Sharif Digital Repository

Hybrid engines are one of a variety of chemical propulsion systems that have been given special attention in recent years by various industries such as space and defense. The most important reasons for considering this type of system are its high safety, its affordable price compared with liquid fuel propulsion systems, the possibility of switching on and off and changing thrust. This system has a lot of disadvantages as well. This system cannot meet all the needs of different industries due to the low regression rate and, consequently, the limitation of the operating range, thrusts and special impulse. As a result, increasing the fuel regression rate in these engines can greatly expand... 

The concept of Online-Distributed Mechanism Design, is taken from the two concepts of Online Mechanism and Distributed Mechanism and speaks of an environment which is dynamic when there is no trusted center to do the computation. This problem is stated in this thesis for the first time and by the thesis we gave the first results in some of the up coming fields of Online-Distributed Mechanism. These feilds would be defined by different assupmtions about dynamic environments and the way of distributing of computation among agents. We consider single valued preference domains in the absence of any trusted center and in the presence of an enforcer. Then we try to design truthful auctions for... 

structures during their service life continually accumulate damage as a result of the action of various environmental forces. Clearly the development of robust techniques for early damage detection is crucial to avoid the possible occurrence of catastrophic structural failure. In a big picture we can divide process into two subcategories: first – we need modal properties of structure. In this case we install several motion sensors on structure and collect their data. Then use a group of methods named as System Identification Process to discover dynamic properties of structure as natural frequencies and mode shapes. Three famous system identification method have been used in this thesis and... 

In this research, multi-disciplinary design optimization (MDO) of a flying vehicle has been done based on the flight simulation. A meta-heuristic algorithm called Multi-objective Adaptive Real-coded Memetic Algorithm (MARCOMA) has been used for optimization. Since solving a MDO problem is a time consuming process, a RBF neural network has been used in the optimization algorithm as a surrogate model. The new algorithm, called MARCOMA+NN, has been tested with some standard benchmarks. MDO problem has six disciplines consists structure, aerodynamic, propulsion, guidance, control, and fire control. The MDO problem has 31 design variables and two objective functions. The objective functions are... 

A cooperative aerial system to defense a Ground Station (GS), against an Incoming aerial Targets (IT) is presented. GS is surrounded by given terrains and a group of homogenous Unmanned Aerial Vehicles (UAVs) are employed using a novel online guidance algorithm in a decentralized manner. The proposed algorithm includes loiter, midcourse and terminal phases. During loiter; UAVs follow an optimal circular path. IT is supposed to approach GS along an optimal low altitude trajectory with respect to the terrains. UAVs are informed the initial position and velocity of IT and they are unaware of IT trajectory. Each UAV decides on whether to engage with IT or not, and shares its decision with other... 

PVDF (polyvinylidene fluoride) magnetic nanocomposite films were prepared by solution casting using two types of nanomagnetic particles: (i) magnetic nanoparticles synthesized by using an alkaline solution of mixed ferrous/ferric salts along with oleic acid as a coating agent at 70˚C; (ii) Fe3O4 nanoparticles prepared by hydrolysis of aqueous solution of ferrous/ferric salts with potassium hydroxide at room temprature. Scanning electron microscopy (SEM) showed that the PVDF magnetic nanocomposite had a porous structure with Fe3O4 nanoparticles dispersed inside the porous polymer matrix. The presence of crystalline magnetite within the polymer matrix was confirmed by X-Ray diffraction method... 

In this project, a method for cooperative search and localization of RF ground moving targets by a group of UAVs is developed. It should be noted that UAVs are just equipped with GPS and directional sensors. Since there is fuel constraint for UAVs, they take fuel from a tanker whenever they require. Moreover, searching method enables the UAVs to see different parts of the desired area with almost uniform distribution. In addition, the proposed approach enables the UAVs to perform a local search with the aim of finding the targets having lost their signal during localization mode. Finally, based upon a fueling decision function the UAVs take turn, approach to the fuel tanker, and start... 

In this research a novel intelligent back-stepping control method is developed. This method is robust to sensor noise and external disturbances. In addition, the controller is robust under model uncertainty. This controller does not need precise knowledge of system parameters. This method is based on three methods of: back-stepping control, least squares estimation and a fuzzy compensator. This controller is used to control quadrotor stand witch is like an inverse pendulum. In quadrotor stand modeling, the inverse pendulum effect is considered too, witch is one of the innovations of the research. By doing various simulations, the validity of controller is tested. Also the performance of the... 

Topic that is investigated in this article include identify and localization a number of aerial target penetrating into a protected by area by a swarm of UAVs is fixed wing. UAVs do not have any prior notice of positioning targets. In addition, it is assumed that lacks any radiation exploitable targets and thus use UAVs for Targets Detection from an active radar system. Obviously this article focus on developing a guidance algorithm UAVs to this particular issue and also as the targets participatory is localization algorithm. In addition, extraction type and performance characteristics radar system required and also performance characteristics of the class of UAVs, which is suitable to... 

