Sharif Digital Repository

In this thesis a general model for simulation of solar cooler for domestic usage is developed. The model consists of 2 main parts: thermo-dynamical and economical calculations. The thermodynamic part consists of 4 sub models: a model for calculation of incoming solar radiation, cooling load demand calculation, the refrigeration cycle and the solar cycle with heat storage.As for hourly calculation of system performance part of the model produces the hourly received radiation data based on geographical position and orientation of the receiving surface. Base on results of the cooling load calculation for a 9 m2 studying room located in western part of Tehran, 1 TBR (3.516 kW) is chosen as... 

Considering problems related to energy, including high fuel prices, increasing demand, constraints, and environmental pollution, makes it clear that efficiency is one of the major problems in all over the world. Iran’s southern parts and those countries around Persian Gulf face serious shortage of drinking water. Moreover, on top of the other three types of energy production the need for drinking water is highly sensible. Therefore, the use of CCHPW System is the best solution in these areas. The purpose of this design is to empower the control capability of the combined systems over all factors and apply the necessary changes under different conditions. This endeavor requires a program to... 

Due to the operation of proton exchange membrane fuel cell (PEMFC), temperature will rise because of the electrochemical reactions and control of temperature is one of the most important sections that has influence on the performance of the fuel cell. In this study three alternative for cooling and controlling the temperature situation is proposed and compared. the experimental setup consists of the simulated fuel cell that produce heat just like PEMFC and number of thermosyphon miniature heat pipes for evoke the heat and three types of condenser that makes three different scenario for this cooling setup. Free convection, force convection using Fan and force convection using circulating... 

In this research, we focus on reduction of solutes in left out water from reverse osmosis membranous units (brine) with reduction of scaling factors of membrane. This research is important from that perspective that the out put brine from reverse osmosis membranous unit After purification by this method, enter into membranous system in order to increase in recovered water volume and also minimization of out put waste from membranous system and decrease the environmental damages. The method used in this research, is three processes of cooling, chemical desalination and seeding by crystal material. In this research is investigated the type and amount of matter for chemical desalination and... 

Today, spark ignition internal combustion engines make up a large percentage of passenger car engines, so their performance improvement is important. Turbocharging of these engines, although is an appropriate method to enhance their specific power and improve their specific fuel consumption, but it has big problems such as the possibility of knock and increasing the NOx emissions in the engine. In this study, resolving these problems is intended by controlling the engine inlet charged air temperature to improve performance of the engine. For this purpose, the investigations are conducted experimentally as well as numerically. The experimental studies are carried out on a turbocharged... 

Often in a vacuum test facility, a supersonic exhaust diffuser uses the energy of the outflow from the nozzle to create and maintain a vacuum condition in the engine test chamber. In this system, the temperature of the motor exhaust gas, which directly hits the diffuser walls, is much higher than the tolerance of the metal body of the diffuser. The purpose of this research is to design a cooling system for thermal protection of diffuser walls of a vacuum simulator using a water-jacket tool. At the beginning of this study, the effective parameters in the design of the water-jacket cooling system were identified. Then, a new algorithm to design and optimize the water-jacket cooling system was... 

Global energy consumption is on a trajectory to surge by 50% by 2050, primarily driven by prevailing energy consumption patterns. Consequently, the imperative to innovate and develop novel energy sources, such as the utilization of recycled waste heat, has become paramount for the foreseeable future. In light of this, this paper delves into the transformative potential of employing Phase Change Materials (PCMs) for cooling Thermoelectric Generators (TEGs) and harnessing waste heat for productive purposes. The research investigates three distinct configurations to evaluate the efficacy of PCMs in enhancing thermal management. Configuration 1 exclusively relies on an active cooling fan, while...