Sharif Digital Repository

In performance-based geotechnical earthquake engineering, the required degree and spatial extent of ground densification for mitigation of liquefaction beneath a structure should be determined based on the acceptable levels of performance of foundation. Currently, there is no solution for evaluation of the amount of settlement and tilt of footings constructed on a densified ground which is surrounded by a liquefiable soil. This implies the need for numerical procedures for simulation of seismic behavior of shallow foundations supported on both liquefiable and densified subsoil. In this paper, the dynamic response of shallow foundations on a densified ground is studied using a 3D fully... 

In the current research, the main concern is to verify the behavior of gravelly soils. To that matter, with taking use of CU triaxial tests and variations in parameters of interest, gradation, relative density, isotropic pressure and anisotropy of consolidation during the tests, the effects on the steady state condition and monotonic liquefaction of gravelly soils are investigated. The test results indicated that as the isotropic pressure increases, percentage increase of steady state strength resulting from the increase of relative density will decrease. Moreover, with the increase of anisotropy of consolidation, the effect of relative density on steady state strength and built-up pore... 

Standard Penetration Test (SPT) is the most commonly used insitu test for soil characterization, including the liquefaction resistance. Many studies have sought to correlate SPT number to cyclic resistance ratio (CRR) as a frequently-used approach for assessment of liquefaction potential. However, it has been shown that SPT has major deficiencies (e.g., inaccuracy in coarse sands and clays) which have given rise to development and utilization of new characterization methods such as geophysical tests (e.g., down-hole and cross-hole). In this paper, a comparison is made between the results of SPT and geophysical tests in three boreholes through the body and foundation of Mahabad Dam (located... 

A fully coupled numerical analysis using Biot's theory with u-p formulation considering variable permeability during liquefaction is used in this study to simulate liquefaction induced lateral spreading phenomenon. A centrifuge test performed on liquefiable soil at Rensselaer Polytechnic Institute is simulated using the developed model. The numerical results are in good agreement with experimental observations. A number of numerical simulations under different geometric, site-specific, and ground acceleration parameters have been carried out in the course of this study. Based on the statistical analysis conducted on the results of 31 different models, a new relation is proposed for... 

Several methods have been used for the evaluation of liquefaction potential, among which the simplified method is mostly used. In this method, which is mainly based on standard penetration test (SPT), cone penetration test (CPT) and shear wave velocity (Vs) measurement, a boundary curve is provided to separate the liquefiable and non-liquefiable soil zones. Vs measurement is a good alternative method of penetration-based methods (SPT and CPT). This is especially true in micro-zonation of liquefaction potential. Although relatively large studies have been carried out to establish the correlation between Vs and liquefaction resistance for sands; there are uncertainties about the effects of... 

Performance-based design (PBD) has become increasingly important in recent years, especially for the design of foundations rested on sub-soils that are susceptible to liquefaction at seismically active areas. Shallow foundations may fail due to excessive settlement because of liquefaction of the underlying loose saturated cohesion-less sands. Building codes usually do not address the issue of liquefaction-induced settlement of shallow foundations. In this paper, a framework is proposed for calculating the liquefaction-induced settlement of shallow foundations resting on heterogeneous two-layered liquefiable soil by conducting a series of 3D. hydro-mechanical dynamic analyses in a fully... 

The use of shear wave velocity (Vs) measurements as an in situ test for evaluation of liquefaction potential has increased substantially due to its advantages. Relatively large numbers of studies have been performed to establish the correlation between Vs and liquefaction resistance (CRR) of clean sands. Usually, natural sands contain silt and/or clay, and previous studies have shown that both the amount of fines and their nature influence the values of CRR as well as Vs. Therefore, the CRR–Vs correlations may also be affected by fines content and type of sandy soils. However, effect of fines content and especially fines type of sandy soils on the correlation between Vs and CRR is... 

Geotechnical design codes have been shifted from classical limit equilibrium analysis toward the performance-based procedures. In foundation design, settlement is the most representative parameter for its performance. Settlement of shallow foundations subjected to earthquake loading and its consequences is one of the most outstanding issues which should be considered in designing different structures. In this study, settlement of shallow footing on two-layered subsoil strata under earthquake loading is of concern. The numerical study presented in this research by means of a 3D dynamic fully coupled u-p analysis, addresses the effect of different parameters on shallow foundation settlement... 

The volume change that occurs due to membrane penetration into peripheral voids of gravelly specimens during hydrostatic compression test in a conventional triaxial apparatus is studied by performing a set of hydrostatic compression tests on gravelly specimens with different initial relative densities. During the isotropic loading on the specimens, the total volume changes of the specimens were determined by measuring the amount of water seeping out of the specimens at different loading steps. Image processing technique was implemented simultaneously to determine the skeletal volume changes of the specimens. In this regard specimens were compressed to isotopic pressures from 10 to 500 kPa... 

During recent years, extensive studies have been conducted around the world documenting liquefaction induced lateral spreading and its effects on deep foundations. This study is aimed to numerically model a shaking table experiment, to investigate the effect of lateral spreading on piles and also to assess the capability of an advanced critical state two-surface plasticity model in predicting soil and pile responses to lateral spreading. Changes in permeability of the soil layers during the shaking are also accounted for using the software's built-in programming language, FISH. Numerical results showed that the onset of liquefaction occurs after just a few cycles from the beginning of the... 

