Sharif Digital Repository

This article proposes a tunable composite right-/left-handed transmission line consisting of a transversely magnetized ferrite substrate periodically loaded by microstrip inductors. The gapless transition between the left- and right-handed bands (balanced response) is the main characteristic of this structure. This composite right-/left-handed transmission line is proposed in both reciprocal and nonreciprocal versions. Based on periodic structure analysis, the dispersion relation is estimated theoretically and validated numerically by the finite-element method in the reciprocal case. Theoretical and numerical results demonstrate the tunability of the proposed structures by changing the DC... 

When a transparent plane-parallel plate is illuminated at a boundary region by a parallel monochromatic beam of light, Fresnel diffraction occurs because of the abrupt change in phase imposed by the finite change in refractive index at the plate boundary. The intensity of the diffraction fringes varies periodically with changes in the optical path difference of the light passing through the plate edge. The optical path difference depends on the incident angle of the light, the refractive index of the plate and surrounding medium, and the wavelength of the light. Plotting the intensity of the diffraction fringes versus optical path difference provides a general phase shift method for phase... 

A 6-bit passive phase shifter for S frequency band has been designed in a standard HEMT technology. A new switched-network topology has been proposed for implementing the 5.625 phase shift step which these digital bits are series with each other. We used Advanced Design System (ADS2010) to perform simulations. These digital bits will produce 64 different mode phase shift of -177.15 to +177.15 degree. In all cases simulation obtained less than 1 % error  

An innovative vector-sum phase shifter with a full 360° variable phase-shift range in 0.18-μm CMOS technology is proposed and experimentally demonstrated in this paper. It employs an I/Q network with high I/Q accuracy over a wide bandwidth to generate two quadrature basis vector differential signals. The fabricated chip operates in the 2.3-4.8 GHz range. The root-mean-square gain error and phase error are less than 1.1 dB and 1.4° over the measured frequency span, respectively. The total current consumption is 10.6 mA (phase shifter core: ∼2.6 mA) from a 1.8 V supply voltage and overall chip size is 0.87 × 0.75 mm 2. To the best of the authors' knowledge, this circuit is the first... 

In this paper, we investigate the dynamic analysis of a strongly nonlinear microrobot using a three-term harmonic balance method. The employed locomotion concept, namely "friction drive principle," is based on the superposition of a horizontal vibration at the interface between the robot and work floor and an active variation of friction force, obtained by the vertical vibration of the base at the same interface. The equation of motion for the system reveals a parametrically excited oscillator with discontinuity for which the elastic force term is proportional to a signum function. The obtained periodic solution not only is of high accuracy, but also can predict the contribution of the... 

This paper presents the design of a 6-bit active digital phase shifter in 0.18-μm CMOS technology. The active phase shifter synthesizes the required phase using a phase interpolation process by adding quadrature phased input signals. It uses a new quadrature all-pass filter for quadrature signaling with a wide bandwidth and low phase error. The phase shifter has simulated RMS phase error of <0.85° at 2.4-5 GHz. The average voltage gain ranges from 1.7 dB at 2.4GHz to -0.14 dB at 5 GHz. Input P1 dB is typically 1.3±0.9 dBm at 3.5 GHz for overall phase states  

We extend the result by Tse and Verdú on the optimum asymptotic multiuser efficiency of randomly spread code division multiple access (CDMA) with binary phase shift keying input. Random Gaussian and random binary antipodal spreading are considered. We obtain the optimum asymptotic multiuser efficiency of a K-user system with spreading gain N when K and N → ∞ and the loading factor, (K/N) , grows logarithmically with K under some conditions. It is shown that the optimum detector in a Gaussian randomly spread CDMA system has a performance close to the single user system at high signal-to-noise ratio when K and N → ∞ and the loading factor, (K/N), is kept less than (log3 K/2). Random binary... 

In this paper, a novel reduced switch cascaded transformer multilevel inverter is proposed. In this structure, a new structure is replaced with conventional H-bridge inverter. It consists of four high frequency switches, two line frequency switches, and two transformers which can be assembled in one core with a specific winding connection. This topology can produce 5 or 7 voltage levels depending on transformers turns ratio. The simplicity and modularity are its advantages compared to the existing structures. Beside these advantages, due to its similarity with H-Bridge converter, it is possible to use a modified technique based on conventional phase shift pulse width modulation to generate... 

Rotating field gradients (RFGs), generated by simultaneously applying sine- and cosine-modulated gradient waveforms along two perpendicular directions, provide an alternative diffusion sensitization mechanism for magnetic resonance imaging and spectroscopy. Two RFGs with a 90-degree phase shift between them are applied around the 180-degree RF pulse in a spin echo sequence to measure the diffusion orientation distribution function (dODF) directly. The technique obviates transforming the data from a space reciprocal to the displacement space. Here, we compare RFG results with those obtained by two pulsed field gradient (PFG) techniques: q-ball imaging (QBI) and its extension to constant solid... 

A 6-bit passive phase shifter for 2.5- to 3.2-GHz frequency band has been designed and implemented in a standard 0.18- μm CMOS technology. A new switched-network topology has been proposed for implementing the 5.625 ° phase shift step. The insertion loss of the circuit is compensated with an on-chip bidirectional amplifier. The measured return losses of the circuit are better than 8 dB with output 1-dB compression point of +9.5 dBm in the transmit mode and noise figure of 7.1 dB in the receive mode. The fabricated phase shifter demonstrates an average rms phase error of less than 2° over the entire operation bandwidth, which makes it suitable for high-precision applications  

In this paper, a modified method based on the frequency discriminator technique for measuring phase noise of microwave oscillators is presented. In the proposed method, the phase shifter is omitted. In contrast, a 90° hybrid with one more channel containing a phase detector, and a low-noise amplifier is added to the measurement setup. It can be said that an in-phase/quadrature phase-noise detection has been developed. With the proposed method, tuning of the variable phase shifter is not needed anymore. Therefore, the measurement is done automatically, and as a result, the measurement time is decreased. Another considerable advantage of this method is that the method is theoretically... 