The purpose of this paper is to design an integrated controller and observer (ICO) for a nonlinear system using genetic programming. ICO is a function that constructs control command directly from the measured state variables of the system. It means that, this function should imitate the behavior of the observer and controller and control the system with acceptable performance in different initial conditions, at the presence of disturbances and system uncertainties. The complexity of this design method, is not related to the complexity of the plant, in fact, the complexity in plant just effects at run time, but the design procedure does not change. So, if exact model of plant exist, using... 

Nowdays much of the organic solid waste and wastewater is buried using centralized and traditional methods. This leads to many problems, including groundwater pollution, methane emissions into the atmosphere and rapid transmission of disease. In order to avoid these problems, using a decentralized approach can be a good solution. In this study, recovery of organic waste and wastewater of residential buildings using anaerobic digester as a decentralized way, have been examined. Using experiments, the optimum mass ratio of organic solid waste and wastewater is obtained as 80% and 20% respectively. Biogas production model is developed using mass balance and Balance of electrons in redox... 

Multi-disciplinary design optimization (MDO) of a surface to air flying vehicle has been done in this research, on the basis of flight simulation. The MDO problem have five disciplines consists of aerodynamic, propulsion, guidance, control, and fire control. Multiple campaign scenarios are defined. The MDO problem has 31 design variables and two objective functions. The objective functions are flying vehicle weight and miss distance. A new meta-heuristic algorithm has been designed to solve multi-objective optimization problems. The new algorithm has been called Multi-objective Adaptive Real-coded Memetic Algorithm (MARCOMA). The MARCOMA can solve large-scale and multi-objective problems and... 

In this Thesis, an unmanned multicopter with a new structure is modeled and a nonlinear controller is designed for it to track the trajectories precisely. The multicopter in this thesis, has six propellers with a hybrid propulsion system (a combination of fuel and electric propulsion system) that has the ability to carry more payload and maintain more flight duration compared to electric multicopters. In the beginning, the performance characteristics and technical specifications of the hexacopter are presented. For modeling, first the equations of six degrees of freedom movement of the hexacopter are derived by the Newton-Euler method. In the next step, the forces and torques applied to the... 

Understanding of the Molecules is the main purpose of the chemistry. Ab-initio molecular dynamics (AIMD) as a branch of the computational chemistry, tries to give us a deep comprehension of the molecule, and its chemical, physical and optical activities. This comprehension, relies on the accuracy of quantum mechanics, in addition to the speed of the classical mechanics. The mixing of the quantum mechanics and the classical mechanics could simulate activities of the atoms in the time-domain, provided the mixing is done with precaution. This, in turn, helps us to forecast the response of a molecule in different situations, and also translating the macroscopic phenomena in a nanoscopic... 

The aim of the present thesis is to develop a novel heuristic filter by utilizing Firefly Optimization Algorithm for state estimation of nonlinear, non-Gaussian systems. The proposed filter formulates the estimation problem as a dynamic, stochastic one. The swarm intelligence of the fireflies enables the filter to find and track the best estimation. To estimate the states of a system, the model of the system is required. Hence, an 8-DoF quadrotor with slung payload system, as a case study, is modeled by the tensor method. In this case, as a highly nonlinear system, in order not to rely on extra sensors for monitoring swing-angle, the estimation of payload states is needed. In this regard,... 

In this study, a multiple model wind estimator is proposed to detect the wind type and to estimate the wind components as well as the states of a fixed-wing UAV without any direct measurement of the air data. Then, the identified wind model and the estimated states are compensated in the heuristic nonlinear model predictive controller during landing phase. For this purpose, a static multiple model approach is taken, comprised of four independent extended Kalman filters, each one is estimating the wind based on one of the four wind models including a constant wind, a “1-cosine” model, a wind shear and a microburst.Moreover, a new heuristic multiple model filter, called Multiple Model Extended... 

In this thesis a guidance algorithm is developed to control middle phase landing of a quadrotor on a moving platform. Middle phase guidance is consisted of approaching time, speed, and angle constraints. In the first step proportional guidance algorithms was studied. Then a six-freedom model of a quadrotor dynamic was developed. At the next step an appropriate guidance algorithm was developed to control a quadrotor for the mentioned constraints. Finally, the parameters of the algorithm were optimized by numerical methods. Monte-Carlo method used to validate this method. For this reason, 850 numerical simulations with random initial and final conditions were performed and the statistics... 

It is well known that data centres consume high amounts of energy, which has become a major concern in the field of cloud computing. Therefore, energy consumption could be reduced by using intelligent mechanisms work to adapt the set of network components to the total traffic volume. SDN is an efficient way to do so because it has many benefits over traditional approaches, such as centralised management, low capex, flexibility, scalability and virtualisation of network functions. In our work will we use the heuristic energy-aware routing (HEAR) model, which is composed of the proposed heuristic algorithm and the energy-aware routing algorithm. This work identifies the unused links and...