount of these types of changes in the polymeric chains are so large that can change the physical and mechanical properties of polymeric nanocomposites. In this... 

In the field of high-pressure material science, diverse carbon systems under pressure have been intensively studied with interest in synthesizing new phases. A variety of these synthetic phases which have met various applications in today technology are called the amorphous diamond. The pressure-induced structural transition of carbonaceous material to amorphous diamond is realized by shock compression and rapid quenching. The shock compression and rapid quenching generate the high pressure (several GPa) and the temperature (several hundred K) in a fraction of a microsecond.Since the mechanical and electrical properties of the synthetic diamond are severely sensitive to the atomic structure,... 

The behavior of boundary layer under the effect of the sweep angle is considered. The measurements were performed by a pitot tube rake. Three models with various sweep angels at angles of attack -2, 0 and 2 degree were tested. Both tip and root of all wings were closed by flat plates in order to prevent the flow to roll-up. However the flow field on the wing was still three-dimensional because of the sweep angle. The velocity on the wing has two components; longitudinal and lateral. The cross flow emerges due to the non-equilibrium of pressure and centrifugal forces. The velocity profiles showed that the magnitude of cross flow was stronger near the leading edge of the wing. The cross flow... 

Drug-eluting bone implant coatings is a new era that has gained a lot of attention in recent years. In this matter, drug is loaded in the coating and local and targeted release of the drug results in preventing the side effects of implantation and increasing the healing process of the patient. The aim of this project was to synthesis the antibiotic eluting chitosan-based composite using electrophoretic deposition for bone implant coating. By using electrophoretic deposition chitosan and chitosan-bioglass composite coatings were synthesized. Then the probability of loading of drug into coating by using electrophoretic deposition was evaluated and by using this process chitosan and... 

The numerical solution of differential equations in high dimensions has always been a challenge and has been associated with various computational difficulties. These equations appear naturally in a variety of problems such as financial mathematics, control, and physics, and their optimal solution with high accuracy and speed can open new windows on new applications. Conventional methods such as Finite element and finite difference method in high dimensions lose their efficiency, which is a barrier to fast and accurate calculation of these equations. In this dissertation first, we review some theoretical and practical aspects of deep neural networks and then we try to examine the recent... 

Confining nematic liquid crystal between two curved boundary conditions while the nematic molecules have a degenerate planar anchoring leads to complex and beautiful textures of molecular disparagement(defect) in the bulk and on the surfaces. Such the liquid crystal shells are made with double-emulsion techniques in microfluidic devices have provided applications for micro-scale colloidal linkers.In this work, we have numerically minimized the elastic energy in one-constant approximation in present of Fournier’s degenerate surface potential with finite element method. The nematic shell is confined between two spherical surfaces that we have studied the final energies and their related...