Sharif Digital Repository

In this paper, we have discussed the results of sensitivity analysis in a payoff matrix of the Matching Pennies game. After representing the game as a LP model, the sensitivity analysis of the elements of the payoff matrix is presented. The game value and the optimal strategies for different values of parameters are determined and compared  

In this paper, we have discussed the results of sensitivity analysis in a payoff matrix of the Matching Pennies game. After representing the game as a LP model, the sensitivity analysis of the elements of the payoff matrix is presented. The game value and the optimal strategies for different values of parameters are determined and compared  

TiO2 thin films with mesoporous structure were deposited on quartz substrate by sol-gel dip coating. The structural, morphological and optical properties of the films were characterized by X-ray diffraction (XRD), simultaneous thermal analysis (STA), Fourier transform infrared spectroscopy (FT-IR), Brunauer-Emmett-Teller (BET), atomic force microscopy (AFM), transmission electron microscopy (TEM) and UV/Vis transmittance spectroscopy. Crystallization of the anatase phase was initiated at 300°C. Its transformation to the rutile phase occurred at 700°C. Anatase and rutile crystallites initially sized 3.2 and 15.3nm, respectively. The anatase phase was under tension; but the rutile phase was... 

Pd 2+-doped TiO 2 thin films with mesoporous structure were produced on quartz substrate by sol-gel dip coating. The structural, morphological and optical properties of the film were characterized by X-ray diffraction (XRD), Brunauer-Emmett-Teller (BET), transmission electron microscopy (TEM), atomic force microscopy (AFM) and UV/vis transmittance spectroscopy. By increasing the Pd 2+ concentration from 0 to 6 mol%, the crystallites appeared solely as the anatase phase and their average sizes decreased from 10.5 to 7.1 nm. Addition of Pd 2+ also resulted in increasing of the specific surface area and decreasing of the pore size of the layer. The transmittance of the films decreased in the... 

In this study an expression for soot absorption coefficient is introduced to extend the weighted-sum-of-gray gases data to the furnace medium containing gas-soot mixture in a utility boiler 150 MWe. Heat transfer and temperature distribution of walls and within the furnace space are predicted by zone method technique. Analyses have been done considering both cases of presence and absence of soot particles at 100% load. To validate the proposed soot absorption coefficient, the expression is coupled with the Taylor and Foster's data as well as Truelove's data for CO2-H2O mixture and the total emissivities are calculated and compared with the Truelove's parameters for 3-term and 4-term gray... 

As Gregory Bateson, the British social scientists, once said "You can't live without an eraser", the process of learning is not a unidirectional way toward accumulation of knowledge, rather, organizations should critically evaluate the value of their knowledge and if necessary, actively forget no-longer-useful knowledge. A brief review of related literature shows that the concept of knowledge active forgetting (KAF) is a crucial aspect of organizational learning and knowledge management. However, many aspects of this topic deserve more attention by researchers. The main gap in the literature seems to be related to the linkage between peculiar aspects of knowledge (such as stickiness, context... 

Convective heat transfer plays a significant role in numerous industrial cooling and heating applications. This method of heat transfer can be passively improved by reconfiguring flow passage, fluid thermophysical properties, or boundary conditions. The broader scope of nanotechnology introduced several studies of thermal engineering and heat transfer. Nano-fluids are one of such technology which can be thought of engineered colloidal fluids with nano-sized particles. In the present study, turbulent forced convection heat transfer to nanofluids in an axisymmetric abrupt expansion heat exchanger was investigated experimentally. During heat transfer investigation, the functionalized... 

γ-Alumina is used to catalyze the Cannizzaro reaction in the absence of any base under microwave irradiation in high yields. In the case of terephthalaldehyde the reaction is carried out with high selectivity  

Enolizable ketones have been reacted in a one-pot method with aromatic aldehydes, acetyl chloride and acetonitrile at room temperature in the presence of SnCl4/SiO2 to furnish the corresponding β-acetamidoketones in improved yields. Acetylation of an aromatic hydroxyl group was observed while using 4-hydroxybenzaldehyde or vanillin and the corresponding β-acetamidoketones were isolated in an excellent yield  

The boundary layer integral method is used to investigate the development of the turbulent swirling flow at the entrance region of a conical nozzle. The governing equations in the spherical coordinate system are simplified with the boundary layer assumptions and integrated through the boundary layer. The resulting sets of differential equations are then solved by the fourth-order Adams predictor-corrector method. The free vortex and uniform velocity profiles are applied for the tangential and axial velocities at the inlet region, respectively. Due to the lack of experimental data for swirling flows in converging nozzles, the developed model is validated against the numerical simulations. The... 

The governing equations of two-dimensional steady density currents are solved numerically using a finite volume method. The v2̄-f turbulence model, based on standard k - s model, is used for the turbulence closure. In this method, all Reynolds stress equations are replaced with both a transport equation for v2̄ and an elliptic relaxation equation for f, a parameter closely related to the pressure strain redistribution term. The Simple-C procedure is used for pressure-velocity coupling. In addition, Boussinesq's approximation is used to obtain the momentum equation. The computed height of the progressive density current is compared to the measured data in the literature, resulting in good... 

