Sharif Digital Repository

In order to study the effect of boron addition on the microstructure and tensile properties of titanium matrix composites, two Ti-6Al-4V/10. Vol% TiC ingots with and without boron were fabricated by VIM furnace and hot rolling. The microstructures of composites were examined using optical microscopy (OM). The X-ray diffraction (XRD) was used to identify the phases present in the composites. Addition of boron resulted in the formation of needle shaped TiB in the matrix that was followed by the refinement of grain size. Compared with Ti-6Al-4V/TiC composite, the composite containing boron content exhibited a significantly higher ductility and lower strength. It was caused by the effects of... 

Information extraction and refinement systems rely on a set of extraction patterns in pattern based approaches in order to construct taxonomies and finding instances of concepts in a corpus. Pattern based methods have high precision and suffer from low recall. Pattern generalization and modeling techniques can increase matching power and decrease GAP between training and test data  

The out-of-pack cementation method was applied to coat the Nickel-based super alloy IN738LC with Si-modified aluminide. Different mixtures of the pack containing pure Al, Si, alumina powders as an inert filler, and NH4Cl as a halide salt activator were used for co-deposition at 950 and 1,050°C. The results showed although the amount of subhalide vapour pressures of Al and Si were equal at 1,050°C, Al atoms diffused only after Si atoms had been deposited. Before heat treatment, the coating thickness formed by the pack containing 2.3 wt.% Al was 6 μm more than that containing 3.5 wt.% Al. After heat treatment, thickening coatings formed within the pack containing 2.3 wt.% Al was less than that... 

By going to millimeter wave (mmWave) we can use large scale MIMO due to short mmWave wavelength to overcome path loss by using beamforming to focus power of signal to the receiver. System structure of mmWave band is different with conventional MIMO because of large scale MIMO which is leading to use many RF-chains. For this reason Hybrid structure have been proposed for large Scale MIMO. By going to Hybrid structure a new issue has been created with phase shifter constraint. In this paper we propose a novel solution to make a hybrid precoding and combing to reach high spectral efficiency. Our problem includes a maximizing Frobenius norm of multiplying five complex matrices. As constraints,... 

In this paper, Ti-6Al-4V/TiC composite was fabricated by VIM furnace and graphite crucible. X-ray diffraction analysis and EDS techniques were used to identify the phases in the material. Microstructure characteristics of the Ti-6Al-4V/TiC composite were evaluated by means of optical microscopy. The tensile test was performed at room temperature after hot-rolling of the samples in the beta phase field. The results revealed that at different melting times, three kinds of precipitates are formed in the microstructure including grain boundary, eutectic and transgranular precipitates. The size of transgranular precipitates was significantly larger than that of the other two types of carbides and... 

Fetching Lexico-Syntactic patterns from text rely on pairs of words (positive instances) that represent the target relation, and finding their simultaneous occurrence in text corpus. Due to existence of WordNet thesaurus (which contains the semantic relationship between words), collecting positive instances is easy. In non-english languages, it's hard to collect large number of positive instances in various contexts. We investigated some new ideas for collecting them in Persian language and finally run the best one and collected approximately 6,000 positive instances  

CMMI is a unified model for software and system engineering in organizations. The initial CMM has been designed for software development. According to its successes, different models were developed by different groups such as: SECM, SACMM, IPDCMM, and FAAICMM. CMM Integration was introduced due to some problems such as lack of uniformity, overlapping, and incompatibility of mentioned models. Current paper is a research on CMMI, especially on configuration management process. We believe that accepting all change requests lead to ad-hoc versions and rejecting them lead to customer dissatisfaction. Therefore a Change-Request buffer is needed in configuration management process based on CMMI... 

Users often have very specific visual content in mind that they are searching for. The most natural way to communicate this content to an image search engine is to use key-words that specify various properties or attributes of the content. A naive way of dealing with such multi-attribute queries is the following: train a classifier for each attribute independently, and then combine their scores on images to judge their fit to the query. We argue that this may not be the most effective or efficient approach. Conjunctions of attribute often correspond to very characteristic appearances. It would thus be beneficial to train classifiers that detect these conjunctions as a whole. But not all... 

