Loading...

Microstructural and mechanical evaluations of SAW by manufactured granular basic bonded Cr, Mo, and Cr–Mo active fluxes on ST37 low carbon steel

Alishavandi, M ; Sharif University of Technology | 2022

127 Viewed
  1. Type of Document: Article
  2. DOI: 10.1007/s00170-021-08238-1
  3. Publisher: Springer Science and Business Media Deutschland GmbH , 2022
  4. Abstract:
  5. Abstract: Bead-on-plate submerged arc welding was conducted on St37 steel by manufactured Cr, Mo, and Cr–Mo active basic fluxes produced via the unfused bonded method. The base metal heat-affected zone and weld metal (WM) microstructures were identified and characterized by optical microscopy and scanning electron microscopy. Furthermore, each element’s recovery rate (η) and slag factor (α) determine the amount of element transferred from flux into WM. Then, the ferrite morphologies volume fraction of WMs was measured. Moreover, the chemical analysis of slag and inclusions was evaluated by point scan energy-dispersive X-ray spectroscopy and extensively discussed. The number density and size of the inclusions as well as their effects on the acicular ferrite (AF) formation were also elaborated. Then, the WMs’ longitudinal tensile strength and Vickers hardness (HV) were measured. Finally, the Charpy V-notch test was conducted to determine the impact toughness; the fracture surfaces were investigated, as well. Graphical abstract: [Figure not available: see fulltext.] © 2021, The Author(s), under exclusive licence to Springer-Verlag London Ltd., part of Springer Nature
  6. Keywords:
  7. Acicular ferrite ; Impact test ; Inclusion ; Submerged arc welding ; Unfused flux ; Chemical analysis ; Energy dispersive spectroscopy ; Ferrite ; Fractography ; Fracture mechanics ; Fracture toughness ; Heat affected zone ; Low carbon steel ; Slags ; Tensile strength ; Vickers hardness ; Active bonded flux ; Active flux ; Bead on plate ; Low-carbon steels ; Mechanical evaluation ; Microstructural evaluation ; Submerged-arc welding ; Scanning electron microscopy ; Slag
  8. Source: International Journal of Advanced Manufacturing Technology ; Volume 119, Issue 9-10 , 2022 , Pages 6335-6347 ; 02683768 (ISSN)
  9. URL: https://link.springer.com/article/10.1007/s00170-021-08238-1