Sharif Digital Repository

The main aim of this study was to improve current efficiency and to obtain thicker coatings via aluminum oxide (Al2O3) addition to the chromium (Cr) (III) bath. Design/methodology/approach ‐ Pure Cr and nanocomposite Cr–Al2O3 coatings were electrodeposited from Cr (III) bath onto cathode copper substrates by conventional method. Dependence of current efficiency to current density, Al2O3 content and particle size were investigated. Findings ‐ Current efficiency increased with Al2O3 amount and decreased with Al2O3 particle size. Maximum current efficiency was achieved at 25 A/dm2 for pure Cr and 30 A/dm2 for composite coatings. Al2O3 bath content, current density and stirring rate increased... 

In this paper we study and evaluate the performance of a spectral-phase encoded optical CDMA (SPE-OCDMA) system using advanced receiver structures based on second harmonic generation (SHG) effect imposed in a Thick or Thin crystal. This receiver structure is employed as the nonlinear pre-processor prior to the conventional low-speed photodetector. In our performance evaluation amplified spontaneous emission (ASE) of the optical amplifiers, receiver front end thermal noise and photodetector shot noise which are effective in low power conditions, and multiple access interference (MAI) noise which is the dominant source of noise in high power conditions in any coherent OCDMA communications... 

In this paper, the authors analyze conditions under which they can be certain on the intensity addition of a given device, such as tapped-delay lines, used in digital incoherent all-optical communication systems. A general expression for phase-induced intensity noise that is applicable to all types of semiconductor lasers is derived by defining an optical self-SNR expression that can be used to analyze and measure phase-induced intensity noise. The result shows that in order to have a minimal phase-induced intensity noise in most digital optical incoherent systems, a large optical self-SNR, e.g., 20 dB or more, is needed. This in turn is shown to place a limit on the maximum rate of... 

Cr and Cr-Al2O3 coatings were electrodeposited from Cr(III) bath with both pulsating and direct current onto copper substrates. Pulsating current resulted in homogeneous films of higher Al2O3 content and lower particle agglomeration than the direct current. Differences were more tangible at shorter duty cycles and pulse frequencies. Pulsating current improved both microhardness and corrosion resistance. The presence of alumina nanoparticles resulted in greater current efficiency, higher film microhardness and better corrosion resistance. Maximum current efficiency, highest microhardness and densest electrodeposited coatings were achieved at current density of 20 A dm-2, duty cycle of 40% and... 

In this paper we study and present an in-depth analysis on the operability and the viability of a typical wireless optical CDMA (OCDMA) local area network. Three receiver structures for OCDMA systems, using optical orthogonal codes (OOC) with minimum auto and cross-correlations as signature sequence, namely, correlation, correlation with hard-limiter, and chip-level detection are studied and proposed for such a network. For the synchronization circuit design the performance of two algorithms for OOC based OCDMA networks, namely, simple serial-search and multiple-shift in the context of wireless OCDMA LAN are studied. Furthermore, we study a synchronization method based on matched filtering... 

In this article, design of an adaptive control scheme for a class of uncertain single-input single-output systems in strict feedback form via a backstepping technique has been proposed. It is assumed that system output and its derivatives are available. By virtue of the observability concept, it is shown that for this class of systems there exists a one-to-one map, which maps output and its derivatives to system states. By means of this mapping and using linearly parametrised approximators, such as fuzzy logic systems or neural networks, the uncertain nonlinear dynamics and unavailable states are estimated. The proposed adaptive controller guarantees that the closed-loop system is uniformly... 

In this paper, an adaptive fuzzy controller, based on backstepping technique, has been proposed for temperature control of a general class of continuous stirred tank reactors (CSTRs). Using the observability concept, an adaptive fuzzy controller using temperature measurement has been designed. A fuzzy logic system is used to estimate the concentration dependent terms and other unknown system parameters appearing in the control law. It is shown that the closed loop system is asymptotically stable and influences of minimum approximation error and external disturbance on the L2 norm of the output tracking error can be attenuated arbitrarily. The performance of the proposed controller has been... 

In this paper, an adaptive fuzzy temperature controller is proposed for a class of continuous stirred tank reactors (CSTRs) based on input-output feedback linearization. Since for control implementation concentrations of all species are needed, based on the observability concept, a fuzzy logic system is used to estimate the concentration dependent terms and other unknown system parameters in the control law, using temperature measurements. It has been shown that the H∞ tracking control performance with a prescribed attenuation level is achieved, by using the proposed controller. Finally the effectiveness of the proposed controller has been demonstrated by applying it to a benchmark chemical... 

In this paper, two nonlinear observer based controllers for temperature control of a continuous stirred tank reactor in which a special class of parallel exothermic reactions take place are proposed. A reduced order nonlinear observer is constructed to estimate the concentration in the reactor. The observer is coupled with two nonlinear controllers, designed based on two well-known techniques, namely input-output linearization and backstepping for controlling the reactor temperature. For dampening the effect of observer error dynamics, a compensating term is used in each control law. The asymptotical stability of the closed-loop system is shown by the Lyapunov's stability theorem. The... 

