Sharif Digital Repository

An efficient method is reported for selective oxidation of various types of sulfides to sulfoxides and sulfones in good to high yields using 30% H 2O2 in the presence of catalytic amounts of molybdate-based catalyst in acetonitrile as solvent at room temperature. The catalyst can be easily recovered and reused for seven reaction cycles without considerable loss of activity  

Graphene oxide (GO) sheets were synthesized through a modified Hummers' method. Using high resolution transmission electron microscopy the thickness of the GO sheets in a multilayer structure of stacked GO sheets was found ∼0.8 nm. A nanosecond pulsed laser (with wavelength of 532 nm and average power of 0.3 W) was applied for effective and environment friendly reduction of the GO sheets in an ammonia solution (pH ∼9) at room temperature conditions. The deoxygenation of the GO sheets by the pulsed laser reduction method was confirmed by using UV-visible, Fourier transform infrared, X-ray photoelectron spectroscopy (XPS) and thermo gravimetric analysis. Based on XPS analysis, the O/C ratio of... 

Ag and Ni are immiscible, mainly due to their large lattice mismatch. This paper reports on their nanoscale formation of solid solution at room temperature by simple reduction reactions which lead to the amorphous Ag-Ni alloy nanoparticles (ANPs) with mono-disperse distribution. Microscopic and spectroscopic studies confirmed dependence of the alloy composition on size of nanoparticles. In the presence of different ligands such as sodium citrate, polyvinyl alcohol and potassium carbonate a mixture of silver oxide and Ag-Ni ANPs was achieved. Stoichiometry of the Ag-Ni ANPs was also found to be strongly dependent on ligands of the reduction reaction and further study shows without any ligand... 

A series of novel pseudopeptides contained coumarin skeleton were synthesized through the Ugi-four-component reaction. The 3-substituted coumarin-3-carboxamides were formed through reaction of benzaldehyde derivatives, anilines, coumarin-3- carboxylic acid and isocyanides with high yields and high bond-forming efficiency at room temperature. These novel amidated coumarins exhibit brilliant fluorescence in range of 535-547 nm in chloroform  

The comprehensive optical-electrical-gain-thermal self-consistent model of the 1.55 μm AlGaInAs Photonic Crystal vertical cavity surface emitting diode lasers (PhC VCSELs) with buried tunnel junction (BTJ) has been applied to optimize its threshold characteristics. It shows that, for 5 μm devices, the room temperature (RT) threshold current equal to only 0.59 mA and maximum operating temperature equal to as much as 380 K. Results suggest that, the 5 μm AlGaInAs PhC VCSELs seem to be the most optimal ones for light sources in high performance optical communication systems  

Two room temperature liquid salts containing molybdenum(VI), [BMIM] 2[MoO2(NCS)4] (1) and [DMIM] 2[MoO2(NCS)4] (2), were immobilized on ionic liquid-modified silica leading to materials which showed notable catalytic activity for the reduction of sulfoxides into sulfides with triphenylphosphine (PPh3). The molybdenum liquid salts immobilized on the supported ionic liquid phase could be reused at least for three catalytic cycles without significant loss of activity  

An environmentally benign, aqueous synthesis of 1,2-azidoalcohols via regioselective ring opening of their epoxides using magnetic imidazolium based dicationic room temperature ionic liquid, [pbmim](FeCl4)2, as an efficient magnetic phase transfer catalyst in water has been described. The present approach offers the advantages of clean reaction, simple methodology, short reaction time, high yield, easy purification and reusable catalyst  

Tungsten oxide thin films (deposited by thermal evaporation or sol gel method) were used for photocatalytic reduction of graphene oxide (GO) platelets (synthesized through a chemical exfoliation method) on surface of the films under UV or visible light of the environment, in the absence of any aqueous ambient at room temperature. Atomic force microscopy (AFM) technique was employed to characterize surface morphology of the GO sheets and the tungsten oxide films. Moreover, using X-ray photoelectron spectroscopy (XPS), chemical state of the tungsten oxide films and the photocatalytic reduction of the GO platelets were quantitatively investigated. The better performance of the sol-gel tungsten... 

This work presents a procedure for functionalization of graphene sheets from edges by polyglycerol. Hyperbranched polyglycerol with a bi-dentate aromatic segment in its focal point was synthesized and used to sandwich graphene sheets from the cut-edges. Due to the hydrophobicity of the flat surface of the edge-functionalized graphenes and hydrophilicity of their edges, they changed their conformation from the extended- to the closed-state and formed nanocapsules in aqueous solutions. Spectroscopy and microscopy evaluations showed that the average size for nanocapsules is 300 nm. They were able to encapsulate hydrophobic molecules such as doxorubicin in aqueous solutions with a high loading... 

In this work, a novel heterogeneous organocatalyst was synthesized by immobilization of hydroxide ions on the modified salep as a natural polymer. Because of the grafting of ionic polymer chains onto the salep backbone, catalyst has high loading level of hydroxide ions (3.01 mmol/g). The resulting catalyst shows excellent activity in the synthesis of 4H-benzo[b]pyrans in water at room temperature in short reaction times. The present catalyst and protocol represent a simple, ecologically safe and cost-effective route to synthesize 4H-benzo[b]pyrans with high product yield, as well as easy catalyst recycling  

A uniformly distributed ZnO nanowire array has been grown on silicon (100) substrates by catalyst-free chemical vapor transport and condensation. The effect of growth conditions including source heating temperature, substrate temperature, and gas flow rate on growth properties of ZnO nanowire arrays are studied. Scanning electron microscopy, X-ray diffraction, and room temperature photoluminescence are employed to study the structural features and optical properties of the samples. The results show a correlation among experimental growth parameters. There is a zone for substrate temperature, by controlling gas flow rate, that uniformly distributed and well aligned ZnO nanowire arrays can be... 