An X-band core chip is designed and fabricated in 0.18-μm CMOS technology, which can significantly reduce the monolithic microwave integrated circuit count required for realizing an active beam-former T/R module. The core chip consists of two RX/TX paths, each of which includes a 6-b phase shifter, a 6-b attenuator, along with two input and output amplifiers. A new architecture for realizing such a core chip system and a low loss circuit for 5.625° phase shift block are proposed. The overall rms phase and gain errors are better than 2° and 0.25 dB, respectively, in both RX/TX paths. The gain of each path is around 12 dB, while the output 1-dB compression point is higher than 10 dBm over the... 

Plug-in hybrid electric vehicles draw electricity from the electrical grid and store energy in their batteries. To increase charge availability for plug-in hybrid electric vehicles, on-board chargers can be used, which should be small in size and lightweight. In this article, an on-board bidirectional soft-switched battery charger is proposed that utilizes a phase-shift-controlled dual-bridge series resonant converter with isolation. The bidirectional characteristic of proposed charger makes it suitable for vehicle-to-grid operation (i.e., injecting power from the vehicle to the grid) in smart grids. A switching control scheme is also proposed to provide soft-switching operation for all... 

Overlapped subarrays have cost benefits compared with non-overlapped subarrays. The main cost of phased array radars are for phase shifter or true time delay modules in the case of wide band radars. In overlapped approach, each phase shifter (or time delay module) might have more than one output and it would reduce costs. Although, overlapped subarrays could fit in reduced space too. A main problem in overlapped subarrays is their limited field of view properties. On the other side, in irregular subarrays, the LFOV (Limited Field Of View) problem solved. So in this article the advantages of mentioned two fields cumulated. In the first part, a review of subarray structure presented. Then... 

Overlapped subarrays have cost benefits compare to non-overlapped subarrays. The main cost of phased array radars are for phase shifter or true time delay modules in the case of wide band radars. In overlapped approach, each phase shifter (or time delay module) might have more than one output and it would reduce costs. Although, overlapped subarrays could fit in reduced space too. A main problem in overlapped subarrays is their limited field of view properties. On the other side, in irregular subarrays, the LFOV (Limited Field Of View) problem solved. So in this article the advantages of mentioned two fields cumulated. In the first part, a review of subarray structure presented. Then matrix... 

The design procedure and measured results of a novel 4 × 4 Butler matrix are presented in this paper. This asymmetrical structure provides fairly flexible phase outputs; therefore, the array radiation pattern can be rotated around the array normal axis. The structure of this modified Butler matrix is discussed in detail, and the explicit design formulas are derived to achieve the arbitrary main beams direction. Using the proposed design procedure, the Butler matrix can provide even broadside and endfire beams. In addition, this structure is employed to design two Butler matrices, which generate similar patterns as a conventional 8 × 8 Butler matrix, using only single layer circuits with... 

In this paper, a low power active phase shifter in 0.18 μm CMOS technology, operating from 5 to 6 GHz, for WLAN applications is presented. Design equations for this novel structure, which consists of two current steering stages, transconductance stage and DACs, are derived, thoroughly. This phase shifter has a range of 360° with 5.625° phase resolution. The power consumption is 35 mW. The RMS phase error is only 0.3°. The simulated power gain, input P1dB, and NF are 4 dB, -0.8 dBm and 6 dB, respectively  

This paper presents a tunable reflection/transmission coefficient (TRTC) circuit based on a 45° hybrid coupler that is potentially useful for leakage cancelation purposes. The analysis of the proposed TRTC circuit shows that the circuit can cover any reflection/transmission coefficient of less than 0.5 on the Smith chart by adjusting only two variable resistors. Meanwhile, the real and imaginary parts of the reflection/transmission coefficient can be tuned independently, facilitating the use of this circuit in feedback systems. To implement the 45° hybrid coupler used in the proposed TRTC circuit, a new wideband planar topology for arbitrary phase and amplitude hybrid coupler is introduced.... 

This paper presents a new implementation of adaptive beamforming algorithm that can be fully implemented on chip. It does not require the knowledge of the incoming signal direction or phase shifter characteristics. Besides, it eliminates the need for the ADC to convert the analog output signal to digital values for the microprocessor and the DAC to apply the calculated values to the control voltages of the analog phase shifters. Thus, it exhibits better convergence speed. In addition, the need for the complex and power-hungry processor is eliminated. Therefore, this implementation consumes less power. Analytical equations and constraints on system design parameters are derived, and the... 

This paper presents a new implementation of adaptive beamforming algorithm that can be fully implemented on chip. It does not require the knowledge of the incoming signal direction or phase shifter characteristics. Besides, it eliminates the need for the ADC to convert the analog output signal to digital values for the microprocessor and the DAC to apply the calculated values to the control voltages of the analog phase shifters. Thus, it exhibits better convergence speed. In addition, the need for the complex and power-hungry processor is eliminated. Therefore, this implementation consumes less power. Analytical equations and constraints on system design parameters are derived, and the...