Loading...

Pore-level influence of micro-fracture parameters on visco-capillary behavior of two-phase displacements in porous media

Rokhforouz, M. R ; Sharif University of Technology | 2018

773 Viewed
  1. Type of Document: Article
  2. DOI: 10.1016/j.advwatres.2018.01.030
  3. Publisher: Elsevier Ltd , 2018
  4. Abstract:
  5. In this work, coupled Cahn–Hilliard phase field and Navier–Stokes equations were solved using finite element method to address the effects of micro-fracture and its characterizations on water-oil displacements in a heterogeneous porous medium. Sensitivity studies at a wide range of viscosity ratios (M) and capillary numbers (Ca), and the resultant log Ca–log M stability phase diagram, revealed that in both media, with/without fracture, the three regimes of viscous fingering, capillary fingering and stable displacement similarly occur. However, presence of the fracture caused water channeling phenomenon which resulted in reduction of the number of active fingers and hence the final oil recovery factor. At high Ca (especially in the stable regime, with log Ca ≥ −2.5 and log M ≥ 0), recovery factor for the fractured medium was relatively identical with the non-fractured one. At log M ≥ 0, the fracture was fully swept, but flow instabilities were observed inside the fracture at lower M values, especially for log Ca > −4.6. In the case of the fractured medium at log Ca = −4.6 and log M = 0 (capillary dominant flow), it is observed that the primary breakthrough took place by a finger progressed through the matrix, not those channeled through the fracture. Geometrical properties of the fracture, including length, aperture and orientation, highly affected both displacement profile and efficiency. The fracture length inversely influenced the oil recovery factor. It was observed that there is a critical fracture width (almost half of the medium average pore diameter) at which the recovery factor of the medium during displacement is minimum, compared to the media having thinner and thicker fractures. Minor channeling effect in the media with thinner fracture and larger fracture swept volume as well as high fracture/matrix cross flow in the media with thicker fracture were detected as the main cause of this non-monotonic behavior. In the models with thick fractures (with the thickness higher than the average pore diameter), considerable trapped oil volumes were observed inside the fracture at low M values. The fracture orientation had the most impressive effect on oil recovery compared to the other studied parameters; where the oil recovery factor incremented more than 20% as the fracture rotated 90° from flow direction. Due to the dominant effect of the channeling phenomenon, the change in the medium wettability from slightly oil-wet to slightly water-wet, did not considerably affect the displacement profile in the fractured medium. However, oil recovery factor increased as the medium became more water-wet. The fracture area was fully swept by the injected water in the oil-wet and neutral-wet media. However, flow instabilities were observed inside the fracture of the water-wet medium due to counter-current imbibition between fracture/matrix. Micro-scale mechanisms of pore doublet effect, interface coalesce, snap-off and reverse movements were captured during the studied unstable displacements. © 2018 Elsevier Ltd
  6. Keywords:
  7. Capillary fingering ; Fractured porous medium ; Phase-field method ; Viscous fingering ; Wettability ; Calcium ; Finite element method ; Fracture ; Navier Stokes equations ; Oil well flooding ; Phase transitions ; Porous materials ; Wetting ; Counter-current imbibition ; Fracture orientations ; Heterogeneous porous medium ; Phase field methods ; Two-phase displacements ; Two phase flow ; Capillarity ; Enhanced oil recovery ; Geometry ; Navier-Stokes equations ; Porous medium ; Viscosity ; Viscous flow
  8. Source: Advances in Water Resources ; Volume 113 , 2018 , Pages 260-271 ; 03091708 (ISSN)
  9. URL: https://www.sciencedirect.com/science/article/pii/S0309170817309351