Sharif Digital Repository

A high silica CHA-type membrane was synthesized by the in-situ crystallization method on a disk like α-alumina porous support to separate both acid (H2S, CO2) gases from methane. The membrane showed a permeance of 3.39×10-8mol/m2sPa for pure CO2with CO2/CH4 ideal selectivity of 21.6 at 303K and 100kPa pressure difference across the membrane. The membrane was also tested with N2 and O2 pure gases indicating a small O2/N2 selectivity of 1.2-1.4, which shows that this type of membrane is not suitable for O2/N2 separation. The membrane performance was also analyzed by binary (CO2-CH4) and ternary (H2S-CO2-CH4) gas mixtures, with compositions near the real sour natural gas (CO2: 2.13mol%, H2S:... 

The details of the crystal structure of the recently discovered Y 3Ba5Cu8O18+δ (Y358) superconductor have been determined by ab initio density functional theory. Total energy calculation has been performed for three different suggested structures with different oxygen content. The structure with a center of inversion symmetry and the highest oxygen concentration has the lowest total energy. Thus, it is the best choice for the Y358 crystal structure. By investigating the detailed structure, it is seen that this compound is arranged either of YBa2Cu3O7 and YBaCu2O 5 or YBaCu2O5 and BaCuO2 substructural blocks in the c direction. The difference between the total energy of Y358 compound and the... 

Titanium(IV) tetraisopropoxide was employed as a metal oxide sol-gel precursor to prepare ceramic composite nanofibers by the electrospinning system. To facilitate this process and obtain the desired nanofibers with higher aspect ratios and surface area, poly(vinylpyrrolidone) was added to the sol of titania. Four ceramic nanofibers sheets based on titania were prepared while each sheet contained different transition metals such as Fe-Mn, Fe-Ni, Fe-Co, and Fe-Mn-Co-Ni. The scanning electron microscope images showed good homogeneity for all the prepared ceramic composites with a diameter range of 100-250 nm. The sorption efficiency was investigated by a micro-solid-phase extraction setup in... 

Phase separation is one of the common methods for fabrication of polymeric membrane, which classifies into the categories of Thermally Induced Phase Separation (TIPS) and Nonsolvent Induced Phase Separation (NIPS), i.e. heat and mass transfer induced phase separation, respectively. NIPS has been applied more commonly than TIPS, but the membranes which have resulted from this technique have macro finger-like voids, weak mechanical strength and not high separation ability in comparison with the TIPS. In contrast, membranes produced by the TIPS method have micro scale pores, high mechanical strength and also high separation capability, however, polymeric solutions prepared at high temperatures... 

A novel Fe3O4-poly(aniline-naphthylamine)-based nanocomposite was synthesized by chemical oxidative polymerization process as a magnetic sorbent for micro solid phase extraction. The scanning electron microscopy images of the synthesized nanocomposite revealed that the copolymer posses a porous structure with diameters less than 50nm. The extraction efficiency of this sorbent was examined by isolation of rhodamine B, a mutagenic and carcinogenic dye, from aquatic media in dispersion mode. Among different synthesized polymers, Fe3O4/poly(aniline-naphthylamine) nanocomposite showed a prominent efficiency. Parameters including the desorption solvent, amount of sorbent, desorption time, sample... 

A novel high-throughput device based on 96-micro-solid phase extraction (96-μ-SPE) system was constructed for multiresidue determination of nine pesticides in aquatic samples. The extraction procedure was performed on a commercially available 96-well plate system. The extraction module consisted of 96 pieces of 1cm×3cm of cylindrically shaped stainless steel meshes. The prepared meshes were fixed in a home-made polytetrafluoroethylene-based constructed ninety-six holes block for possible simultaneous immersion of meshes into the center of individual wells. Dodecyl methacrylate and ethylene glycol dimethacrylate was copolymerized as a monolithic polymer and placed in the cylindrically shaped... 

Multivariate curve resolution-particle swarm optimization (MCR-PSO) algorithm is proposed to exploit pure chromatographic and spectroscopic information from multi-component hyphenated chromatographic signals. This new MCR method is based on rotation of mathematically unique PCA solutions into the chemically meaningful MCR solutions. To obtain a proper rotation matrix, an objective function based on non-fulfillment of constraints is defined and is optimized using particle swarm optimization (PSO) algorithm. Initial values of rotation matrix are calculated using local rank analysis and heuristic evolving latent projection (HELP) method. The ability of MCR-PSO in resolving the chromatographic... 

