Sharif Digital Repository

Multiple input multiple output (MIMO) radar is known for its superiority over conventional radar due to its antenna and waveform diversity. However, the increased hardware cost (due to multiple transmitters and receivers), power consumption (due to multiple transmitters and pulses), and computational complexity (due to numerous pulses) form the drawbacks of MIMO radar. On one hand, a higher estimation accuracy is required, but on the other hand, a lower number of active antennas/pulses is desirable. Therefore, in this paper, by proposing a convex optimization approach for the general case of transmitter-receiver-pulse selection, we will minimize the total number of active antennas/pulses in... 

In conventional arrays, improving angular resolution requires larger aperture which demands more number of elements. On the other hand, array thinning is an efficient method of achieving narrow beamwidth (high angular resolution) with fewer number of elements. Reducing the number of elements results in reducing weight, cost, hardware complexity, and energy consumption. In this paper, a novel dynamic programming algorithm of array thinning with the objective of reducing sidelobe levels (SLLs), desired for large circular arrays, is proposed. The circular array is partitioned into annular rings, and the objective of the optimization problem is to determine the number of active elements in each... 

Brushless Doubly Fed Induction Generator (BDFIG) has been recently proposed to be used in variable speed wind turbines. This paper intends to investigate the influence of certain model simplifications to obtain a reduced-order model of a wind turbine with BDFIG suitable for transient studies. To achieve this goal, small signal analysis is performed for a recently manufactured 250 kVA BDFIG to obtain system modes and their participation factors. Identifying highly damped modes, influences of neglecting dynamics of their participated states are studied through time-domain simulation in MATLAB/Simulink  

The use of brushless doubly-fed induction generator has been recently proposed for wind turbines because of its variable speed operation with fractional size converter without the need to brush and slip ring. This paper introduces a control scheme to improve low voltage ride-through capability of doubly-fed induction generator considering grid code requirements. The proposed control strategy is based on analysis of flux linkages and back electromotive forces and intends to retain the control-winding current below the safety limit (typically 2 pu) during severe voltage dips. The time-domain simulations validate effectiveness of the proposed scheme to protect the converter against failure as... 

The use of brushless doubly-fed induction generator has been recently proposed for wind turbines because of its variable speed operation with fractional size converter without the need to brush and slip ring. This paper introduces a control scheme to improve low voltage ride-through capability of doubly-fed induction generator considering grid code requirements. The proposed control strategy is based on analysis of flux linkages and back electromotive forces and intends to retain the control-winding current below the safety limit (typically 2pu) during severe voltage dips. The time-domain simulations validate effectiveness of the proposed scheme to protect the converter against failure as... 

Weighting elements to achieve radiation patterns with desired characteristics is a classical work in phased array antennas. These characteristics can be low sidelobe level, narrow beamwidth, high directivity, pattern nulling in special angle and etc. For each of these characteristics, different methods have been introduced. Most of methods have been presented for uniform arrays, however there are lots of methods to obtain a desired pattern for antennas with non-uniform element distances. The problem with these methods is complexity or not very good results. In this paper, fast and easy methods based on Least Square Error that leads to good results are presented. In addition, weighting of... 

Masking effect is the most important problem in Noise Radars. Recently, some waveform design methods to resolve this problem have been developed, however this paper will show an important fact: 'sidelobe suppression increases the Periodicity of signal and, consequently, decreases unpredictability'. Eventually, an appropriate level for sidelobe reduction is introduced  

The brushless doubly fed induction generator has been proposed for use in wind turbines as a more reliable alternative to the more commonly used doubly fed induction generator. To realize the commercial promises of the brushless doubly fed induction generator in this role, it must meet the existing grid connection codes, particularly with respect to low-voltage ride-through. In this article, the application of series dynamic resistors is proposed to enhance brushless doubly fed induction generator low-voltage ride-through capability, and the required analysis is provided. Three locations for series dynamic resistors are suggested in the brushless doubly fed induction generator circuit and... 

This paper discusses the dynamic behavior of the brushless doubly fed induction generator during the grid faults which lead to a decrease in the generator's terminal voltage. The variation of the fluxes, back EMFs, and currents are analyzed during and after the voltage dip. Furthermore, two alternative approaches are proposed to improve the generator ride-through capability using crowbar and series dynamic resistor circuits. Appropriate values for their resistances are calculated analytically. Finally, the coupled circuit model and the generator's speed and reactive power controllers are simulated to validate the theoretical results and the effectiveness of the proposed solutions. Moreover,... 

The Brushless Doubly-fed Induction Generator (BDFIG) has high potential for wind energy systems, especially for offshore applications where minimum maintenance is vital. The machine low voltage ride through (LVRT) capability in the light of current grid code requirements was investigated using a precise dynamic model. This is particularly important for future multi- MW BDFIGs. This paper shows the necessity for improvements of the BDFIG LVRT capability with presenting a comprehensive analytical study during asymmetrical voltage dips. Analytical studies are conducted to extract a more precise equivalent circuit model of the BDFIG used for analyzing machine dynamic behavior under various fault... 

Compressive sensing (CS) has been widely used in multiple-input-multiple-output (MIMO) radar in recent years. Unlike traditional MIMO radar, detection/estimation of targets in a CS-based MIMO radar is accomplished via sparse recovery. In this article, for a CS-based colocated MIMO radar with linear arrays, we attempt to improve the target detection performance by reducing the coherence of the associated sensing matrix. Our tool in reducing the coherence is the placement of the antennas across the array aperture. In particular, we choose antenna positions within a given grid. Initially, we formalize the position selection problem as finding binary weights for each of the locations. This... 

It is shown that the detection performance can be significantly improved using the recent technology of multiple-input multiple-output (MIMO) radar systems. This is a result of the spatial diversity in such systems due to the viewing of the target from different angles. On the other hand, the moving target indication (MTI) processing has long been known and applied in the traditional pulse radars to detect weak moving targets in the presence of strong clutter signals. The authors propose a procedure based on the compressive sensing idea, in order to apply the MTI processing in a MIMO radar with widely separated antennas. Although a clutter is included in the signal model and a different... 

In this study, the steady-state operation of the brushless doubly-fed machine (BDFM) in various modes is physically elaborated and the active power flow and torque analysis are presented for each operating mode alongside confirmatory experimental results on a 4/8 pole D160 size machine. The machine behaviour in asynchronous operating modes is described similar to the conventional induction machines with corresponding pole numbers. Moreover, its performance in synchronous mode is shown to be similar to synchronous machines. On the basis of the above, the BDFM performance is further analysed under two possible fault conditions: first, a controller or converter fault leading to loss of... 

Target detection in noise radar is always done by computing cross-correlation between transmitted and received signals. In this process, side lobes of a strong target emerge and make some troubles in detection of weak ones (Masking Effect). Therefore, finding methods to suppress this effect becomes important. These methods can be implemented at the transmitter or receiver or at both to achieve more improvement. There are many new methods developed for the receiver side and a few methods applicable at the transmitter side. The main idea of suppressing side lobes at the transmitter is to design a specific noise signal instead of using purely random noise. In this paper we begin with... 

With the rising penetration of wind power into electric power systems, more accurate and comprehensive studies are required to identify the interaction between wind farm(s) and power system. This requires accurate models of different types of wind turbine-generators. This paper describes modeling and small signal analysis of a grid connected fixed speed wind turbine generator (FSWTG). A complete model of FSWTG is derived and some reduced-order models are deduced. Eigenvalues and participation factors of the system for these models are calculated. Then, using the eigen analysis results, the models are compared and the simplifying assumptions which have been considered in the literatures are...