Sharif Digital Repository

Spent fuel assemblies are kept in spent fuel maintenance pools, designed at the vicinity of the reactor, after consuming. As capacity of these pools are limited, fuel assemblies should be transported to outside of the reactor building for maintenance. Transportation cask is used for this reason which is Russian type, named TUK-13, at Bushehr Nuclear Power Plant. The aim of this project is to ensure proper removal of heat from the transportation cask(TUK-13). For this purpose, numerical computational fluid dynamics method is used. The software used in this study is the Comsol. The temperature range suitable for any part of the chamber is different; but the most sensitive and the most... 

Most marine areas such as bays and lagoons are usually exposed to the high pollution load of their catchment area. Gorgan Bay and Miankaleh Wetland is a connected water body that is subject to the entry of various pollutants through the surrounding agricultural and urban areas, due to the ecological importance of this area and its registration as a biosphere reserve in the United Nations. It is important to control and evaluate its water quality. TSI and NSF-WQI environmental indicators have been used to evaluate the level of water pollution and water quality respectively. TSI and NSF-WQI indices have been evaluated in 8 stations in January and September 2023. The parameters of total... 

Paper and cardboard waste pulping consume large volumes of water, so the discharge of this effluent without proper treatment can have far-reaching environmental consequences. The color and variable COD concentration of wastewater in this industry make treating this wastewater complicated. Therefore, this study aims to reduce the COD of the wastewater treatment plant of a pulp and paper mill under different laboratory conditions to achieve environmental standards in Iran.In this study, coagulation-flocculation and the Fenton process on the wastewater entering the treatment plant were investigated first. It was found that coagulation and flocculation by 750-1250 ppm of alum coagulant and ten... 

The integration of radar and communication functionalities into a unified Joint Radar-Communication (JRC) system offers enhanced spectral efficiency and reduced hardware complexity. Recognized as a key enabler for next-generation wireless networks, JRC systems require a careful balance between radar and communication demands, where waveform design plays a pivotal role in achieving this equilibrium. Although waveform design has been extensively studied separately in radar and communication domains, the requirements of modern networks necessitate a unified approach that simultaneously addresses the needs of both systems. This thesis advances waveform design methodologies for JRC systems,... 

Supply chains are socio-technical engineering systems which now days perform in more uncertain operational environment than before. These systems have been vulnerable because of increasing the number of natural disasters, competitiveness and changing the demand. So these systems in order to be survived in such high uncertain environment need to enhance some capabilities in their structure. In this research by considering an assumed auto supply chain, we try to develop an approach to cover uncertainties in operational environment of this system. At the next step, we use design structure matrix modeling to model the interactions between system elements before and after scenario occurring.... 

Flow analysis in and out of the pressure-swirl injector in supercritical condition is investigated in this thesis. These injectors widely are used in different industries such gas turbine combustion chamber and liquid fuel rockets. Flow simulation in these injectors is so complex because of existence of gas core in axial region and high swirl and axial speeds in injectors. Unlike subcritical condition, droplet and ligament don’t form in supercritical condition so injector performance represents with two parameters including liquid film thickness in vortex chamber and liquid spreading angle. Mass flow, geometric constant, length and the distance between tangential inlet and injector head, are... 

In this experimental study, a series of wind tunnel tests were performed to examine the wake flow profile over three swept wings with sweep angles of 23, 33 and 40 degrees with similar aspect ratio at various conditions. The airfoil of wing was a NACA 6-series airfoil designed to provide a laminar flow on the front half of the airfoil. The tests, made at a mid aerodynamic chord Reynolds number of 8×〖10〗^5, covered an angle of attack range of -2 to 10 degree. The wing tip vortex effects are eliminated by placing an End-plate on the wing tip.The tests were carried out at two main section of wing and two various position from behind of wing. A total pressure rake and transducers was used to... 

In this dissertation, the application of frequency and space diversities in radar target parameter estimation are investigated. On this basis, multi-frequency signal is used to improve the range resolution, array structure is used to increase the angle estimation accuracy and the merger of the multi-frequency signal and array structure are used to increase the maximum number of targets that can be uniquely identified.Considering the desirable properties of multi-frequency signals such as high bandwidth efficiency, high range resolution achievement without chip length decrease and …, there has been increased interest in the vast area of research on the design of such signals that has... 

Target recognition techniques based on micro Doppler phenomenon are popular because they are applicable even on low resolution radars, in contrast to other techniques such as High Resolution Range Profile (HRRP) which need high resolution in range or angle. Usually, main purpose of such techniques is generating robust features against target initial state, velocity, aspect angle, etc. rather than features which exactly identify a target. Main approaches in the literature are based on time-frequency transforms (TFT) such as spectrogram in order to generate features to classify targets, but in this thesis, we propose a totally different method using Recurrence Plot for generating features... 

In this research with Finite Element Methods in ABAQUS, numerical modeling has done in three-dimensions, which can be used to determine the effect of different factors on the surface settlement. Also, various factors such as geotechnical conditions, tunnel diameter,tunnel depth, the impact of the thickness of the segments and the amount of eccentricity of the structure relative to the longitudinal axis of the tunnel considered in this study. Face Pressure Supports, and Grout Injection Pressures are taken into account, too.Tunnel drilling causes a change in the displacement area and creates a changing zone around the tunnel. In this regard, not only adjacent buildings will be affected by... 