Alumina-zirconia nanostructured coatings were formed on 7075 Al alloy through Plasma Electrolytic Oxidation (PEO) operated in aDC potentiostatic mode. The composite coatings were produced in the range of 425-500 V in an alkaline electrolyte containing 4 g/LK2ZrF6. Tribological properties of coatings were investigated using dry sliding wear test against WC balls with a pin-on-disc tribometer. Wear rates were evaluated using optical profilometer. It was shown that the nanostructured alumina-zirconia composite coatings can be formed at voltages 450 V. The coating thickness and roughness were in the range of 15.2-24.2 μm and 0.68-2.35 μm, respectively. The distribution of Al, Zr and O in the... 

Using multiple antennas at the transmit and receive sides of a passive radar brings both the benefits of MIMO radar and passive radar. However one of the obstacles arisen in such configuration is the receive antennas placement in proper positions so that the radar performance is improved. Here we just consider the case of positioning one receiver among multiple illuminators of opportunity. Indeed it is a start for the solution of optimizing the geometry of the multiple receivers in a passive radar  

SbCl3 supported on montmorillonite K-10 is an efficient catalyst for the ring opening of epoxides with aromatic amines under solvent-free conditions and microwave irradiation to give the corresponding b-amino alcohols in high yields with high regioselectivity  

In this paper, we consider an integrated sensing and communication (ISAC) system with wireless power transfer (WPT) where an unmanned aerial vehicle (UAV)-based radar serves a group of energy-limited communication users in addition to its sensing functionality. In this architecture, the radar senses the environment in phase 1 (namely sensing phase) and mean-while, the communications users (nodes) harvest and store the energy from the radar transmit signal. The stored energy is then used for information transmission from the nodes to UAV in phase 2, i.e., uplink phase. Performance of the radar system depends on the transmit signal as well as the receive filter; the energy of the transmit... 

One of the important obstacles in MIMO (Multiple Input Multiple Output) radars is the issue of designing proper transmit signals. Indeed, the capability of signal design is a significant advantage in MIMO radars, through which, the system can achieve much better performance. Many different aspects of this performance improvement have been considered yet, and the transmit signals have been designed to attain such goal, e.g., getting higher SNR or better detector's performance at the receiver. However, an important tool for evaluating the radar's performance is its ambiguity function. In this paper, we consider the problem of transmit signal design, in order to optimize the ambiguity function... 

Two gains play key roles in recently developed MIMO wireless communication systems: "spatial diversity" gain and "spatial multiplexing" gain. The diversity gain refers to the capability to decrease the error rate of the MIMO channel, while the multiplexing gain implicitly refers to the amount of increase in the capacity of the MIMO channel. It has been shown that there is a fundamental tradeoff between these two types of gains, meaning interplay between increasing reliability (via an increase in the diversity gain) and increasing data rate (via an increase in the multiplexing gain). On the other hand, recently, MIMO radars have attracted much attention for their superior ability to enhance... 

It is a well known fact that using multiple antennas at transmit and receive sides improves the detection performance. However, in such multiple-input multiple-output (MIMO) configuration, proper positioning of transmitters and receivers is a big challenge that can have significant influence on the performance of the overall system. In addition, determining the power of each transmitter under a total power constraint is a problem that should be solved in order to enhance the performance and coverage of such a system. In this paper, we design the Neyman-Pearson detector under the Rayleigh scatter model and use it to introduce a criterion for the antenna placement at both transmit and receive... 

There has been much interest, recently, towards exploiting the Multiple-Input Multiple-Output (MIMO) technique in radar. It is shown that using multiple antennas at transmit and receive sides can improve the performance of the system. However, in order to analyze the system's performance, its ambiguity function, i.e. the ambiguity function of a MIMO radar, is needed to be defined. In this paper, beginning from the information theoretic definitions, we derive such function, specifically for a MIMO radar with widely separated antennas