Loading...

Microstructure and mechanical properties of dual phase steels, with different martensite morphology, produced during TLP bonding of a low C-Mn steel

Fazaeli, A ; Sharif University of Technology

370 Viewed
  1. Type of Document: Article
  2. DOI: 10.1007/s12540-016-6154-y
  3. Publisher: Korean Institute of Metals and Materials
  4. Abstract:
  5. In this research, production of ferrite - martensite dual phase Steels with different martensite morphology was considered during transient liquid phase bonding of a low carbon steel. The steel was bonded using an iron base interlayer with melting point of 1443 K and 40 μm thickness. Bonding process carried out at 1473 K, under pressure of 0.5 MPa, at different holding time of 10, 20, 30 and 40 minutes. Microstructural studies of joint region showed that isothermal solidification completed at the bonding time of 40 minutes. Microstructure of joints made at the bonding time of 10, 20, and 30 minutes consists of two distinct region, athermal and isothermal solidified zones. Microstructure of these zones was studied and chemical composition of these zones was determined by EDS. Joints made with bonding time of 40 minutes were homogenized at 1008 K and then cooled into cold water to produce dual phase ferrite and martensite microstructure with different martensite morphology. According to shear test results, it was found that the shear strength of ferrite - fibrous martensite microstructure is greater than those with ferrite - continuous martensite and ferrite - blocky martensite microstructure
  6. Keywords:
  7. Homogenization ; Mechanical properties ; Microstructure ; Solidification ; Transient liquid phase bonding
  8. Source: Metals and Materials International ; Volume 22, Issue 5 , 2016 , Pages 856-862 ; 15989623 (ISSN)
  9. URL: https://link.springer.com/article/10.1007/s12540-016-6154-y