Thread the bearing capacity of soil beneath the foundations of the main topics in Engineering is considered that main reason it is the more contact structures. if all the factors that are likely to impact on bearing capacity is more useful to consider more accurate results are obtained. This thesis has tried using FLAC software is a comprehensive review on the soil bearing capacity of foundations under certain conditions of Geotechnical and foundation strip, can be done .The modeling of soil layers and soil bearing capacity based on changes in properties (clay and sandy soils) and changes in depth are examined. The changes in the deep layer of soil and properties of soil, bearing capacity is... 

Proton precession magnetometers are one of the most sensitive scalar magnetic sensors. Their function is based on Zeeman effect and also nuclear magnetic resonance phenomena. In this project we have designed and implemented needed coils, swithching and signal detection circuits. Because of extremely high sensitivity of this sensor to induced noises and also gradient of earth’s magnetic fileld, detection of precession signal needs design of low noise electronic circuits with special EMC considerations. The implemented system in this project contains different blocks, such as switching circuit and its related control unit, amplifier, filter and frequency meter. Using this system, the obtained... 

Effective field theory is a practical method for model building and explaining experimental/observational data. These theories are constructed based on knowing low energy degrees of freedom and symmetries (accidental or fundamental). By construction, these theories are applicable up to a cut-off scale and their predictions beyond that are not reliable. For applications to higher energies a UV completion is needed through which modifications are applied or new heavy degrees of freedom are introduced. In order to complete a theory in a Wilsonian approach, scattering amplitudes must satisfy some constraints. These constraints are derived from basic assumptions like Lorentz invariance,... 

Numerous structures which are involved in seismic soil-pile-structure interaction have been destroyed. Considering complexities which exist in soil-pile interaction problems and lack of precise methods without imperfect bases, it is necessary to use numerical methods for analyzing soil-pile interaction problems. In this research, three-dimensional modeling and studying the effect of changing soil and pile parameters on the behavior of pile under earthquake loading is performed using finite difference software, FLAC3D. The soil in this model has a softening behavior. Real earthquake spectrum has been applied into the model as the acceleration time history at the bedrock level. The results of... 

Titanium nitride-carbon nanocomposites are synthesized by the reaction of TiCl4 and NaN3 in supercritical benzene medium that also serves as a carbon source. In order to improve the crystallinity of the as-prepared precursor (SI), it is further heat-treated at 1000 ˚C for 3-10 h using anhydrous ammonia and UHP nitrogen atmospheres at 1000 ˚C (SIII-SV). Moreover, to improve electrochemical behavior, the synthesized nanocomposite (SIV) is modified with Pt nanoparticles using a polyol process. For better understanding of synthesized catalyst nature and justifying their variant ORR activity several analyses are done. X-ray diffraction (XRD), Raman spectrum, field emission scanning electron... 

Because of the importance of purification units at the refineries, in this research the process of sulfur removing compounds from light naphtha product with 1 ppm concentration by adsorption method in a fixed bed tower was simulated by COMSOL Multiphysics software. In this work, simulation was done using two macro and micro perspectives. In the Macro-scale mass transfer takes place between the spherical particles of catalyst and in the micro-scale mass transfer takes place within the spherical particles and these two scales were coupled together by reaction rate variable. In Macro-scale one-dimensional and two-dimensional geometry were considered for model. Naturally, the result of the... 

This paper investigates the interaction between the beneficiaries of an employee stock option plan within a Stackelberg game framework. The beneficiaries are shareholders and employees. In the proposed model, shareholders, as the leaders of the Stackelberg game, determine the optimal features of employee stock option grants. In response, employees, the followers of the proposed Stackelberg game, maximize their own profits by determining their own effort level by considering that every effort level of employees has an associated cost and expected income for employees. It is assumed that the stock price follow Geometric Brownian Motion process with a known drift rate and volatility. Also, it... 

During the operation of a nuclear power plant, the reactor pressure vessel (RPV) is exposed to a variety of pressure and thermal stresses and neutron radiations. This will cause the loss of the initial strength of the reactor vessel component. During the occurrence of some of accidents, an excessive cooling of the coolant inside the RPV takes place which in the term is called overcooling transients. In addition, in some of these events, a break in a section of the circuit will reduce the water level at the core of the reactor. By reducing the water level, the existing emergency makeup water systems are activated and inject water into the reactor. The temperature of the added water is much... 

Video segmentation means grouping of pixels of the video sequences into spatio-temporal regions which exhibit coherence in both appearance and motion. Due to complexity and spatio-temporal variations, dynamic texture segmentation is a one of the most challenging task in video processing. The problem of dynamic texture segmentation has received considerable attention due to the explosive growth of its applications in video analysis and surveillance systems. In this thesis, two novel approaches have been proposed. The first proposed method is based on generative Dynamic texture models (DTMs) which represent videos as a linear dynamical system. Since DTMs cannot be used for complex videos which... 

The current global economy challenges and the importance of maintaining a sustainable development strategy has increasingly bolded the importance of construction productivity measures. This research describes the results of a running research that is to find the most critical factors affecting the productivity of high rise concrete building projects in developing countries. To achieve that, we have conducted Delphi method in two phases. In the first phase we had a brainstorming program with construction experts from owner organizations, construction contractors and designing engineers to identify factors that have influenced productivity in recent concrete building construction projects.50...