In this study, TiO 2-SiO 2 nanocomposite films with different amounts of SiO 2 were prepared by sol-gel process and were coated onto stainless steel 316L. The effect of addition of various amount of SiO 2 in the precursor solution on the photocatalysis, photo-generated hydrophilicity and self-cleaning property of TiO 2 thin films was investigated by X-ray diffraction, Fourier transform infrared spectroscopy, water contact angle measurements and UV spectroscopy. In the tested ranges of SiO 2 content and sintering temperature, the highest photocatalytic activity and self-cleaning property were observed in the 15 mol% SiO 2 sample sintered at 750 °C. Addition of less than 30 mol% SiO 2 had a... 

Formation of transparent glass-ceramic in the system MgO-SiO 2-Al 2O 3-K 2O-B 2O 3-F with and without addition of LiF and NaF has been investigated. Crystallization of glass-sample was conducted by controlled thermal heat-treatment, at determined nucleation and crystallization temperatures. In this regard, the effects of addition of LiF and NaF were investigated on the crystallization behavior and transparency of the samples. Low transmission (less than 80% at 600. nm) was observed in the basic composition (K).The addition of NaF and LiF caused more intense phase separation in the system. The results indicated that the glass-ceramic can remain transparent if fine grains with nano size are... 

A high-order compact finite-difference lattice Boltzmann method (CFDLBM) is extended and applied to accurately simulate two-phase liquid-vapor flows with high density ratios. Herein, the He-Shan-Doolen-type lattice Boltzmann multiphase model is used and the spatial derivatives in the resulting equations are discretized by using the fourth-order compact finite-difference scheme and the temporal term is discretized with the fourth-order Runge-Kutta scheme to provide an accurate and efficient two-phase flow solver. A high-order spectral-type low-pass compact nonlinear filter is used to regularize the numerical solution and remove spurious waves generated by flow nonlinearities in smooth regions... 

A nanocomposite of silica-polydiphenylamine doped with silver nanoparticles (Ag-SiO2-PDPA) was successfully synthesized by the sol-gel process. For its preparation, PDPA was mixed with butanethiol capped Ag nanoparticles (NPs) and added to the silica sol solution. The Ag NPs were stabilized as a result of their adsorption on the SiO2 spheres. The surface characteristic of nanocomposite was investigated using scanning electron microscopy (SEM). In this work the Ag-SiO2-PDPA nanocomposite was employed as an efficient sorbent for micro-solid-phase extraction (μ-SPE) of some selected pesticides. An amount of 15 mg of the prepared sorbent was used to extract and... 

The extraction and purification of lipids from the microalgae Chlorella vulgaris have been investigated. First, a mixture of hexane and ethanol was used to extract lipids from the algal biomass. Ultrasonication was employed to disrupt the cell wall and increase the extraction performance. Under these conditions, over 90% of the fatty acids in the biomass were extracted. Second, a biphasic system was formed by adding water and hexane to the extracted crude oil. In this way, fatty acids were mainly distributed in the organic phase (mostly hexane and ethanol) while most of the contaminants remained in the aqueous phase (mostly water and ethanol). Equilibrium distribution data between the phases... 

An attempt was made to combine μ-solid phase extraction and headspace single drop microextraction techniques and use their advantages for trace determination of some volatile organic compounds in aqueous samples. After performing the two-step preconcentration approach, the desired analytes were determined by gas chromatography-mass spectrometry. A resorcinol-formaldehyde-based xerogel was used as the extraction medium in the μ-solid phase extraction (μ-SPE) method. Then, the extracted BTEX was eluted with a rather large amount of methanol. To remove the laborious process including solvent evaporation and further reconstitution, which is usually accompanied by loss of analytes and accuracy,... 

