Sharif Digital Repository

In this work, permeation of mixed gases H2S/CH4 through commercial polyphenylene oxide (PPO) hollow fiber and poly (ester urethane) urea (PEUU) flat membranes was studied at pressures of 345–689 kPa, at ambient temperature and at 313.15 K. Various H2S concentrations of about 100–5000 ppm in CH4 binary synthetic gas mixtures as well as a real natural gas sample obtained from a gas refinery containing 0.3360 mol.% H2S (equivalent to 3360 ppm) were tested. It was observed that the permeance of components was affected by the balance between competitive sorption and plasticization effects. Separation factors of H2S/CH4 were in the range of 1.3–2.9, 1.8–3.1 and 2.2–4.3 at pressures of 345, 517 and... 

In this study, a two-stage membrane system for the separation of CH4/CO2 was designed based on a series of laboratory-scale experiments obtained using two types of commercial hollow fiber membranes including polyphenylene oxide (PPO) and Cardo-type polyimide (PI). The former showed high permeability and low to moderate selectivity, while the latter exhibited high selectivity and moderate permeability. In this design, the permeate from the first stage - rich in CO2 but containing considerable amount of methane - is fed into the second stage to recover its methane content. The performances of double- and single-stage system designs were compared in terms of methane loss (the ratio of methane... 

Impurities such as hydrogen sulfide, water vapor and heavy hydrocarbons in natural gas have considerable effects on the membrane performance. The influence of ethane on the performance of polyphenylene oxide and cardo-type polyimide hollow fiber membranes in CO2/CH4 Separation was studied. The gas mixture permeation rate was increased in the presence of C2H6. However, the CO2/CH4 separation factors remained almost the same in the presence and absence of the C2H6. This is an abstract of a paper presented at the 8th World Congress of Chemical Engineering (Montreal, Quebec, Canada 8/23-27/2009)  

The performances of poly (2,6-dimethyl-1 A-phenylene oxide)(PPO) and Cardo-type polyimide (PI) hollow fiber membranes in the removal of H2S were studied. At 101-401 ppm concentration of H2S in CH4, the CH4 permeability decreased in the presence of H2S for Cardo-type polyimide hollow fiber membranes whereas the PPO membrane performance was not affected. The separation coefficients of H2S/CH4 were 6 and 4 for PI and PPO membranes, respectively. The permeabilities of both components of the mixture increased with increasing temperature whereas the selectivities remained constant. This is an abstract of a paper presented at the 8th World Congress of Chemical Engineering (Montreal, Quebec, Canada... 

Gas separation properties of commercially available polyphenylene oxide (PPO) and Cardo-type polyimide (PI) hollow fiber membranes were investigated by CO2/CH4 and O2/N2 separation experiments. The pure gas permeation and the mixed gas separation experiments indicated that the two hollow fiber membranes were suitable candidates for O2/N2 and CO2/CH4 separations. Average O2/N2 permselectivities of 3.9 and 5.7 for PPO and PI hollow fibers, respectively, average CO2/CH4 permselectivities of 16.4 and 36.0 for PPO and PI hollow fibers, respectively, CO2 permeances of 210 and 110 GPU at 100 psig for PPO and PI hollow fibers, and O2 permeances of 40 GPU and 15 GPU for PPO and PI hollow fibers were... 

The effects of water vapor on CO2/CH4 separation using commercially available poly(2,6-dimethyl-1,4-phenylene oxide) (PPO) and Cardo-type polyimide hollow fiber membranes were investigated. Pure methane and CO2/CH4 mixture permeation experiments were carried out in the absence and presence of water vapor (60% RH). Pure methane permeance decreased in the presence of water vapor for both membrane types. The decrease was 28% for hydrophilic Cardo-type polyimide and 6% for hydrophobic PPO membranes. The decline in the permeance was also observed for CO2/CH4 mixture separation through both membranes. However, selectivities of the two membranes were affected differently by water vapor. The... 

In this study, the effect of film preparation conditions on the gas permeation properties of polyethylene (PE) and ethylene vinyl acetate (EVA) films (containing 18 and 28wt% vinyl acetate) was investigated. Film blowing and phase inversion methods were applied in the production of PE and EVA films, respectively. The permeation of pure oxygen and carbon dioxide gases was measured at room temperature. The results indicated that with the increase of PE film thickness, permeability and solubility of O2 and CO2 in these films decreased; but the diffusivities of gases through PE films increased. In addition, in the case of EVA copolymers, by increasing the content of vinyl acetate, the... 

In this research, the effects of preparation conditions, including the coagulation bath temperature, polymer solution composition, preliminary drying time, and thickness of cast polymeric films, on the morphology of ethylene/vinyl acetate copolymer membranes were investigated with scanning electron microscopy and nitrogen gas permeability tests. Flat sheet membranes were prepared through a thermal-wet phase-inversion method. Scanning electron microscopy pictures showed asymmetric structures for some of the membranes. It was also observed that the porosity of the membranes decreased with an increase in the temperature of the coagulation bath and the solvent evaporation period. When the... 

The gas separation properties of ethylene vinyl acetate (EVA) membranes containing 18 and 28 wt% of vinyl acetate (VA) were investigated in this study. The effects of membrane preparation conditions, such as thermal and thermal/wet phase inversion, and the type of solvent on the gas separation properties of EVA membranes were investigated. The permeation of pure O2, N2, CH4, and CO2 gases at different feed pressures ranging from 2 to 11 bar were examined. The results indicated that the CO2 permeability was evidently higher than those of the other gases. Furthermore, the solubility mechanism was found to be the dominant mechanism for permeation of gases through EVA membranes. Moreover, the... 