Fiber bending and temperature loss mechanisms in plastic optical fibers are reported.A simple arrangement is used to monitor the fiber bending and temperature by output power variation. Powers in the fibers in bend-free situation at room temperature and under rolling deforming force at different water bath temperatures (20-60°C) are measured and compared. Reported arrangements can be used as a temperature sensor  

In the present paper, the heat treatment effect on A356.0, a cast aluminum alloy which has been widely used in diesel engine cylinder heads, is investigated under out-of-phase thermo-mechanical fatigue and low cycle fatigue (at different temperatures) loadings. A typical heat treatment is applied to the material including 8. h solution at 535 °C, water quench and 3. h ageing at 180 °C. The experimental fatigue results show that the heat treatment process has considerable influence on mechanical and low cycle fatigue behaviors, especially at room temperature, but its effect on thermo-mechanical fatigue lifetime is not significant. The improvement in the strength can be explained by the... 

Ferrite-bainite-martensite triple phase (TP) microstructures with different volume fractions of martensite were obtained by changing heat treatment time during austempering at 300 C. Room temperature impact properties of TP steels with different martensite volume fractions (VM) were determined by means of Charpy impact testing. The effects of test temperature on impact properties were also investigated for two selected microstructures containing 0 (the DP steel) and 8.5 vol.% martensite. Test results showed reduction in toughness with increasing VM in TP steels. Fracture toughness values for the DP and TP steels with 8.5 vol.% martensite were obtained from correlation between fracture... 

Hydrolysis of titanium isopropoxide alcoholic solution has been used to prepare the crystallized TiO2 nanoparticles at low temperature. Concentration ratio was used to control the pathway of sol-gel process and change the physical characteristics of TiO2 nanopowders. The crystallinity, morphology and size of aged TiO2 nanopowders were studied by X-ray diffraction and Scanning Electron Microscopy (SEM). FTIR and, Thermo-Gravimetric (TG) analysis were used to identify the functional groups and thermal behavior of prepared samples. Experimental results have shown that high crystalline TiO2 nanomaterial with anatase polymorph can be obtained at room temperature. It has been found that the... 

By combination of 1-ethyl-3-methyl immidazolium ethyl sulfate as a typical room temperature ionic liquid (IL) and graphene oxide (GO) nanosheets, a nanocomposite was introduced for improving the direct electrochemistry and electrocatalytic activity of glucose oxidase (GOx). The enzyme on the IL-GO-modified glassy carbon electrode exhibited a quasireversible cyclic voltammogram corresponding to the flavine adenine dinucleotide/FADH2 redox prosthetic group of GOx. At the scan rate of 100 mV s-1, the enzyme showed a peak-to-peak potential separation of 82 mV and the formal potential of -463 mV (vs Ag/AgCl in 0.1 M phosphate buffer solution, pH 7.0). The kinetic parameters of the charge transfer... 

In this study, a hybrid of silica nanosphere/multiwall carbon nanotube (MWCNT) has been synthesized by wet chemical method at room temperature. The effect of MWCNTs, silica nanospheres and hybrid nanostructures (80% silica nanosphere/20% MWCNT and 50% silica nanosphere/50% MWCNT) on the thermal conductivity of distilled water has been investigated. SDBS was used as the dispersant to stabilize nanomaterials in the aqueous suspension and its concentration was 1.5 times of the concentration of nanomaterials. As results show, by increasing the concentration of nanomaterials, effective thermal conductivity of nanofluids increased. The most and the least enhancement in the effective thermal... 

In this study, the synthesis and characterization of a novel nano-porous superabsorbent hydrogel with high water swelling capacity is described. A nano-porous hydrogel was prepared by employing (2-dimethylaminoethyl) methacrylate (PDMAEMA) as a pH sensitive monomer and sodium alginate (SA) as a water soluble polysaccharide under γ-ray irradiation. The polymerization reaction was performed at room temperature in the absence of chemically toxic crosslinking agent and initiators. The interactive parameters including biopolymer backbone concentration, monomer concentration and γ-irradiation dose were selected as major factors in the synthesis of superabsorbent and three levels for each factor... 

Two types of gold ores were subjected to iodide/iodine leaching at room temperature. The effects of three factors, including ore type (a carbonaceous and an oxide gold ores), iodide/iodine concentration, and the presence of oxygen in solution on gold leaching performance were investigated. The carbonaceous ore showed only 20% gold extraction into the solution; since gold-iodide complexes would readily adsorb on organic matter. In contrast, gold extraction from the oxide ore in a solution containing 20 g/L iodide and 4 g/L iodine reached 77% in 6 h and 89% in 24 h. With iodate as the oxidant, no gold could be leached in 48 hours. When the iodate was partially converted to iodine by adding HCl... 

In this study, the kinetics of aging in AA6061 and AA6061 with 5% volume fraction SiCp were studied and compared. The composite was first produced and homogenized using stir casting technique followed by hot extrusion with the ratio of 18:1. Then, both AA6061 and the composite were aged at three different temperatures including room temperature, 170 °C and 240 °C, while mechanical properties during aging were evaluated employing hardness measurements and tensile testing. Moreover, in order to assess the effect of plastic deformation on the kinetics of aging, a series of samples were first deformed by equal-channel angular pressing immediately after solution treatment and then aged in the...