Loading...
Search for: process-technology
0.007 seconds

    Substrate oscillations boost recombinant protein release from Escherichia coli

    , Article Bioprocess and Biosystems Engineering ; Volume 37, Issue 5 , May , 2014 , Pages 881-890 ; ISSN: 16157591 Jazini, M ; Herwig, C ; Sharif University of Technology
    Abstract
    Intracellular production of recombinant proteins in prokaryotes necessitates subsequent disruption of cells for protein recovery. Since the cell disruption and subsequent purification steps largely contribute to the total production cost, scalable tools for protein release into the extracellular space is of utmost importance. Although there are several ways for enhancing protein release, changing culture conditions is rather a simple and scalable approach compared to, for example, molecular cell design. This contribution aimed at quantitatively studying process technological means to boost protein release of a periplasmatic recombinant protein (alkaline phosphatase) from E. coli.... 

    Two-compartment processing as a tool to boost recombinant protein production

    , Article Engineering in Life Sciences ; Vol. 14, issue. 2 , March , 2014 , p. 118-128 Jazini, M ; Herwig, C ; Sharif University of Technology
    Abstract
    Pichia pastoris is used extensively as a production platform for many recombinant proteins. The dissolved oxygen (DO) is one of the most important factors influencing protein production. The influence of the DO on productivity has not been studied independent from the feed rate. In this work, various DO levels were investigated independent from the feed rate. The model system was recombinant P. pastoris under the control of methanol-induced alcohol oxidase promoter, which expressed HRP as the target protein. No significant effect was observed in terms of titer and specific productivity, which is a confirmation of the fact that the DO in a one-compartment system cannot boost productivity for... 

    Influence of ridge filter material on the beam efficiency and secondary neutron production in a proton therapy system

    , Article Zeitschrift fur Medizinische Physik ; Volume 22, Issue 3 , September , 2012 , Pages 231-240 ; 09393889 (ISSN) Riazi, Z ; Afarideh, H ; Sadighi-Bonabi, R ; Sharif University of Technology
    Elsevier  2012
    Abstract
    In this work, the 3D proton dose profile is calculated in a homogenous water phantom using a Monte Carlo application developed with the Geant4 toolkit. The effect of the ridge filter material (for SOBP widths of 6, 9 and 12 cm) on the homogeneity of the dose distribution, secondary neutron production and beam efficiency are investigated in a single ring wobbling irradiation system. The energy spectrum of secondary neutrons per primary proton at various locations around the phantom surface is calculated. The simulation revealed that most of the produced neutrons are released at slight angles which enable them to reach the patient and consequently to be hazardous. Also, the homogeneity of the... 

    Enhancement of L-asparaginase production by candida utilis in a 13L fermenter and its purification

    , Article International Journal of Engineering, Transactions B: Applications ; Volume 28, Issue 8 , 2015 , Pages 1133-1141 ; 1728-144X (ISSN) Momeni, V ; Alemzadeh, I ; Vosoughi, M ; Sharif University of Technology
    Materials and Energy Research Center  2015
    Abstract
    L- asparaginase enzyme is a renown enzyme because of its chemotherapeutic properties. This enzyme may also be employed in food processing technology. The present study aimed, optimizing the agitation and aeration rate in L-asparaginase production, using C. utilis, ATCC 9950 in batch fermentation system. Beet molasses used as the carbohydrate source for enzyme production. A maximum asparaginase activity of 245.6 U/ml obtained after 20h of fermentation under optimal condition of 1.25 vvm aeration rate and 300 rpm agitation speed. Purification of the enzyme was also done by Acetone Precipitation and column chromatograph. Purified L-asparaginase revealed molecular weight 75 kDa and 82.7 % yield... 

    CNTFET full-adders for energy-efficient arithmetic applications

    , Article 6th International Conference on Computing, Communications and Networking Technologies, 13 July 2015 through 15 July 2015 ; 2015 ; 9781479979844 (ISBN) Grailoo, M ; Hashemi, M ; Haghshenas, K ; Rezaee, S ; Rapolu, S ; Nikoubin, T ; University of North Texas ; Sharif University of Technology
    Institute of Electrical and Electronics Engineers Inc 
    Abstract
    In this paper, we present two energy-efficient full adders (FAs) which are a crucial building block of nano arithmetic logic units (nano-ALUs) with the Cell Design Methodology (CDM). Since the most suitable design configuration for CNT-based ICs is pass transistor configuration (PTL), CDM which properly benefits from PTL advantages is utilized. So the designs herewith take full advantages of simplicity, fewer transistors and better immunity against threshold voltage fluctuations of the PTL than the CCMOS configuration. CDM also resolves two problems of PTL by employing elegant mechanisms which are threshold voltage drop and loss of gain. Using the amend mechanisms and SEA sizing algorithm... 

    Multi-criteria Model Development to Evaluation of Waste Energy and Material Recovery in Tehran

    , M.Sc. Thesis Sharif University of Technology Salehi, Niloufar (Author) ; Saboohi, Yadollah (Supervisor)
    Abstract
    Waste management is one of the essential and basic utility services in 21st century, especially in rural areas. It includes different environmental, technical, economic, legal and social aspects which need to be considered in levels of waste generation, transport, treatment and disposal. Therefore, considering economic criterion in waste management programs, as the only one criterion, will result in environmental impacts in long-term and impose high costs to the society and the economy overall. The main purpose of this study is to develop a multi-criteria mathematical model, which take into account both economic and environmental criteria in order to present an integrated municipal solid... 

    NTIRE 2021 challenge on perceptual image quality assessment

    , Article 2021 IEEE/CVF Conference on Computer Vision and Pattern Recognition Workshops, CVPRW 2021, 19 June 2021 through 25 June 2021 ; 2021 , Pages 677-690 ; 21607508 (ISSN); 9781665448994 (ISBN) Gu, J ; Cai, H ; Dong, C ; Ren, J.S ; Qiao, Y ; Gu, S ; Timofte, R ; Cheon, M ; Yoon, S ; Kang, B. K ; Lee, J ; Zhang, Q ; Guo, H ; Bin, Y ; Hou, Y ; Luo, H ; Guo, J ; Wang, Z ; Wang, H ; Yang, W ; Bai, Q ; Shi, S ; Xia, W ; Cao, M ; Wang, J ; Chen, Y ; Yang, Y ; Li, Y ; Zhang, T ; Feng, L ; Liao, Y ; Li, J ; Thong, W ; Pereira, J. C ; Leonardis, A ; McDonagh, S ; Xu, K ; Yang, L ; Cai, H ; Sun, P ; Ayyoubzadeh, M ; Royat, A ; Fezza, A ; Hammou, D ; Hamidouche, W ; Ahn, S ; Yoon, G ; Tsubota, K ; Akutsu, H ; Aizawa, K ; Sharif University of Technology
    IEEE Computer Society  2021
    Abstract
    This paper reports on the NTIRE 2021 challenge on perceptual image quality assessment (IQA), held in conjunction with the New Trends in Image Restoration and Enhancement workshop (NTIRE) workshop at CVPR 2021. As a new type of image processing technology, perceptual image processing algorithms based on Generative Adversarial Networks (GAN) have produced images with more realistic textures. These output images have completely different characteristics from traditional distortions, thus pose a new challenge for IQA methods to evaluate their visual quality. In comparison with previous IQA challenges, the training and testing datasets in this challenge include the outputs of perceptual image...