The performance of commercially available poly (2,6-dimethyl-1,4-phenylene oxide) (PPO) and Cardotype polyimide (PI) hollow fiber membranes was investigated in removing hydrogen sulfide from methane in a series of bench-scale experiments. It was observed that in the concentration range of hydrogen sulfide in methane from 101 to 401 ppm, the methane permeability decreased in the presence of hydrogen sulfide for Cardo-type polyimide hollow fiber membranes, whereas the PPO membrane performance was not affected. The separation coefficients of hydrogen sulfide/methane were 6 and 4 for PI and PPO membranes, respectively. Effects of temperature on the performance of PI and PPO membranes were... 

Impurities such as hydrogen sulfide, water vapor and heavy hydrocarbons in natural gas have considerable effects on the membrane performance. Small amounts of condensable and polymer soluble components in the feed gas cause swelling or plasticization of glassy membranes, leading to a reduction in membrane selectivity. In the present research the influence of ethane was investigated on the permeance and selectivity of two commercially available hollow fiber membranes, namely Cardo-type polyimide and PPO hollow fibers for CO 2/CH 4 separations. It was concluded that the gas mixture permeation rate was increased in the presence of C 2H 6. However, the CO 2/CH 4 separation factors remained... 

Human parvovirus B19 (B19) is a small, non-enveloped virus and belongs to Parvoviridae family. B19 persists in many tissues such as thyroid tissue and even thyroid cancer. The main aim of this study was to determine the presence of B19, its association with increased inflammation in thyroid tissue, and thus its possible role in thyroid cancer progression. Studies have shown that virus replication in non-permissive tissue leads to overexpression of non-structural protein and results in upregulation of proinflammatory cytokines such as interleukin 6 and tumor necrosis factor alpha. A total of 36 paraffin-embedded thyroid specimens and serum were collected from patients and 12 samples were used... 

Using multiple antennas at the transmit and receive sides of a passive radar brings both the benefits of MIMO radar and passive radar. However one of the obstacles arisen in such configuration is the receive antennas placement in proper positions so that the radar performance is improved. Here we just consider the case of positioning one receiver among multiple illuminators of opportunity. Indeed it is a start for the solution of optimizing the geometry of the multiple receivers in a passive radar  

SbCl3 supported on montmorillonite K-10 is an efficient catalyst for the ring opening of epoxides with aromatic amines under solvent-free conditions and microwave irradiation to give the corresponding b-amino alcohols in high yields with high regioselectivity  

One of the important obstacles in MIMO (Multiple Input Multiple Output) radars is the issue of designing proper transmit signals. Indeed, the capability of signal design is a significant advantage in MIMO radars, through which, the system can achieve much better performance. Many different aspects of this performance improvement have been considered yet, and the transmit signals have been designed to attain such goal, e.g., getting higher SNR or better detector's performance at the receiver. However, an important tool for evaluating the radar's performance is its ambiguity function. In this paper, we consider the problem of transmit signal design, in order to optimize the ambiguity function... 

Two gains play key roles in recently developed MIMO wireless communication systems: "spatial diversity" gain and "spatial multiplexing" gain. The diversity gain refers to the capability to decrease the error rate of the MIMO channel, while the multiplexing gain implicitly refers to the amount of increase in the capacity of the MIMO channel. It has been shown that there is a fundamental tradeoff between these two types of gains, meaning interplay between increasing reliability (via an increase in the diversity gain) and increasing data rate (via an increase in the multiplexing gain). On the other hand, recently, MIMO radars have attracted much attention for their superior ability to enhance... 

It is a well known fact that using multiple antennas at transmit and receive sides improves the detection performance. However, in such multiple-input multiple-output (MIMO) configuration, proper positioning of transmitters and receivers is a big challenge that can have significant influence on the performance of the overall system. In addition, determining the power of each transmitter under a total power constraint is a problem that should be solved in order to enhance the performance and coverage of such a system. In this paper, we design the Neyman-Pearson detector under the Rayleigh scatter model and use it to introduce a criterion for the antenna placement at both transmit and receive... 

There has been much interest, recently, towards exploiting the Multiple-Input Multiple-Output (MIMO) technique in radar. It is shown that using multiple antennas at transmit and receive sides can improve the performance of the system. However, in order to analyze the system's performance, its ambiguity function, i.e. the ambiguity function of a MIMO radar, is needed to be defined. In this paper, beginning from the information theoretic definitions, we derive such function, specifically for a MIMO radar with widely separated antennas  

By combining the two ideas of MIMO (Multiple Input Multiple Output) and PCL (Passive Coherent Location) in radar, one can achieve the advantages of both recently developed techniques simultaneously. While using multiple antennas at the receive side provides a spatial diversity of the object to be detected, using multiple illuminators of opportunity, most importantly, makes the radar covert to the interceptors. One obstacle in such MIMO configuration is choosing the positions of the receive antennas. In this paper, after analyzing the Neyman-Pearson detector for the DVB-T based PCL, we introduce the probability of missed detection as a criterion to place the receive antenna. Here, we only... 

One of the most important obstacles in passive radar applications is removing the direct signal from the target channel. Otherwise, week echoes from the targets in the target channel would be ignored due to the limited dynamic range of the system. One of the most effective techniques in this field is using adaptive filters. In this paper various adaptive filters are introduced and their performances are shown and compared