The deposition behavior of fine sediment is an important phenomenon, and yet unclear to engineers concerned about reservoir sedimentation. An elliptic relaxation turbulence model (v2̄ - f model) has been used to simulate the motion of turbid density currents laden whit fine solid particles. During the last few years, the v2̄ - f turbulence model has become increasingly popular due to its ability to account for near-wall damping without use of damping functions. In addition, it has been proved that the v2̄ - f model to be superior to other RANS methods in many fluid flows where complex flow features are present. Due to low Reynolds number turbulence of turbidity current,(its critical Reynolds... 

In this paper, an analytical solution for steady creeping motion of viscoelastic drop falling through a viscous Newtonian fluid is presented. The Oldroyd-B model is used as the constitutive equation. The analytical solutions for both interior and exterior flows are obtained using the perturbation method. Deborah number and capillary numbers are considered as the perturbation parameters. The effect of viscoelastic properties on drop shape and motion are studied in detail. The previous empirical studies indicated that unlike the Newtonian creeping drop in which the drop shape is exactly spherical, a dimpled shape appears in viscoelastic drops. It is shown that the results of the present... 

In this paper, creeping motion of a viscoelastic drop falling through a Newtonian fluid is investigated experimentally and analytically. A polymeric solution of 0.08 % xanthan gum in 80:20 glycerol/water and silicon oil is implemented as the viscoelastic drop and the bulk viscous fluids, respectively. The shape and motion of falling drops are visualized using a high speed camera. The perturbation technique is employed for both interior and exterior flows, and Deborah and capillary numbers are considered as perturbation parameters up to second order. The product of Deborah and capillary numbers is also used as a perturbation parameter to apply the boundary condition on the deformation on the... 

In this paper, we consider the problem of minimizing the uplink delays of users in a 5G cellular network. Such cellular network is based on a Cloud Radio Access Network (CRAN) architecture with limited fronthaul capacity, where our goal is to minimize delays of all users through an optimal resource allocation. Earlier works minimize average delay of each user assuming same transmit power for all users. Combining Pareto optimization and Markov Decision Process (MDP), we show that every desired balance in the trade-off among infinite-horizon average-reward delays, is achievable by minimizing a properly weighted sum delays. In addition, we solve the problem in two realistic scenarios;... 

Microwave induced Cannizzaro reaction, which was performed in presence of neutral γ-alumina as a polymeric catalyst, was discussed. Cannizzaro reaction was carried out on alumina surface and other unknown products were also obtained. Solvent extraction method was utilized to isolate mild and selective benzyl alcohol and carboxylic acids  

A well known method to reduce the intrinsic complexity of Multiple Input Multiple Output (MIMO) systems is to choose a subset of available antennas which have stronger links than the others, in order to perform the specified MIMO algorithm. The data resulted from the antenna selection process (at the receiver side) is sent back to the transmitter side via a feedback channel. There seems to be a need to reduce the number of feedack bits, specially when the number of antennas is not small. In this paper, we investigate the problem of reducing the number of feedback bits in antenna selection techniques. We've proposed two methods using vector quantization techniques to perform feedback bit... 

Nowadays, deployment of peer-to-peer video streaming systems over wireless mesh networks has attained raising popularity among large number of users around the world. In this paper, we present an efficient peer-to-peer live video streaming architecture over multi-hop wireless mesh networks. In our proposed architecture, we take the physical topology of network into account and based on a distributed distributed locality-aware neighbor selection algorithm in the overlay construction phase, we generate an efficient mesh-based overlay on top of wireless mesh networks. In locality-aware neighbor selection algorithm, instead of choosing randomly, peers find their best neighbors based on their... 

Standard sparse decomposition (with applications in many different areas including compressive sampling) amounts to finding the minimum ℓ 0-norm solution of an underdetermined system of linear equations. In this decomposition, all atoms are treated 'uniformly' for being included or not in the decomposition. However, one may wish to weigh more or less certain atoms, or, assign higher costs to some other atoms to be included in the decomposition. This can happen for example when there is prior information available on each atom. This motivates generalizing the notion of minimal ℓ 0-norm solution to that of minimal weighted ℓ 0-norm solution. On the other hand, relaxing weighted ℓ 0-norm via... 

Precipitation, aggregation, and breakup of asphaltene particles are studied under natural depletion and nitrogen injection processes by means of high pressure filtration and a photographic procedure coupled with image analysis. Filtration results show that nitrogen destabilizes asphaltenes extremely, and the problem is more severe for heavier crude samples. Bimodal histograms of particle size distribution show two agglomeration mechanisms: cluster aggregation dominant around bubble point pressure and diffusion limited far away. The fractal structure of aggregates is also altered by gas injection; it is observed that the flocculent masses grow in size and become more compact and organized...