Sharif Digital Repository

An intense decrease in cycling performance and safety is a challenge for elevated temperature application of LiNi0.5Co0.2Mn0.3O2 (NCM) cathode material. In this paper, effect of two types of nano-coatings on improvement of elevated temperature performance of NCM cathode material has been investigated. One of the coatings contains SiO2 nanoparticles and the other one contains composite of reduced graphene oxide and SiO2 nanoparticles (rGO-SiO2). The coatings were fabricated by a facile wet chemical method. The SiO2 coated cathode material showed an excellent elevated temperature cycling stability, however, a decrease in discharge capacity and rate capability of this sample was observed. On... 

Acidizing of carbonate oil-wet rocks saturated with oil and saline formation water is subjected failure in some cases due to acid-induced damage such as sludge and emulsion formations. This condition may also lead to mineral precipitation, oil film barrier between acid and rock and diversion chemical malfunctions. Therefore, pre-flush process has been proposed as one of the most efficient stage for oil-wells matrix acidizing to reduce these challenges significantly. Besides, the pre-flush stage would result in more clean rock as the reservoir fluids are pushed back from the near wellbore regions, restoring rock wettability to more water wet state, preventing direct acid-oil contact and... 

In this study the bioleaching of a low-grade uranium ore containing 480 ppm uranium has been reported. The studies involved extraction of uranium using Acidithiobacillus ferrooxidans derived from the uranium mine samples. The maximum specific growth rate (μ max) and doubling time (t d) were obtained 0.08 h-1 and 8.66 h, respectively. Parameters such as Fe2+ concentration, particle size, temperature and pH were optimized. The effect of pulp density (PD) was also studied. Maximum uranium bio-dissolution of 100 ± 5 % was achieved under the conditions of pH 2.0, 5 % PD and 35 °C in 48 h with the particles of d 80 = 100 μm. The optimum concentration of supplementary Fe2+ was dependent to the PD.... 

In this work, phase evolution, solid solution formation and diffusion behavior of three binary systems, including TaC-HfC, TaC-ZrC and HfC-ZrC, were investigated. In this regard, pure carbide powders of TaC, HfC, and ZrC were selected as starting raw materials. The prepared samples were heat treated at 2000 C for 1 hour in Ar atmosphere. For each system, three compositions were chosen for phase evolution investigation by X-ray diffractometer. Moreover, three couple samples were prepared for diffusion behavior survey through SEM/EDX analyses. It was found that ZrC diffuses faster in TaC structure rather than HfC and a single phase solid solution phase with hosting TaC is formed in TaC-HfC and... 

One of the key factors in drug's efficacy is the value of their bioavailability that increases by the reduction of particle size through improvement of dissolution rate. In this study, raloxifene particle size was reduced by Rapid Expansion of Supercritical Solution (RESS). The effect of extraction temperature (40-80 °C), extraction pressure (10-18 MPa) and spray distance (5-10 cm) were investigated on size and particle size distribution of the nanoparticles. Particles were characterized using X-ray diffraction (XRD), Fourier Transform Infrared Analysis (FTIR), Differential Scanning Calorimetry (DSC), Scanning Electron Microscopy (SEM) and Dynamic Light Scattering (DLS). The average size of... 

Dissolution pressure and nozzle temperature effects on particle size and distribution were investigated for RESS (Rapid Expansion of Supercritical Solution) process. Supercritical CO2 was used as solvent and Ibuprofen was applied as the model component in all runs. The resulting Ibuprofen nano-particles (about 50 nm in optimized runs) were analyzed by SEM and laser diffraction particle size analyzer systems. Results show that in low supercritical pressure ranges, depending on the solvent and solid component properties (Lower than 105 bar for Ibuprofen-CO2 system), nozzle temperature should be as low as possible (80-90 °C for Ibuprofen-CO2 system). In the other hand in high supercritical... 

Kinetics of dissolution of silver present in precious metal scraps in HNO3 was studied in temperature range of 26-85°C. Dissolution rate of silver was much faster than that of copper at all temperatures. Effects of particle size, stirring speed, acid concentration and temperature on the rate of dissolving of silver were evaluated. Dissolution rate decreases with particle size and increases with temperature. Dissolving was accelerated with acid concentrations less than 10 mol/L, Concentrations greater than 10 mol/L resulted in slowing down of the dissolution rate. Shrinking core model with internal diffusion equation t/τ = 1 - 3 (1-x)2/3 + 2 (1-x) could be used to explain the mechanism of the...