Using Suitable Softwares for Micrositing Calculations in Order to Generate Wind Energy for a Specific Region

, M.Sc. Thesis Sharif University of Technology Saraei, Alireza (Author) ; Abbaspour, Majid (Supervisor) ; Mozaffari, Ali Asghar (Supervisor)

Abstract

Because of advantages of using new sources of energy in the country, especially for generating green energy, the use of wind energy for power generating in wind Fields is of great interest of current communities. For developing a wind power plant the first step is to locate and confirm the areas which possess enough potential for installing the wind turbines. For this purpose in the first chapter of this thesis an introduction to the basic principles of wind energy is noted then in the next chapter the physical relations to calculate the estimated reachable energy in the area is mentioned and in the third chapter the empirical methods for selection of the suitable sites are exhibited .in the...

Simulation of Flow around Building for Using Small wind Turbine in Urban Areas

, M.Sc. Thesis Sharif University of Technology Sharifi, Pooria (Author) ; Boroushaki, Mehrdad (Supervisor) ; Avami, Akram (Supervisor)

Abstract

Wind is one of the clean energies available in the world which its damage to the environment is less than other renewable resources. One of technologies of generating energy from wind is the small turbines installed in city area. However, installing these turbines in cities may encounter with problems such as low speed of wind and high turbulence in the air causing aero-dynamic noise. If the turbines are installed in a bad place in cities, their electricity generation might be zero. Among important parameters that affect the performance of the turbines installed in the roof is the formation of the building, the buildings around, and the location of wind turbine. If the buildings’...

Selection of a Proper Methodology and Field Activity for Micrositing of Wind Energy Production for a Selected Site

, M.Sc. Thesis Sharif University of Technology Feizpour, Mahmood (Author) ; Abbaspour, Majid (Supervisor) ; Mozaffari, Ali Asghar (Supervisor)

Abstract

Because of advantages of using new sources of energy in the country, especially for generating green energy, the use of wind energy for power generating in wind Fields is of great interest of current communities. For developing a wind power plant the first step is to locate and confirm the areas which possess enough potential for installing the wind turbines. For this purpose in the first and second chapters of this thesis an introduction to the basic principles of wind energy is noted then in the third chaptermethods of grid connection, conversion systems and turnover problems in windfarm is evaluated.in the fourth chapter with the use of Windographer software and empirical data of standard...

in Partial Fulfilment of the Requirements for the Degree of Master of Engineering Faculty of Civil Engineering, Department of Water and Environmental Engineering Sharif University of Technology

, M.Sc. Thesis Sharif University of Technology Rezaee, Ehsan (Author) ; Arhami, Mohammad (Supervisor) ; Abrishamchi, Ahmad (Co-Advisor)

Abstract

Oil and gas industries are always considered as one of the most polluting industries in the world. Many pollutants are emitted from the industry into the environment every year. Equipment’s leak and flaring off additional gases produced by various processes of oil and gas production are the main sources of waste in these industries. In order to control these hazardous wastes, it is necessary to provide effective solutions and make appropriate decisions so policymakers will be able to implement policies in order to reduce the emissions of air pollutants. In order to reduce the emissions, it is necessary to conduct the correct and reliable methods and have sufficient information about the...

Emission Mitigation Strategies for Combustion Sources

, M.Sc. Thesis Sharif University of Technology Naseri, Kasra (Author) ; Arhami, Mohammad (Supervisor) ; Abrishamchi, Ahmad (Co-Supervisor) ; Azarmi, Farhad (Co-Supervisor)

Abstract

Scientific studies, conducted over the world, show that an immense portion of pollutants and greenhouse gases emission to the atmosphere are the direct result of the incineration of fossil fuels in industrial units. These industrial units include chemical industries, power plants, metal industry, etc. Therefore, there is a tremendous necessity to reduce the pollutants emission from these industries immediately and effectively. Meanwhile, in order to mitigate the emission to the atmosphere, there should be a meticulous estimation of pollutants emission from various sources. Hence, in a project called "standardization of emission of pollutants from diverse industrial units in Iran", the...