Numerical analyses of liquefiable sand are presented in this paper. Liquefaction phenomenon is an undrained response of saturated sandy soils when they are subjected to static or dynamic loads. A fully coupled dynamic computer code is developed to predict the liquefaction potential of a saturated sandy layer. Coupled dynamic field equations of extended Biot's theory with u-P formulation are used to determine the responses of pore fluid and soil skeleton. Generalized Newmark method is employed for integration in time. The soil behavior is modelled by two constitutive models; a critical state two-surface plasticity model, and a densification model. A class 'B' analysis of a centrifuge... 

Liquefaction-induced lateral spreading caused severe damages to pile foundations during past earthquakes. Micropiles can be used as a mitigation strategy against lateral spreading e ects on pile foundations. However, the available knowledge about the possible efficiency of this strategy is quite limited. In this regard, the present study aims to evaluate the e ectiveness of a vertical micropile system as a lateral spreading countermeasure using large-scale 1 g shake table tests on 3 x 3 pile groups. The results showed that the micropile system was not able to e ectively reduce the bending moments in piles; however, it considerably reduced the lateral soil pressures exerted on the upslope... 

The application of the simplified method for evaluating the liquefaction potential based on shear wave velocity measurements has increased substantially due to its advantages, especially for microzonation of liquefaction potential. In the simplified method, a curve is proposed to correlate the cyclic resistance ratio (CRR) with overburden stress-corrected shear wave velocity (Vs1). However, the uniqueness of this curve for all types of soils is questionable. The objective of this research is to study whether the correlation between CRR and Vs1 is unique or not. Besides, the necessity of developing the soil-specific correlations is also investigated. Based on laboratory test data, a new... 

Soils have an anisotropic response, and changing the inclination (α) and magnitude of the major principal stress will affect collapse potential and brittleness, as well as shear strength and shear stiffness. In this paper, the effect of the stress path, with changes in intermediate principal stress, on the dynamic behavior of Babolsar sand, is studied. A series of undrained monotonic and cyclic tests on loose sand with induced anisotropy were conducted by using automatic hollow cylinder apparatus. Special attention was paid to the significant role of the intermediate principal stress parameter (b) in the deformation behavior of the sand during cyclic loading. Results show that at constant α,... 

Liquefaction-induced lateral spreading has imposed severe damages to many important structures supported on pile foundations during past earthquakes. As a result, evaluation of pile response to lateral spreading is an important step towards safe and resistant design of pile foundations against this destructive phenomenon. Current paper aims to study the response of a group of piles subjected to liquefaction-induced lateral spreading using a large scale 1-g shake table test. General test results including time-histories of accelerations, pore water pressures, displacements and bending moments are presented and discussed in this paper. In addition, distribution of lateral soil pressure on... 

Abstract Lateral Spreading, which usually occurs as a consequence of liquefaction in gently sloped loose saturated sand layers, is known to be a major source of earthquake-induced damages to structures such as quay walls, bridge piers, pipelines, and highway/railways. Therefore evaluation of the liquefaction potential and using appropriate methods for prediction of the adverse consequences of lateral spreading is of great importance. In this study, numerical modeling has been used to study lateral spreading phenomenon behind rigid waterfront structures. Coupled dynamic field equations of the extended Biot's theory with u-P formulation are used for simulating the phenomenon. A fully coupled... 

It is well established that the main mechanism for the occurrence of liquefaction under seismic loading conditions is the generation of excess pore water pressure. The growth of the excess pore water pressure of saturated sand is dependent on several factors. Changing the inclination and magnitude of the major principal stress with respect to the depositional direction in most cases will increase the collapse potential and brittleness as well as reduce the shear strength and shear stiffness. An experimental program was carried out to study the variation of pore water pressure of cross-anisotropic deposits under anisotropic cyclic loading. A total of 30 undrained cyclic tests were performed... 

Occurrence of liquefaction in saturated sand deposits underlying foundation of structure can cause a wide range of structural damages starting from minor settlement, and ending to general failure due to loss of bearing capacity. If the bearing capacity failure is not the problem, reliable estimation of the liquefaction-induced settlement will be of prime importance in assessment of the overall performance of the structure. Currently, there are few procedures with limited application in practice for estimation of settlement of foundations on liquefied ground. Therefore, development of a general relationship is important from the practical viewpoint. In this paper, the dynamic response of... 

The lateral movement of a liquefiable soil layer on gentle slopes is the most visible and devastating type of liquefaction-induced ground failure. Recent earthquakes have shown that this phenomenon causes severe damages to coastal structures, pier of the bridges and life-lines by exerting large lateral forces on the structures. In this paper coupled dynamic field equations of extended Biot's theory with u-p formulation are used for simulating the phenomenon and the soil behavior is modeled by a critical state two-surface plasticity model for sands. Furthermore, in this study variation of permeability coefficient during liquefaction is taken into account. The permeability coefficient is... 

Liquefaction is one of the most serious geotechnical hazards that may cause irreparable and financial damages. Based on in-situ testing results, several methods have been developed to evaluate the liquefaction potential. Due to continuous and repeated records, the piezocone (CPTu) has gained wide acceptance among other in-situ tests in geotechnical practice. In this paper, a new approach is proposed for liquefaction potential evaluation based on CPTu results. The new approach is verified by ten CPTu soundings (case histories) derived from different sites. By analyzing the liquefied sites, an area on the soil classification charts was introduced in this paper, showing the soil types which are...