Sharif Digital Repository

This study aimed at using industrial organization approach for banks and the use of models of determining the market structure and the level of competition in Iran’s banking industry. Models of market structure determination are divided into two categories: structural models that are the same as calculation of concentration indices using market share and non-structural models that are the same as revenue-cost nature of economic enterprises. Structural models have been established based on two theories of structure-conduct-performance (SCP) and efficient structure (ES). The difference between these two perspectives depends on the good or bad nature of concentration in banking services market.... 

Open data intermediaries, as the key species of the ecosystem, and since they are the primary consumers of open government data, are crucial to the ecosystem's growth. Without them, the data would be useless during the dissemination phase. This study aims to define the roles of open data intermediaries and explain how they are compatible with the value creation and sustainability of the open data ecosystem in order to fill a gap in the literature in this area. Two Iranian open data intermediaries, Rasmio company and Vinsabt group, which have been involved in the field of data pertaining to companies, have been studied for this purpose. The data for this study is qualitative and was gathered... 

In this study closed cell aluminum foam was manufactured through accumulative roll bonding (ARB). In this method, aluminum AA1050 strip was used as the matrix and calcium carbonate was selected as blowing agent powder. The strips were roll-bonded with reduction of 50% during each pass. The produced composite was then subjected to different foaming conditions in order to achieve foams with maximum porosity. Subsequently, influences of content of the blowing agent, time, pressure, number of rolling passes and heating rate on the percentage of porosities were evaluated. In optimum condition quantity of the blowing agent, foaming temperature, holding time and number of ARB passes were equal to 1... 

Nowadays, According to the improvement of technology, especially in power electronics, electric shipboards are preferred over traditional ones. Better maneuverability, lower emission, higher efficiency and reliability are the most conspicuous merits of this type of ships. Notwithstanding the fact that electric shipboards have many advantages, some serious problems may arise in these ships. Since the thruster motors of these ships are usually induction motors and they are fed by the microgrid of the ship, and taking into ACcount that thruster motors consume a huge amount of the generated power by the synchronous generators, the concept of infinite bus is inexistent in these microgrids. Hence,... 

One way for businesses to grow and compete, in any age (especially the digital age), is to create a Brand Relevance through creating or finding, and then owning new categories or subcategories. In this way, instead of beating competitors; they become irrelevant by enticing customers to buy a new category or subcategory for which other alternative brands are not considered relevant. Firms traditionally rely on interviews and focus groups to identify these subcategories and customer needs. Nowadays, with the growth of social media, user-generated content (UGC) is also a good alternative source. However, Due to the large size of UGC and the non-informative or repetitive data it contains,... 

Double cantilever beam (DCB) specimens were prepared according to standard surface mount technology (SMT). The samples were stored inside an environmental chamber at two different relative humidity values (i.e. 40 or 100%) for either 2 or 4 hours. Then they were aged at 25ºC, 75ºC or 125℃ for the same time. Finally, after being cooled to room temperature, fracture tests were performed under mode-I loading conditions at a strain rate of 0.03 s-1 at room temperature. Storage time did not have a significant effect on the fracture behavior. The fracture load and energy of the solder joints decreased significantly when the temperature was increased from 25 to 75℃. By further increase in the... 

In safe and economic designing of deep foundations for any structure, there are several factors affecting the behavior and response of a pile under seismic loads. These factors can be divided into three main categories: geometrical factors (e.g. Dimensions of the pile, soil, and mesh scheme), material properties (e.g. shear modulus, bulk modulus, soil elasticity, soil density, and shear strength) and earthquake load characteristics (e.g. frequency range, PGA, duration of excitation(. Studying the effects and importance of these factors in the final response of the pile (i.e. ultimate forces and displacements ) can help the design engineers of these foundations to optimize their designs.... 

Subwavelength localization of electromagnetic energy with intense local fields, also known as electromagnetic hotspots, has received significant attention over the past few decades. In most cases the hotspot is achieved through the resonant concentration of electromagnetic fields. One way recently considered to get hotspot is through reflection of electromagnetic waves in nonreciprocal one-way structures, in plasmonics and via magneto optic effect.However these hotspots are less confined compared to hotspots caused by resonances. So combining nonreciprocal structures with resonance can provide better hotspots.Our aim in this thesis is to study nonreciprocal resonant structures using coupled... 

In the first description if we describe technology as a tool, Communication technologies or media should be consider as the most important element of today's technological world. This research is going to cover reconsidering and recreating the mean of media based on the Ideas of JacquesDerrida. In this regard, two major dichotomy is evident in the public understanding of media. meanwhile "media versus message" and on the other hand opposition between "media and audience". So deconstruction in the face of these binary oppositions, want to read out the notion that message is superior to media, and on the other hand to deconstruction of the hegemony of the media on the audience  

A new strategy for enhancing the efficiency of TiO2 dye sensitized solar cells (DSSCs) doped with Ni ions with different molar percentages (i.e., 0, 0.5, 1, 5 and 10 mol%) was reported. The samples were prepared by sol-gel route and characterized by means of XRD, DRS, UV-visible, FESEM and photovoltaic measurment techniques. It was found that Ni-doped TiO2 nanoparticles had a mixture of anatase, rutile and brookite crystal structures. Moreover, the band gap energy was decreased with increasing Ni molar ratio, The highest cell efficiency of 5.4% was achieved for 1mol% Ni-doped TiO2, being 42% greater than that of pure TiO2 nanoparticles