In this study, organic aerogels were synthesized by the sol-gel polycondensation of mixed cresol with formaldehyde in a slightly basic aqueous solution. Carbon aerogels and xerogels are generated by pyrolysis of organic aerogels. The novel sol-gel-based micro-solid-phase extraction sorbent, resorcinol-formaldehyde xerogel, was employed for preconcentration of some selected herbicides. Three herbicides of the aryloxyphenoxypropionate group, clodinafop-propargyl, haloxyfop-etotyl, and fenoxaprop-P-ethyl, were extracted from aqueous samples by micro-solid-phase extraction and subsequently determined by gas chromatography with mass spectrometry. The effect of different parameters influencing the... 

We report the rheological properties of ferro-fluid (FF) containing iron oxide nano-particles. At first, a FF was synthesized by using chemical co-precipitaton[1]. The microstructure study using SEM revealed that the FF contained nano-particles with the mean particle size of 35nm. The XRD study revealed that we have well crystallized structures of magnetite; they appeared to be approximately single crystalline structures. The rheological results proved that the FF has non Newtonian behavior, it is a shear thinning fluid in all magnetic fields, Moreover, the magnetic field increases the viscosity in a definite shear rate due to the nano-particles agglomerations and formation of chain-like... 

The present article deals with super-swelling behavior of crosslinked homopolymer of 2-acrylamido-2-methylpropane sulfonic acid, poly(AMPS), in binary mixtures of dimethyl sulfoxide (DMSO) and various polar solvents including water, mono-, and polyhydric alcohols, and amide solvents such as N-methyl pyrrolidone. Extraordinary phase transition sequences including a new unusual swelling phenomenon, referred to as "overentrant" swelling, was observed for this polymeric organogel in the solvent/DMSO mixtures. The swelling behaviors were preliminarily explained based on the major interactions involved in the solvation process and dielectric constant of the swelling media. It was established that... 

In this article, a multiscale modeling procedure is implemented to study the effect of interphase on the Young's modulus of CNT/polymer composites. For this purpose, a three-phase RVE is introduced which consists of three components, i.e., a carbon nanotube, an interphase layer, and an outer polymer matrix. The nanotube is modeled at the atomistic scale using molecular structural mechanics. Moreover, three-dimensional elements are employed to model the interphase layer and polymer matrix. The nanotube and polymer matrix are assumed to be bonded by van der Waals interactions based on the Lennard-Jones potential at the interface. Using this Molecular Structural Mechanics/Finite Element... 

In this study, a fast and sensitive flow injection μ-solid phase extraction (FI-μ-SPE) technique based on an electrospun polyaniline (PANI) nanocomposite in conjunction with gas chromatography-mass spectrometry (GC-MS) was developed. The PANI-based nanocomposite was synthesized by electrospinning of a solution containing polyvinyl alcohol (PVA)/PANI. The majority of PVA template was subsequently removed from the whole PVA/PANI nanofibers blend by exposing the electrospun nanocomposite to hot water. The homogeneity, porosity and characterization of the electrospun nanofibers were investigated by the scanning electron microscopy (SEM) and Fourier transform infrared (FT-IR) spectroscopy. Due to... 

In the present work, a new micro-solid phase extraction (μ-SPE) sorbent as an extracting medium based on core-shell nanofibers was synthesized by electrospinning. The core-shell nanofibers of polyvinylpyrrolidone-Polybutylene terephthalate/polypyrrole (PVP-PBT/PPy) were electrospun and subsequently, modified hollow nanofibers were prepared by removing the central PVP moiety. Moreover, conventional PBT/PPy was also prepared for the comparison purposes. The homogeneity and the porous surface structure of the core-shell nanofibers were confirmed by scanning electron microscopy (SEM). The applicability of the fabricated nanofibers-coating was examined by immersed μ-SPE of some selected triazine... 

A high-throughput micro-solid-phase extraction device based on a 96-well plate was constructed and applied to the determination of pesticide residues in various apple samples. Butyl methacrylate and ethylene glycol dimethacrylate were copolymerized as a monolithic polymer and placed in the cylindrically shaped stainless-steel meshes of 96-micro-solid-phase extraction device and used as an extracting unit. Before the micro-solid-phase extraction, microwave-assisted extraction was employed to facilitate the transfer of the pesticide residues from the apple matrix to liquid media. Then, 1 mL of the aquatic samples was transferred into the 96-well plate and the 96-micro-solid-phase extraction...