A novel packet-based photonic label switching router for a multirate all-optical switch using generalized multiprotocol label switching is proposed. The idea is based on using optical code-division multiple access (OCDMA) as multiplexing technique and treating OCDMA codes as labels. The system can coexist with current wavelength division multiplexing systems on the same infrastructure. The concept of switch fabric is introduced. Label processing and label swapping functionalities of the switch are discussed. In-depth analyses are made for spectrally phase-encoded OCDMA (SPE-OCDMA) due to its capabilities of supporting high data rates, large code cardinality, and its secure transmission.... 

Autocorrelation receiver (AcR) is usually used as the general receiver for transmitted reference (TR) communication systems on a quite intuitive basis. In this paper, we apply the principle of statistical invariance to obtain the optimum TR receiver on a decision-theoretic basis, and it is shown that the autocorrelation receiver is optimal only in a special case. Performance of the optimum receiver and the suboptimum AcR for some important modulation schemes is also evaluated. The results imply that allocating a part of the transmitted energy and bandwidth to reference pulses would not help improve the performance of the system and the optimal performance might be achieved via much simpler... 

In this paper, we study theoretically the generation of high repetition rate short pulses using fiber optical parametric amplification. We show that the pulse shape and duration depend on the signal location relatively to the pump frequency. We demonstrate that in order to get the shortest pulse width, the signal must be located at one of the extremities of the gain spectrum associated with the pump peak power. We derive the analytical expression of the pulse shape in this case and compare it to the exponential gain regime case. Using numerical simulations, we also analyze the impact of walk-off and pump phase modulation that is required to suppress Stimulated Brillouin Scattering and derive... 

This paper describes methods used for determining the characteristic acoustic modes and frequencies of a liquid-propellant rocket-motor combustion chamber and effects of radial baffles on the chamber's acoustic field. A multi-point sensing experimental setup, including stationary and moving sensors, was used to measure characteristic frequencies and mode shapes of a combustion chamber. A new technique based on the comparison of signal phase angles from stationary sensors to that of a moving sensor was used to map complex characteristic mode shapes of a combustor. A three-dimensional Helmholtz acoustic solver was also developed using an efficient finite volume approach for complex geometries... 

Turbulence–chemistry interaction models such as the conditional moment closure and various flamelet models require a presumed Probability Density Function (PDF) model of the conditioning variables. In turbulent stratified flames, a joint-PDF model for a reaction progress variable and the mixture fraction is required. The joint-PDF is often modelled by two beta functions using the first and second moments of the two conditioning variables. In this work, the performance of a joint-PDF model based on the flamelet PDF approach is compared to the double beta-PDF model. The conditional PDF of the reaction progress variable conditioned on mixture fraction is modelled with the flamelet PDF. Unlike... 

In this paper we present and investigate a digital design and implementational details of a wireless optical CDMA (OCDMA) system based on generalized optical orthogonal codes (OOCs). A detailed digital implementation analysis and transmitter/receiver architectures in the context of the above design are fully studied. We analyze various subsystems for a wireless OCDMA system including detector and receiver structure, acquisition, and tracking blocks as well as evaluating their performance in a typical wireless OCDMA communication system. By analyzing two main parts of the system, namely, chip-level detector and OCDMA receiver blocks we evaluate the performance of the overall system.... 

In this work, softening kinetics after cold rolling has been simulated using a coupled finite element-cellular automata model. Firstly, a two-dimensional rigid plastic finite element analysis has been developed to assess strain field and the stored energy accumulation during cold rolling as well as the initial condition of the mesoscopic model. Then, the cellular automata scheme has been employed to calculate the progress of static recrystallization at a given temperature while a dislocation-base model was simultaneously utilized to consider the effect of recovery on static softening process and final microstructures. The model has been examined on isothermal annealing of cold rolled AA5052... 

Nowadays, economical extraction of the oil and gas, and their products is an important problem. Up to now, vertical wells have been used for oil extraction but some wells exist that they cannot be reached by using the vertical drilling. Horizontal and directional drillings are some techniques to reach these wells. In this article, dynamics of the horizontal drill string is studied. According to the forces that affect the dynamics of drilling, its longitudinal vibration is analyzed. After determination of the boundary conditions and normal modes of the system with using mode summation method, displacement of the bit is obtained. Finally, dynamics of the horizontal drill string is simulated... 

Due to the low cardinality of optical orthogonal codes (OOCs) with a correlation value of 1, the capability of an internal channel-coding scheme cannot be applied effectively for an increasing number of simultaneous users in a typical fiber-optic code division multiple-access (FO-CDMA) system. In this paper, we consider applying the internal channel-coding scheme to the framed time-hopping (FTH) FO-CDMA system. Due to the extremely high cardinality of the spreading sequence in FTH FO-CDMA, the technique highlights the ability of the internal channel-coding scheme to increase the effective number of users in an FO-CDMA system. For the FTH FO-CDMA system, we only consider a Poisson... 

The effect of NaOH content of electrolyte on the properties of ceramic coatings, produced in silicate solution, was studied. Morphology, chemical analysis, phase composition, and cross-section of the ceramic coatings were investigated by SEM, EDS, XRD, and OM, respectively. The corrosion resistance and corrosion mechanism were also studied using potentiodynamic polarization and electrochemical impedance spectroscopy in a 3.5% NaCl solution. To study the surface roughness, a brightness SEM image analysis method was used. Results suggested that increasing the NaOH concentration of sediment production size causes thickness and coating roughness to decrease. The lowest corrosion rate belonged to...